BUOYANCY: AN INVERTED CONE 10 CM ACROSS THE BOTTOM AND 12 CM HEIGHT  WITH SPECIFIC GRAVITY OF 0.9 FLOATS IN WATER WITH SPECIFIC GRAVITY OF 1.0. (NOTE 1 M = 100 CM) The draft in water of the cone is The displaced volume is The above volume is The total volume of the cone is

Q: determine the end moments of the beam shown in Figure 11.9a. Assume support B settles 1.5 in, and…

A:

Q: Use THREE MOMENT EQUATION MET determine the member end moments of the beam of the rectangular cross…

A: Calculation End Moment of beam using Three Moment Equations ####

Q: Direction: A four hour unit hydrograph of a catchment is traingular in shape with base of 80 hours.…

A: 4 hour Unit Hydrograph triangular in shape Base=80 hours Area=720 km2 Base flow=30 m3/s Phi-index=1…

Q: Q-4) An extruded aluminum beam has the cross section shown. Knowing that the vertical shear in the…

A: - Moment of area is given by QA ; QA = A1 × y1 Where ; A1 = Width × thickness Width = 4 - 2 (0.5) =…

Q: Determine D10, D30, D60 of the following soils using interpolation. Please show solutions.

A: Soil A Soil B Soil C sieve No. sieve size in mm % finer % finer % finer 4 4.75 84.231 100…

Q: What is the total number of unknowns if determining the reactions at points A, B, C, D, and E? C 250…

A:

Q: 15.6 Solve Problem 15.2 for the loading shown in Fig. P15.2 and a settlement of in. at support B.…

A: Given: E = 29000 ksi=201.3876 ksf I = 1650 in4 = 0.07957 ft4 The settlement, h = 0.5 in  Analyze the…

Q: USE THREE MOMENT EQUATION  Determine the reactions and draw the shear and bending moment diagrams…

A: E = 29000 ksi = 201.4 ksf I = 1530 in4 = 0.074 ft4 The support settlements of 1 in. at B and; 1/4…

Q: A vertical rectangular plane surface is submerged in water such that is top and bottom surface are…

A:

Q: Irrigation Engineering Q.1. Figure 1 can be seen a section of a hydraulic structure on permeable…

A: A figure of a section of a hydraulic structure on permeable foundation is given, we need to find out…

Q: a 15-meter precast concrete pile is to be lifted. if the unit weight of concrete is 23.54 kN/m3. And…

A: A 15m precast concrete pile is to be lifted. If the unit weight of concrete is 23.54kN/m3 and the…

Q: A 4-hour rainfall in a catchment of 250 km² produces rainfall depths of 6.2 cm and 5.0 cm in…

A:

Q: Q1/ (a) The soil profile at a building site consists of dense sand up to 2m depth, normally loaded…

A:

Q: Average free-flow speed and the jam density observed on a road stretch are 60 km/h and 120…

A:

Q: What are comm

A: A hydric soil is defined as a soil, in its undrained condition,is saturated, flooded, or ponded long…

Q: 2 m 15 kN 20 kN.m 1 m 1 m 10 kN/m -2m- B

A: Free body diagram:

Q: a. Determine the following design criteria for the bioreactor: Bioreactor Volume (V) Food to Biomass…

A: A continuous stirred tank reactor (CSTR) Activated Sludge Process is used to treat municipal…

Q: A prismatic bar of length 'L' loaded under its own weight (W=pg) is fixed to the roof of a building…

A: given : length = L weight ( W )  density = ρ acceleration due to gravity = g γ= ρ.g    To find :…

Q: What is ratio of young's modulus to modulus of rigidity for a material having Poisson's ratio 0.2.

A: Poisson's ratio = 0.2 To Find : Ratio of Young's modulus to modulus of rigidity ?

Q: 5.(c) A circular sewer is to be designed to carry maximum flow of sewage while flowing 70% full at a…

A:

Q: 4. Length of offset from long chord is equal to a)R-V R²-X² b) v R-X²-(R-M) c)) √ R²-X² -(R+M) d) v…

A: A curve of radius R  TO FIND :  length of offset from long chord

Q: Can just certain candidate system types be employed in a building?

A: A candidate system refers to a proposed solution for a particular aspect of a construction project.…

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- radius=R=5 cm area=A % error in area needs to be find out.

Q: A boom is pinned at A and supported by cable BC. If the weight of the boom is 500 kg, determine the…

A:

Q: 4. Length of offset from long chord is equal to a)R-V R²-X² b) √ R--X²-(R-M) c)) √ R²-X² -(R+M) d) v…

A:

Q: Average free-flow speed and the jam density observed on a road stretch are 60 km/h and 120…

A: Free-flow speed (Vf) = 60 km/hr. Jam density (Kj) = 120 vehicles/km.   For a linear speed-density…

Q: 4. The average spacing between vehicles in a traffic is 50 m, then the density (in veh/km) of the…

A:

Q: A 4-hour storm occurs over an 80 km² watershed. The details of the catchment are as follows. Sub…

A: area km2 loss @ mm/hour 1sthour rainfall in mm hour 2ndhour rainfall in mm hour 3rd hour rainfall in…

Q: The sign has a mass of 100 kg with a center of mass at G. Determine the components of the reaction…

A: The mass of the sign = 100 kg The weight of the rod AB is to be neglected To determine:- The…

Q: determine the member end moments of the beam of the rectangular cross section

A: ##Calculation of final end moment at support using Moment Distribution Method####

Q: Memb 9k skl 7k7 3k7 kg 4k 6 6k 以 H K 或許前業 ALIV VV ¥ 3' 4' 最★ nhóm 3' 3' 3' 关计

A: Compute the support reactions: RA+RJ=9+7+3+4+6=29 kΣMJ=0RA×12-9×12-7×9-3×6-4×3=0RA=16.75 kRJ=12.25 k…

Q: A Force of 397 N is at an angle of 69 degrees above the positive x axis. What is the y component of…

A:

Q: Define  a. Architrave b. Frieze c. Cornic

A: In order for a building to be truly aesthetic and structurally sound, it is imperative that its…

Q: An isolated three-phase traffic signal is designed by Webster's method. The critical flow ratios for…

A: An isolated three-phase traffic signal designed by Webster's method- Critical flow ratio for the…

Q: How high should a helicopter pilot rise at a point A just to see the horizon at point B, if the…

A: Distance between two points A & B d=40 km, To Find- The height of the helicopter h to see the…

Q: 8-2 Construct the influence lines for FRA FOB, ME, FQE, FRC, FRD QB ME, FQF by using static (or…

A: Construct ILD for : FRA , FQB , ME, FQE , FRC, FRD, MF, FQF

Q: Define the following traverse technical terms. (1) Traverse distance (d) x sin 8 (ii) Traverse…

A: The departure of a line is its projection on the east-west meridian and is equal to the length of…

Q: Calculate the reactions at the supports, draw the free body diagrams of each section, determine the…

A:

Q: Determine the oil surface elevation at section 1. Ⓡ Elevation=1 -60 m Oil, S-0.9 v= 3 x 10-5 m²/s…

A: Specific gravity of oil, S=0.9Kinematic viscosity, ν=3×10-5 m2/ske=0.5ks=0.045Discharge, Q=0.03…

Q: Observed N-value of an SPT test is 21. The N-value after correcting for dilatancy is 1. 18 2. 21 3.…

A: Observed N-value of an SPT test, No=21.

Q: A 4-hour rainfall in a catchment of 250 km2 produces rainfall depths of 6.2 cm and 5.0 cm in…

A: 4-hr rainfall,Catchment area A=250 km2,Rainfall depths = 6.2 cm & 5 cm in successive 2-hour unit…

Q: 5/117 Determine the reactions at A and B for the beam subjected to the distributed and concentrated…

A: FBD of the given Beam: To Determine : Reactions at A and B

Q: A theodolite is setup at point (A) , For observing target point (B) the vertical circle reading are…

A: The vertical circle readings are, For Left hand face, FLZenith Angle=303°48'0'' For Right hand face,…

Q: Example 16. The contour interval on a map is 15 m. If the upward gradient of 1 in 20 is required to…

A: Contour interval on a map =15 m Upward gradient between points = 1 in 20 The value of Horizontal…

Q: The concrete footing shown in figure is designed to support a dead load of 200 t and live load of 60…

A: Dead load DL = 200 t Live load LL = 60 t allowable soil pressure = 270 kN/m3  eccentricity e = 0.9 m

Q: Calculate the loadings on the column. The column will be supporting the loads from the roof and…

A: Roof Slope = 15° , Eave's Height = 5m , Bay Width = 6.4m , Dead Load, Pd=200kips , Floor Live…

Q: A velocity field is given by the equation v = (3x)i + (2y)j. The y-component of the acceleration,…

A:

Q: ABC is a continuous member and is pin-connected at A. There is a smooth pin, which is fixed to the…

A: Member ABC: Member CD:

Q: 4. Given the utility expression AK 0.05Ta 0.04Tw- 0.03T, -0.02C where Ta is the access time, Tw is…

A: Given the utility expression is as follows:  UK = AK - 0.05Ta - 0.04Tw - 0.03Tr - 0.02C   NOTE : As…

Q: An extended layer of soil with homogeneous rounded grains has 10% of the material finer than 0.007…

A: An extended layer of soil- 10% of the material finer than 0.007 mm. Constant C=750, To Find- The…

Thermal Processes

Some of the key areas where thermal processes find their application are: