blaj 4 The frequency of oscillations for the system described by the * block diagram is 1 K s(s+2)(s+3)

Q: In an RC circuit, how many time constant must elapsed if an initial uncharged capacitor is reach 80%…

A: According to the question we have to find the value of the elapsed time constant.

Q: Please please answer this question for me in 20 min and I will be grateful to you

A:

Q: A 100 Hz sinusoid is sampled at thrice the nyquist rate. Then how many samples are obtained in 2sec.

A: Given values are - f=100Hz Given that signal is sampled at thrice of nyquist rate.

Q: 8(t) 22sin (400zt) = Find the fundamental period of g(t). The fundamental period of g() is ms.

A:

Q: Determine which of the following statements is true or false, and correct the wrong? Demodulation…

A: There are two different terms are related with the signals one us modulation and one is…

Q: In a series connected RL circuit, if the circuit is fed with a square signal, the waveform below can…

A: Given   R= 150 ohm L=86.7 μH Vtt= 10 V  F= 100 kHz

Q: Given: Regd: RT RA A B Rc

A:

Q: The result of the convolution sin(t) * 8(2t + 2) is А. B. sin(t) С.—1 D. sin(t + 1) O A. . O B. . O…

A: We need to find out given convolution . We will use impulse property of convolution

Q: A series RLC circuit is excited by an ac voltage v(t) = Sint. If L=10H and C=0.1F, then the peak…

A:

Q: A series RLC circuit shows a phase angle of positive 20degrees. (The oscilloscope trace shows the…

A: The solution is given by

Q: A source voltage of an AC series RLC circuit is 120 V. The circuit consists of the ff. quantities: R…

A:

Q: 8- The RC circuit as shown in Figure has been connected for a long time. What is the potential…

A:

Q: Calculate the R value according to the fact that a sinusoidal sign is observed at a frequency of 38…

A:

Q: In an RC series circuit, E 12.0 V, R = 1.0 MQ, and C = 3.1 uF. Calculate the time constant.

A: Find time constant of rc circuit

Q: .A series RLC circuit has elements R = 150 ohms, L = 18 mH and C = 2.22 microfarads. What is the…

A:

Q: Compute the impedance of a parallel RLC circuit with the following values: R = 70 2 L = 354 mH C =…

A: As we know that for calculating impedance first we have to calculate reactances.

Q: g(t) = 8sin (20t) + 8cos (4t) Find the fundamental period and fundamental frequency of g(). The…

A:

Q: Q. Find the number of closed loop right half s-planes of CG(s) = lo 353+ 65+5s+3

A: Routh Hurwitz  necessary but not sufficient  condition for stability is a)The coefficient of all…

Q: (s+0.02)(s+6.25) G(s) = 8 - Which of the following compensators is given the function at the bottom?…

A: We need to tell about the given function type .we will compare it with standard form of controller.…

Q: Using the formula in the second image, compute for the following current of the AC Series RLC…

A:

Q: when the capacitor discharges. from t= 1s to t= 10s during its t (s) 1 V(V) 9.4 7.31 5.15 Use…

A: 1)By the above circuit voltage across the capacitor is   Vct=V0e-tRC volt   from the above table Vc1…

Q: Q Analyze the signal to its even and odd components and then sketch the three signals x(t) = sin…

A:

Q: Let's consider the series RLC circuit below. Let the input V = 0. R and C are positive constant…

A: The circuit is simple series RLC circuit in which the input voltage is given as zero. So the energy…

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 сos (67лt). Select one: O a. 77 O b.…

A:

Q: A series RC Circuit with R=2000 Q and C= 2µF has a Time Constan of %3D 4000 ms 4 micro seconds None…

A: Given :R=2000 ΩC=2μFTo find Time constantThe formula for time constant, τ =R*Cτ=2000×2×10-6 τ=4×10-3…

Q: An RLC series circuit has a average true power of 6.7mW and power factor of 0.31. What is the…

A: In this question series RLC circuit is given...And true power and power factor is given..We have to…

Q: Compute the impedance of a series RLC circuit with the following values: R = 77 N L = 304 mH C = 35…

A:

Q: Q8: For the system shown in figure (8). R(s) s+5 K C(s) Figure (8) s+6 (s+4)(s +4s +8) A) Draw the…

A:

Q: 3. Compute the V1 and V2 for the circuit shown below. 1045V 3/0 A 120 5- Design an RC circuit to…

A: In the circuit,  Find the voltage V1 and V2  We are solving using the nodal analysis.  We are using…

Q: A series RLC circuit has R=8 Q, L=50 mH and C=10 mF. The frequency of the circuit is w=100 rad/sec.…

A: NOTE :- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: In RC circuit if R=2002 and C=50μF, then the time constant T for the circuit is * O 1μs 2μs 2ms 1ms

A: Given data, Resistance R=20 Ω Capacitance C=50 μF

Q: Convert the given Delta circuit to Y and find R1 RC RB 150 90 RA 120 37.5 ohms

A:

Q: 8. Calculate the inductive reactance of a 3.00 mH inductor when 60.0 Hz and 10.0 kHz AC voltages are…

A: Inductive reactance = (2×pi× frequency × inductance ). Resonance frequency in RLC series circuit is…

Q: Determine the value of ER

A: The voltage across resistor can be found by multiplying current through the resistor and value of…

Q: Fine the time domain waveforms of i(t). R1 i(t) 30 N + R2 V(t) = 110 cos(2760t+0°) V 60 N 65 μF

A:

Q: Consider a series RC circuit as in Figure below for which R =2.2 MQ, C=8.4 µF, and e=30.0 V. Find…

A: According to the question we have to find the value of the Time constant.

Q: و Ra غير دلتا إلى معادلة تحويل النجوم ل لعثور على .كما هو موضح في الشكل Rc و Rb R, R. بال م2

A:

Q: A series RLC circuit is excited by a 100 volts 79.6 Hz source. Resistance R is 100 ohms inductance L…

A:

Q: If the value of C in a series RLC circuit is decreased, the resonant frequency is reduced to zero…

A:

Q: The RC circuit of the figure is fed from the constant magnitude variable frequency sinusoidal…

A: When inductance  (L) and capacitance (C) are connected to the AC circuit, then their reactance…

Q: 6 kΩ R2 2 kn c1 µF out The value of the corner frequency in the circuit shown is...rad/s 700 666 220…

A: First we will find out the transfer function then we will find out cutoff frequency expression from…

Q: t=0 R rit) 1. Find ſt) in the RLC circuit above where R = 7 Q, L = 25 mH, and C = 2.0833 mF.

A: We have to find i(t) given in the circuit for the values: R=7Ω L=25mH C=2.0833mF

Q: bläs 4 The frequency of oscillations for the system described by the * block diagram is 1 K s(s…

A: Transfer function:  The ratio of the Laplace transform of output to the Laplace transform of input…

Q: What is the unit step response of the system shown below? 10 R(s) Σ StI C(s)

A:

Q: Q6: chose the correct answer for the following: 1-the Nyquist sampling rate for the signal: 500mt…

A: In this question,  We need to choose the correct options The Nyquist sampling rate for the signal..…

Q: Select the correct answer 7. In principle, the SNR is a ratio between magnitudes of... A. frequency.…

A: In principle, the SNR is a ratio between magnitudes of power.

Q: In an audio signal processing and chord detection algorithm, the following signals are used as test…

A: Given a discrete signal To find: Its time Period

Q: A 9.3 uF capacitor is charged by 60 V batteries and then is disconnected from the battery. The…

A: Given: Capacitance, C=9.3 μF Capacitor voltage, Vc=60 V Resistance, R=1200 Ω

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.