Block Shear The tension member is a PL3⁄8×51⁄2 of A242 steel. It is connected to a 3⁄8-in. thick gusset plate, also of A242 steel, with 3⁄4-inch diameter bolts as shown in Figure P3.5-1. Determine the nominal block shear strength of the tension member.

Q: The gravity wall is made of concrete. Determine the location of the center of gravity (G) for the…

A: To determine the centroid of the dam.

Q: A reinforced concrete beam, supported on columns at ends, has a clear span 5 m and 0.5m effective…

A: Given. A reinforced concrete beam,clear span,cs= 5meffective depth,d= 0.5 mLoad,ω=  100 KN/mFind the…

Q: What will be the metacentric height of a rectangular block having dimension 6 × 3 × 1.5 m if the…

A: Given - Dimention of rectengular block = (6×3×1.5) m Submerged height = 0.8 m To find - The…

Q: Determine the maximum load P that can be applied to the beam if the bearing plates A' and B' have…

A: Given: Required : Maximum value of P

Q: A saturated sand sample has a dry unit weight of 18 kN/m² and a specific gravity of 2.65. If yw 9.81…

A:

Q: A three-hinged parabolic arch subjected to a load w at L/4 distance from left support. The rise of…

A: Given- Rise of the crown=4 m Span = 20 m load w=80 kN It is needed to find the horizontal thrust at…

Q: An undisturbed sample of soil has a moist unit weight of 105 pcf, a moisture content of 15%, and the…

A: Objective: To determine the weight of water required to be added to reach full saturation.   Kindly…

Q: The scale of a map is represented by representative fraction as 1 : 4000. The distance between two…

A:

Q: SM soil Ko = 0.6 Assume elastic behavior Ysat 22 kN/m G = 100 MPa, v = 0.30 24m 6m 6m

A: The change in total radial stress at the springline of the existing right tunnel liner can be…

Q: Head Loss (m) 10.0 9.0 8.0 7.0 6.0 5.0 4.0 3.0

A: The loss coefficient for a gate valve, also known as the "flow coefficient" or "resistance…

Q: A non-Newtonian fluid is flowing in a floor having height 5mm and with a free stream velocity of 0.5…

A:

Q: 1. Ra XW VX Find Ra, Rb, Ma & Mb: WX Draw Shear & Moment Diagram YZ XW Rb

A:

Q: Find one cubic metre of concrete (1:3:5). Find the number of bag required?

A: Given data. One cubic metre of concrete 1:3:5Where,  1m3=1 part of cementSo,Find the number of bags…

Q: Determine the number of 8-inch-high by 8-inch-wide by 16-inch-long concrete (CMU) blocks required to…

A: Given, Size of CMU = 8" x 8" x 16" Length of fence = 250 ft  Height of fence = 6 ft 8 in or 80 in

Q: What is the differences between the behavior of dispersive soils and swelling soils?

A: To  find : difference between the behaviour of dispersive soil and swelling soil

Q: A deep na slopes 15 kN/m2, p = 15°, e = 0.76 and G = 2.7. Taylor's stability number for that sudden…

A: Given - A canal has Deep, H = 4 m Sides slopes = 1:1 The property of the Soil is, C =15 kN/m2 ϕ =…

Q: 1. Locate, and find the magnitude and the position of the resultant R at point A of the forces…

A:

Q: Given T = 0.6, SDS = 1.67, SD1 = 0.87, W = 1000 (kips), R = 8, and Ie = 1, find Base Shear V in kips…

A: Given, T = 0.6 SDS = 1.67 SD1 = 0.87 W = 1000 kips R = 8 Ie = 1

Q: Q- A hollow shaft of external and internal diameters as 100 mm and 40 mm respectively is…

A: Given data- A hollow shaft- External diameter D=100 mm, Internal diameter d=40 mm, Speed N=120 rpm,…

Q: Question 57 For a hydraulically efficient rectangular channel of bed width 5m, the hydraulic radius…

A: Given Data  Hydraulic efficient Rectangular channel  Bed width (B) = 5m  Find the hydraulic radius…

Q: A certain crop is grown in an area of 3000 ha which is fed by a canal system. The data is given as…

A:

Q: Problem 2: A bridge girder consists of W 760 x 161 and a channel C 380 x 50.4 and joined by 2 - 22…

A: Maximum bending stress in tension is the maximum stress in the beam due to the bending moment .…

Q: Determine

A:

Q: In a borrow pit, the natural soil was found to have a moist unit weight of 112 pcf. The in- situ…

A: Given, Moist unit weight of borrow soil, γmb = 112 pcf  Specific gravity of soil, Gs = 2.7  Dry unit…

Q: 1.34 The 7/8-in.-diameter pins at A and C that support the structure are in single shear. Find the…

A:

Q: 3.42 4K 200 8k F 12' 8k gk H E 4 EQUAL PANELS @ 12¹ = 48¹ russes Method of Sections: Section 3.3 4k…

A:

Q: QUESTION 1 If the accidental error is estimated to be ±0.0079 for each of 33 separate measurements,…

A: Given -  Accidental error for each separate measurement =

Q: I am still confused with the sign convention we were told that in rock mechanic the sigma y in…

A: This question is related to the Stresses transformation from Strength of the material from Civil…

Q: A trapezoidal channel has a bottom width of 20 feet, has side slopes of 2H:1V, and carries a flow of…

A: Given:- The bottom width of the trapezoidal channel = 20 ft The side slope of the channel = 2H:1V…

Q: Please estimate the evaporation rate in in./day using the Penman equation for an air temperature of…

A:

Q: 1. SOLVE FOR THE REACTIONS @SUPPORTS NEGEGEE WEIGH OF BEAM 120kN/m ст 1120 ки 50 kN/m + est 6m 3m

A: Given Data  Determine the support reaction.

Q: If the pressure inside the droplet of water is 10% more than that of outside pressure of the droplet…

A: Given: The pressure inside the droplet of water is 10 % more than that of outside pressure.…

Q: 1. Determine the magnitude and direction of the moment of the 500-N force about point O. 500 N 2 m 1…

A: "Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: As shown in the diagram, brine of specific gravity draining from the bot through a 100 mm pipe, the…

A:

Q: Problem 2: A bridge girder consists of W 760 x 161 and a channel C 380 x 50.4 and joined by 2 - 22…

A:

Q: Conduct an occupational risk assessment (risk analysis) of a quarry of aggregates. Identify the…

A: Given question has asked the followings:  Conduct an occupational risk assessment of a quarry of…

Q: h 1 B b H 2 H = 25ft h = 18 ft b = 8 ft B = 30 ft 8 = 72.4 lb per cu. ft Sconc=150 lb per cu. ft 1.…

A: Height of the dam, H = 25 ft Height of the water level = 18 ft b = 8 ft B=30 ft Density of water, δ…

Q: 1.43 The plate welded to the end of the I-beam is fastened to the support with four 10-mm-diameter…

A: Reference : Engineering mechanics, Mechanics of deformable bodies Given data : 4 number of bolts…

Q: A welded plate girder of span 25 m is Laterally restrained throughout its length. It has to carry- a…

A:

Q: A propped beam shown in figure below having a span of 6m, carries a uniformly distributed uniform…

A:

Q: ure 2m- B 2m 2m E D 4 m 500 N 2 of 2 700 N Identify the zero-force members in the truss shown in…

A: The force in any member can be determined by using the method of joints. In the method of joints,…

Q: The correction to be applied to each 55m chain length along oº slope ?

A: Given. The correction to be applied to each 55 m chain length along θ0 slope.

Q: The discharge in m^3/s for laminar flow through a pipe of diameter 0.08 m having a centre line…

A: Given Data; →diameter of pipe,d =0.08m→Centre line velocity, Umax=1.6msTo determine :Discharge ,Q in…

Q: A certain crop is grown in an area of 3000 ha which is fed by a canal system. The data is given…

A:

Q: Q.3 Torsional Formula A circular shaft of diameter 300 mm and length 2.5 m is subjected to a torque,…

A: Given data- A circular shaft- Diameter D=300 mm, Length L=2.5 m, Angle of twist θ=0.025 radian, To…

Q: If the limiting length of a line is 5 m Long plotted to a scale of 1 cm = 20 m, then find the…

A:

Q: The field capacity for a certain is 25%. If the dry density of the soil is 18.5 kN/m³ and effective…

A: Given -  Field capacity, FC = 25% Dry density = 18.5 kN/m3 Effective depth = 80 cm It is needed to…

Q: SITUATION 32 The simply supported beam in the figure below has a rectangular cross section 120 mm…

A: To find the Bending stresses

Q: Problem 2: a) Draw the influence line for the bending moment at point C b) Determine the maximum…

A: Given To find a) Draw the influence line for bending moment at C b) The maximum positive and…

Q: Calculate all forces acting on member CDB. - -3 A 20 38- 240 lb

A: