Benzene (i), toluene (ii), acetonitrile(iii), and methane(iv) are among the chemical wastes discovered in a river Please discuss about : - Permitted exposure level of each chemical waste (Benzene, toluene, acetonitrile, and methane) -Risk of exposure of each waste - Symptoms of exposure of each waste

Q: 1. A single-loop control system is shown in figure below. Determine the closed- loop transfer functi...

A:

Q: An ethanol-water mixture containing 35% mol% ethanol will be refluxed in a distillation tower. The t...

A: Feed F=1000 kgmole/hr xF=0.35 feed is saturated liquid q=1 Reflux ratio R=1 xD=0.7 xB=0.02  

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A:

Q: Q1) A piston cylinder device contains 0.2 kg of air initially at 0.06 m³ and 3 bar. The air is first...

A:  

Q: The vapor pressure of component A is 300.3 torr, and that of component B is 70 torr at 35 °C. A Solu...

A:

Q: Q7. A gas expands adiabatically in a cylinder fitted with a piston. The initial pressure and tempera...

A:

Q: The two tank systems shown in the figure are in steady state. At 0, the flow rate was suddenly incre...

A:

Q: In the nitric acid manufacture, 100 m'/h of ammonia at 290 K and 1 bar is mixed with air and passed ...

A:

Q: QUESTION 11 NUCLEAR CHEMISTRY: Consider the nuclei 1150Sn. Determine its mass defect in kilograms if...

A:

Q: An evaporator is concentrating solutions coming from two different sources. The solution from the fi...

A: given details, first stream, F1 with 44 kg/min with composition 10% NaCl  10% NaOH 80% water second ...

Q: 1- W hat effect of molecular weight on diesel index 2- W hat ben efit of calculated diesel index

A: Diesel index is the cetane number and can be defined as a measure of an indication of the ignition q...

Q: How is the unit for dissolved oxygen is mg/L using this formula? Show the factor-label method. Given...

A: Given:V1= 10 mLV2= 50 mLV3= 4 mLV4= 50 mLN= 0.0250 N  

Q: acid in solid state has a viscosity

A: Yes ,  The viscosity of a fat in solid state  is due to the internal friction between the lipids th...

Q: Q.5 Consider one such alloy that initially has a uniform carbon concentration of 1. 22 wt% and is to...

A: In this system the surface composition is constant. The diffusion in this system is non steady state...

Q: 2. To prevent the presence of air, noble gases are placed over highly reactive chemicals to act as i...

A: given: mass of helium=5.50 g mass of krypton=35 g molecular weight of helium=4.0 g/mol molecular wei...

Q: Compare the mechanical and thermal properties and costs of PET and poly(trimethylene terephthalate) ...

A: Polyethylene terephthalate (PET) is thermoplastic polymer resin of the polyester family and is used ...

Q: cherry contain about 20 wt% solids and 80 wt% water. To make cherry jam, crushed cherries and sugar ...

A: Law of conservation of mass is used to calculate the unknowns in process systems. This is material b...

Q: In fixed-bed leaching, what could be the yield please mention one or two only.

A: The yield obtained in fixed-bed leaching is to be mentioned.

Q: Calculate the pH of a 0.25 M nitrous acid (HNO2) solution. [ Ka = 4.5 x A. 1.97 B. 3.95 C. 0.011 D. ...

A: Chemical Equation:                              HNO2 ⇔ H+   (aq) + NO2- (aq) Initial                ...

Q: You are learning Russia {passiv}

A: The given statement is to be converted into passive voice.

Q: Játer at 93.5°C 1s pumped from a storage tank at a volumetric floW ate of 3.15x10-3 m³/s. The motor ...

A:

Q: A petroleum cut has the following TBP Distillation data: 0 10 30 71 85 125 150 175 200 225 Volume % ...

A:

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with o...

A: Oil density = ρ1 = 1500 kg/m3  Depth of oil = Z1 =  1 meter  Water density = ρ2 = 1000  kg/m3   Dept...

Q: if Ksp < Qsp then precipitate will form the reaction will not occur O the reaction will remain satur...

A: Ksp is the solubility product regular and Qsp is the solubility product quotient. The key distinctio...

Q: A mercury thermometer is initially located in a 75°F room. It is suddenly immersed in a 400°F oil ba...

A:

Q: Calculate the power to move a load of 850 tons/h of a granular material on a conveyor belt, 1 m wide...

A: Given Load =850tons/h Wide=1m Length L=100m Belt speed=150m/min Moving parts weight= 5000 kg Find ...

