Bearing Angle Traverse Given the tabulated measurement of the closed traverse as shown. Determine the missing data. Line Length Bearing AB 413.600 m N 09°30’ W BC 304.380 m N 55°06’ W CD 407.210 m S 57°35’ W DE Unknown S 04°05’ E EA 649.630 m Unknown   Note: EXPRESS YOUR ANSWER UPTO 3 DECIMAL PLACES.   please be accurate when proving solutions. thank you so much.

Q: The following were the monthly evaporation data in cm in certain year (January- December) in the…

A:

Q: A 150mm x 400mm x 3m timber beam (simple span) is to be loaded with uniform load and a concentrated…

A: please look into the solution

Q: The steel column has an outer diameter of 4 in. and inner diameter of 3.5 in. is carrying a load P =…

A: ASKED- To determine: a. compressive stress in the column b. bearing stress of the concrete c.…

Q: Form the given beam loaded has shown, Ely = MẠ¤ + RA2² – ¿P(x – )² + C1 - Ely = MA2² + ¿RA2³ – P(x –…

A:

Q: A high-strength steel bar used in a large crane has a diameter d = 4.00 in. (see figure). The steel…

A:

Q: bulk density and dry density of a soil are 1.95 gm/cc and 1.58 gm/cc respectively. Assuming Gs =…

A:

Q: Draw the influence line for the reaction at A. Find the positive maximum equivalent unit load for…

A:

Q: Given the following Northing and Easting, use the COORDINATE METHOD to solve for the area of this…

A:

Q: B- EVEN: Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way…

A:

Q: A catchment area has 5 non-recording rain gauge stations. The amount of rainfall recorded for one…

A: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost other…

Q: Bearing Angle Traverse Given the tabulated measurement of the closed traverse as shown. Determine…

A: Introduction- Leveling is a discipline of engineering that determines the location of an item on the…

Q: Note: Show all of the diagrams used while solving the problem. Show each and every reaction and…

A:

Q: PROBLEM 1. A simple curve connects two tangents AB and BC with bearings N 41°22' E and N 89° 42' E ,…

A:

Q: 1m 1m 4m 1m 4m Determine the discharge thru a storm sewer shown if slope is 0.0009 and roughness…

A: Given data,  Slope (S) = 0.0009 Roughness coefficient (n) = 0.035 To find out the discharge through…

Q: What is the leading cause of fire the leading cause of fire?

A: Leading cause of fire means that fire occurs more often than other causes or in other words most…

Q: What is the maximum positive moment for the beam shown? Use the method of consistent deformations.…

A:

Q: Find the required slope of a rectangular open channel when the water flows at a rate of 20,000 L/s,…

A: Given data :-  Type of channel = Rectangular channel  Base width (B) = 4 m  Depth of flow (y) = 2.5…

Q: (c) To evaluate the acoustic behaviour of a concrete wall, the propagation of a sound wave in air…

A:

Q: Given the following Northing and Easting, use the COORDINATE METHOD to solve for the area of this…

A:

Q: A motorist is travelling at 72km/hr when he observes that a traffic light ahead of him turns red.…

A: Given  s= 300m u= 20m/s t= 22s To Calculate -  a) deceleration (a) = ? b) velocity (v) = ?

Q: For the loading shown, use the double-integration method to determine (a) the equation of the…

A:

Q: (3L – 4x), Ely wx f elastic curve are the following: Ely = 24 Pa, I = 1660 x 10^6 mm^4 BkN/m, L =…

A:

Q: Determine the support reactions on the pin and roller as shown in the figure below. Simplify your…

A: Given data in question  UVL Span member length  To find out  Reactions

Q: A circular footing is 2.50 meters in diameter. The bottom of the footing is 2.97 m. below the ground…

A: Given: The diameter of the footing is 2.5 m. The depth is 2.97 m. The depth of the water table is…

Q: 9. Find the length of AB and the bearing of line DE for the lot whose other description is given…

A:

Q: A 150mm x 400mm x 3m timber beam (simple span) is to be loaded with uniform load and a concentrated…

A: L = 3m

Q: The stresses on an element are o, = -270 psi and o, = -540 psi. Find the maximum shear stresses (in…

A: σx = σ1 = -270 psi.σy = σ2 = -540 psi. To determine: τmax x1 = maximum shear stress when element is…

Q: 5 kN 1.5 m 1.5 m B В y 3 m L 3 m 6 m

A:

Q: A block of wood 0.6 m x 0.6 m x “h” meters in dimension was thrown into the water, it floats with…

A:

Q: The time to reach 60% consolidation is 35 seconds for a sample of 15 m thick tested in a laboratory…

A: Using the definition of time factor. And its relation with degree of consolidation.

Q: diagram and the maximum shear a

A:

Q: a. Classify soil A using AASHTO method. b. Classify soil B using AASHTO method c. Classify soil C…

A:

Q: Situation 4 - Three samples of loose sand were tested under consolidated undrained (CU) conditions.…

A: Given data in question  Deviatric stress Undrained angle of internal friction  Pore water pressure…

Q: D A В 3m 6m 4m 2m

A: The length of beam, L=15mThe pinned support is at 3m from left end and roller support is 2m from…

Q: A 150mm x 400mm x 3m timber beam (simple span) is to be loaded with uniform load and a concentrated…

A:

Q: The figure shown is the cross section on the fixed support of a propped beam that carries a moment…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: VE FOR THE SUPPORT REACTIONS AND DRAW THE SHEAR RAM OF THE FOLLOWING. IOT JUST WRITE THE MDM TABLE.…

A:

Q: Situation 11 - The moist unit weight and degree of saturation of a soil are given in the following…

A:

Q: Design a beam of 5 m effective span, carrying a uniform load of 20 kN/m if the compression flange is…

A:

Q: A steel pad supporting heavy machinery rests on four short, hollow, cast iron piers (see figure).…

A:

Q: x 400mm x 3m timber beam (simple span) is to be loaded with u or a cumulative period of about 20…

A:

Q: he angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus…

A: solution Given angle of internal friction ϕ=26.57°shearing stress ζ=250Kpa normal stress σ=480Kpa we…

Q: A propped cantilever steel beam is constructed from a W12 x 35 section. В The beam is loaded by its…

A: (a) calculate reaction at A and B (b) Location of zero moment (c) Maximum deflection and rotation at…

Q: 12. Situation 4 - A block of wood 0.6 m x 0.6 m x “h” meters in dimension was thrown into the water,…

A:

Q: The number of flow channels and head drops is 4 and 12 respectively. If the difference in the…

A:

Q: What is the fixed end moment FEMas for the beam with a settlement of 25 mm at support C? 20 kN/m 60…

A: Figure is as shown

Q: The perpendicular offset distance from point A on a simple curve tto Q on the tangent line is 64 m.…

A:

Q: D. A- ODD: A 2.0 kN bar AB carries a load F = 75 kN vertical force at A. The bar is supported by a…

A: NOTE :- As per our guidelines we are supposed to solve first three SUBPARTS. So please repost next…

Q: Problem 1: 2m 2m 3m Im Im 2m 4m Sm 3m 3m A2 A2 5m 4m 4m 4m 4m 2m A3 7m 9m 8m 4m A3 4m A4 answer FE,…

A: Given data: Top view of lake chain. Cross-sections A2 A3 and A4.

Q: Situation 1 - The pressure on a closed tank reads 58.86 kPa. What is the equivalent height, in…

A:

Area Computations

The area is the mathematical estimation of the inner space occupied by any shape or object and area computation is the evaluation of how much inner space that particular shape or object has utilized. Simple applications include calculating the area of wall for the quantity of paint or plaster to be applied on it, area calculations for construction of a trapezoidal dam and how much material is required, calculating the area of a circle to determine the range or distance of wheels that they are capable of covering due to varied radii and so on.