Briefly describe the tracer dilution method of discharge estimation and list its advantages and disadvantages/limitations.
Q: Describe any other conceivable elements that influence energy loss in open channel flow.
A: Following are the conceivable elements that influence energy loss: 1) Material : Rougher is the bed…
Q: Question 5 Direction: Choose A - When both statements are true; B - When both statements are false;…
A:
Q: Determine the discharge at pipeline 1 in lit/sec assuming f=0.02 for all pipes. CHOICES: a. 782, b.…
A: The problem is based on the parallel combinations of pipe flow. In this combination the head loss in…
Q: Normal depth O is valid with respect to all the given answers. O obtained for uniform flow is…
A: Normal depth obtained for only uniform flow And it can be obtained using both chezzy or Manning's…
Q: A 12-in-diameter new cast iron pipe is 1.0 miles long. Determine the discharge capacity of this pipe…
A: Given data: Diameter of the pipe (D) = 12in length (L) = 1.0 mile Head loss (HL) = 24.5 ft
Q: Q3 (a) Describe briefly the main objective water quality and state the main parameters involved in…
A:
Q: In a geometrically similar model of spillway, the discharge per metre length is of spillway is 0.167…
A: Prototype is the actual physical structure which is going to construct where design for the…
Q: A V-notch having vertical angle of 90° is used to measure the discharge through a channel. If there…
A: Given: Notch angle, θ= 90° Error in measuring the head, dH = 4.5 mm Estimated discharge, Q = 18 lt/s…
Q: Determine the following: What is Rainfall-Run off Relation? Definition of Hydrograph What is a…
A:
Q: Describe three advantages and three disadvantages of using variable speed pumps and connecting…
A: Variable speed pumps These types of pumps can operate at different speeds as the head and rate of…
Q: The sewage from an area of 400 acres is to be carried by a circular sewer at a velocity not less…
A: Manning's equation : Manning's equation is an empirical equation that is a function of the channel…
Q: What are the three reasons why we undertake discharge measurement in open channels
A: Open channel flow is the flow which takes place due to gravity and not under pressure. Hydraulic…
Q: What is Unit Hydrograph? Discuss Unit Hydrograph method of estimating maximum Probable Discharge.
A: The graphical representation of time versus discharge at a particular point on a stream or channel…
Q: a.) Which graph best shows the effect of detention in peak flow reduction?
A: peak flow reduction : The technique of eliminating excess water from a sewer network or collecting…
Q: Describe average discharge velocity.
A: Velocity is defined as the rate of change in distance covered by a body or object. Flow velocity is…
Q: Compute the discharge.
A: To find: Discharge
Q: (1 A venture flume is used to measure the discharge in a rectangular channel of width Wi and…
A:
Q: What happens to the value of the head loss if the discharge through the titling flume channel is…
A: The value of the head loss is increased, if the discharge through the tilting flume channel is…
Q: General Instructions: 1. A simple pipe network is shown in the figure below. Determine the actual…
A: Flow is supposed to be laminar when the ways of the singular particles don't cross or converge. By…
Q: Given the drainage area in above Figure calculate the discharge at the outfall using the rational…
A: A1= 1.3 acres ; C1= 0.50 ; Inlet time t1 = 7 mins. L1=500ftA2= 2.5 acres ; C2= 0.40 ; Inlet time t2…
Q: -. Calculate the discharge through the side slope of the channel is
A: To find : Discharge through channel.
Q: (a) What are the factors that influence the selection of a site for a stream gauging station? (b)…
A: The factors which influence the selection of a site for a stream gauging station are such as…
Q: Describe the features of a desirable suction line and discharge line design
A: Discharge : A discharge is a measurement of how much fluid flows in a certain amount of time. It's…
Q: What happens to the theoretical discharge if the flowrate traveling through the device is increased?…
A: Flow over rectangular weir is dependent on head , coefficient of discharge, length of weir .
Q: A discharge of 1.90 m3/s flows on an open channel with a slope of 0.0062. If the coefficient of…
A:
Q: What are the effects of a change in the V-notch angle on the discharge equation and the accuracy of…
A: Notches:- It is a device used for measuring the discharge through a small channel or a tank. It is…
Q: What effect do such losses have on your initial analysis of full-flow discharge? What other loss…
A: Given, L = 3.34 km or 3340 m D = 1000 mm or 1 m Q = 0.99 m3/s
Q: 8.67 A 1/25 scale model of a spillway is tested. The discharge in the model is 0.1 m³/s. To what…
A:
Q: Using the Manning nomograph and assuming n=0.013, determine the following: (a) An 800 mm diameter…
A: (Note-Since you have asked multiple questions, we will solve the first question for you. If you want…
Q: Discuss Unit Hydrograph method of estimating maximum Probable Discharge.
A: A unit hydrograph is the hydrograph of direct runoff caused by one unit depth (1 cm) of rainfall…
Q: Given the drainage area in above Figure calculate the discharge at the outfall using the rational…
A:
Q: Using the Manning nomograph determine the following: a. An 800 mm diameter sanitary sewer is built…
A:
Q: A rapid mixing basin is to be designed for a water coagulation plant, and the design flow for the…
A:
Q: 6. Using the Manning nomograph determine the following: An 800 mm diameter sanitary sewer is built…
A:
Q: community sampling line, calculate the diameter of the instrument inlet tubing required to keep the…
A:
Q: s/s on a grade of 0.007 ? (c) A 300 mm diameter sewer is built at a grade of 2 percent. What is the…
A: a.) Nomo graph solution The discharge capacity and velocity of flow is obtained from figure 2.21 ''…
Q: A rectangular channel has a width of 3.6m with a roughness coefficient of 0.013 Compute the critical…
A:
Q: A discharge of 108 L/s is to be measured by a triangular notch of vertex angle 60 degrees. What…
A: Discharge over a triangular notch = Q= 815Cd tanθ22gH52 Q= 108 L/s = 0.108 m3/s Cd= 0.57 θ=60° H=??…
Q: A hydraulic jump is designed to occur in a rectangular open channel . The ratio of the sequent water…
A:
Q: The incremental rainfall intensity data given in the table below were recorded at a gage located on…
A:
Q: Briefly describe the slope-area method of discharge estimation and list its advantages and…
A: 1)When it is not possible to make direct measurement especially during floods, slope-area method is…
Q: A simple pipe network is shown in the figure below. Determine the actual discharges in each pipe…
A: Hardy-Cross method: Predict flows in each pipe and create the total inflow…
Q: Describe the 'Rational' method of designing surface water drainage systems. Define fully any terms…
A: Q1) a) Introduction : The rational method is a straightforward method for calculating a small…
Q: A simple pipe network is shown in the figure below. Determine the actual discharges in each pipe…
A: Given data
Q: 116 ft3/s-day. The reservoir routing curves graph is given in Figure 1. Perform calculation until…
A: Given, Spillway crest elevation, H= 50 ft Coefficient, C=3 Spillway length, L=35 ft
Q: .What is Unit Hydrograph? Discuss Unit Hydrograph method of estimating maximum Probable Discharge.
A: Unit hydrograph- It is a hydrograph of direct runoff resulting for one unit of effective rainfall…
Briefly describe the tracer dilution method of discharge estimation and list its advantages and disadvantages/limitations.
Step by step
Solved in 3 steps with 6 images
- Briefly describe the slope-area method of discharge estimation and list its advantages and disadvantages/limitations.Other than current Meter method what other method can be used to measure Discharge. Explain the methodThe data pertaining to a stream-gauging site are given below. The rating equation of the current meter is v = 0.35Ns + 0.02 m/s where Ns =revolutions per second. Calculate the following: Round off your final answers to two decimal places, a. Discharge of the second segment? b. Velocity of the third segment? c. Discharge of the fourth segment? d. Velocity of the fifth segment? e. Discharge of the sixth segment? f. Total discharge?
- In determining discharge on closed conduit using Venturi meter, will there be an effect of the installation of the Venturi meter (i.e. inclined, horizontal, or vertical) in the value of the discharge computed? Explain your answerWhat are the three reasons why we undertake discharge measurement in open channelsWhat happens to the theoretical discharge if the flowrate traveling through the device is increased? (FLOW OVER A RECTANGULAR WEIR)
- In determining discharge on closed conduit using Venturi meter, will there be an effect of the installation of the Venturi meter (i.e. inclined, horizontal, or vertical) in the value of the discharge computed?Assume that the contaminated water is to be used for drinking. Using principles of hydraulics, calculate the diameter of a cast iron pipe needed to obtain steady uniform gravity flow of about 0.04 m3/sec given a grading of 0.5% slope.Show the formula used and complete solution. Graph the data given. All data of discharge are in ft^3/s.
- I NEED THIS ASAPPPP What is specific energy in open channel flow? Draw a typical graph of depth vs. specific energy for aconstant discharge in rapidly varied flow (RVF). Identify the regions of subcritical flow, supercriticalflow, and critical flow and alternate depths on the graphA pipe having a diameter of 3 m with roughness coefficient of 0.013 flows 30% of full depth. If the slope of the energy grade line is 0.0025, determine the discharge.Given the 2-Hour Unit Hydrograph shown below, construct a 3-Hour Unit Hydrograph using the S-Hydrograph procedure.