Q: Using Newton’s iterative method find the molar volume of methane at 600 bar and 300K  (provided the ...

A: Given: P = 600 bar = 600×105 N/m2T = 300 Ka = 0.2285 N.m4b = 4.27×10-5 m3R = 8.314 J/mol.K Newton's ...

Q: Steady state and unsteady state

A: Mole Balance: FAO-FA + rAV=dNAdtFBO-FB + rBV=dNBdtFCO-FC + rCV=dNCdt

Q: How many atoms of sulfur are in 499 g of Na,S,O, ? Atomic weights: Na=22.99, S=32.07, O=15.99. Input...

A: Given Data :   The mass of Na2S2O3 =  499 g  The molar mass of Na2S2O3 = 158 .11 g / mol  To Find: T...

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A:

Q: Calculate density when m=10 kg, V= 15 Cm and discuss the influence of mass and volume on density val...

A: The density of the substance is the amount of mass contained per unit of volume of the substance. It...

Q: A loaded semi-truck consumes about 10 US gallons of diesel per hour (assuming an average speed of 60...

A:

Q: titauium 2. ambient temperatue t Peeuuee of erystal is veloied - faiked' kexayoual, kas Q- The Stwit...

A:

Q: Table 3: Specification for heat exchanger purchased in 2015 Design Specification Material of constru...

A: a) Given that C=K(Cost index)  Cost index in 2001=394. Cost index in 2015=557 C2C1=Cost index for 2C...

Q: An evaporator is concentrating solutions coming from two different sources. The solution from the fi...

A: given details, first stream, F1 with 53 kg/min with composition 10% NaCl  10% NaOH 80% water second ...

Q: a 200-liter tank initially contains 40 liters of 3 grams/liter potassium chloride solution. At t = 0...

A: Given data: Volume of tank = 200 L Initial volume of potassium chloride solution = 40 L Initial conc...

Q: The initial value of the equipment and its salvage values ​​are Rs.10 lakhs and Rs.2 lakhs respectiv...

A:

Q: Q1. Characteristics for the Servo problem is given as: 1 G, (s) s2 + 4s + 1' G.(s) = K. ; Gm(s) = G,...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: P15: 5 dm3 of O2, 10 dm3 of CO2 and 15 dm3 of N2 are mixed reversely at 27 °C and 1 atm to form an i...

A:

Q: Q2:A sandstone core sample (Vb 49 cm3, Vp 8.8 cm3, fluid mass 15.2 g) contains both oil and water (p...

A: Given, The density of oil, ρo = 0.82 g/cm3 The density of water, ρw = 1 g/cm3 Mass of the sandstone,...

Q: Alcohol making process can be divided into five distinct steps: harvesting and crushing grapes. ferm...

A: Reaction is C6H12O4→ 2C2H5OH+2CH3OH 70% of sugar T=40℃ Time=500days Conversion=45% Methanol concent...

Q: A Simple Dankine cyele work heturen pressure. 3400 kpaand beahpa.the initial canelition of Steam bei...

A: Given data  P1= 3400 Kpa =34 bar P2=1000 Kpa=10 bar

Q: Q2/ Calculate the activation energy for vacancy formation in aluminum, given that the equilibrium nu...

A: Given, The density of aluminum, ρ = 2.62 g/cm3 The atomic weight for aluminum, M = 26.98 g/mol Equil...

Q: 1) An Zn-Cu alloy contains 15 wt % Zn, the solute in this system is 2) Hydrogen bonding is a form of...

A: Given that  Zn - cu alloy  15 wt % Zn       According to bartleby rule ,I can solved only 1st questi...

Q: 10 kg of saturated solution of a highly soluble component A at 80°C is cooled to 30°C .Calculate the...

A:

Q: Pure CO2 may be prepared by treating limestone with aqueous sulfuric acid. The limestone used contai...

A: To obtain the analysis of limestone we need to obtain the analysis of product and its components. Ap...

Q: (Barbir Chp6 Problem 1) Determine the required number of cells and cell active area for a fuel cell ...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: Calculate the equilibrium constant for the vapour-phase hydration of ethylene at 145 oC. C2H4(g) + H...

A: Given Data : Vapour phase hydration of ethylene is given in the question  The reaction is given as :...

Q: Q6/ Do you think that distillation is a good method for classifying and studying petroleum propeties...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: A simple Rankine cycle works betw een pressures 43 bar and 10 Kpa, the initial condition of steam be...

A: