Butane-fueled cigarette lighters, which give hundreds oflights each, typically contain 4 to 5 g butane (C4H10),which is confined in a 10-mL plastic container and exertsa pressure of 3.0 atm at room temperature (25°C). Thebutane boils at-0.5°C under normal pressure. Butanelighters have been known to explode during use, inflictingserious injury. A person hoping to end such accidents suggests that there be less butane placed in the lighters so thatthe pressure inside them does not exceed 1.0 atm. Estimatehow many grams of butane would be contained in such alighter.

Q: A real gas mixture consists of 35% N2 and 65% C2H4 (on molar basis), hasa pressure of 18 MPa and a t...

A: The value of the molar-specific volume of the mixture is to be determined and a comparison of this v...

Q: The airbags that protect people in car crashes are inflated by the extremely rapid decomposition of ...

A: Our objective is to find the balanced chemical equation for the decomposition of solid NaN3 into sol...

Q: Design a vapor compression cycle using ammonia as the refrigerant thatwill be used to maintain the t...

A: To do- design a vapor compression cycle using ammonia as the refrigerant thatwill be used to maintai...

Q: 10.7. Show that: (a) The "partial molar mass" of a species in solution is equal to its molar mass. (...

A: We need to prove the following: The partial molar mass of a species in solution is equal to to its ...

Q: Aldehydes react with sodium acetylide (the sodium salt of acetylene, Na-:C=CH) to give alcohols. For...

A: (a) A compound is said to be chiral if the mirror image is not superimposed on it. The product forme...

Q: A three process-cycle of an ideal gas, for which Cp= 1.064 and CV= 0.804 kJ/kg.k°, is initiated by a...

A: Given data: Cp=1.064kJ/kgK Cv=0.804kJ/kgK n=1.2 We need to find: QA, WN, e and PME

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of 2,6...

A:

Q: Ans this Q part A, B, C

A: Given: It is required to find magnitude of F, R and B streams

Q: A refrigerator has an ice tray compartment at -18.0°C and the room temperature is 20.2°C. The refrig...

A:   Given:                     Mass of water, m=377 g            Specific heat of ice, Ci=2.09 kJkg·K ...

Q: Given the following thermochemical equations, calculate the change in enthalpy for the formation of ...

A: Write the reactions as follows: 2H2g+O2g → 2H2Ol  ;  ∆H = -571.6 kJ Multiply with 12 on both sides. ...

Q: 1- A sample weighing 1 g contains acetic acid (FW = 60 g/mol). The content of acetic acid in the sam...

A: The weight percent of the acetic acid in the sample is to be calculated.

Q: 6

A: Energy density of pure gasoline = 115600 BTU/gallon Energy density of ethanol = 75670 BTU/gallon Cos...

Q: Heat Transfer Question

A: Given data: Number of revolution, n=180 rpm = 180/60 = 3rps Impeller diameter, Da = 0.61m W=0.122m D...

Q: Determine the Reynolds number for a flow of water at 25 ° C in a 1 in diameter sanitary pipe at a ra...

A: Given that, The temperature of water T = 25oC The diameter of pipe = 1 in The mass flow rate of pipe...

Q: A sample of gold weighing 227 grams is cooled then placed in a calorimeter containing 31 grams of wa...

A:  Write the expression for heat of reaction as follows:Q = mCpTf-Ti      ......(1)

Q: Acetylene, C,H,, is used in welding torches. It releases a lot of energy when burned in oxygen. The ...

A: Write the reaction for the combustion of acetylene as follows: C2H2 + 52O2 → 2CO2 + H2O;   ∆Hrxno = ...

Q: Oxygen in the air is traveling at an average speed of 444 m/s. If the coefficient of viscosity is 17...

A: Given that, Average Speed of Oxygen vavg = 444 msCoefficient of viscosity μ = 175 micropoise = 175 ×...

Q: Two successive reactions, A->B and 2B->C, took place in a container. Ten moles of A is initial...

A: Given data: Initial umber of moles of A = 10 mol Percentage yield of reaction 1 = 80 % Percentage yi...

Q: Consider if a reaction could happen as shown, stereochemistry is something to pay close attention to...

A:

Q: Give four design features of flue gas analysis stack?

A: Flue gas are the exhaust gas produced by the combustion processes. The main components of flue gas a...

Q: A steam power plant operates on the ideal Rankine cycle. Steam enters the turbine at the following c...

A: Rankine cycle Through Rankine cycle model, the performance of a steam power plant is measured. It is...

Q: The burner gas from a sulfur burner analyzes 9.2% SO2, 7.13% O2 and 83.67% N2. The raw sulfur charge...

A: Raw sulfur analysis: 90% pure sulfur (S) Cinder analysis: 15% unburned S Burner gas analysis: 9.2% S...

Q: 3. Giventhe following reactions, calculate the heat of formation of hydrazine in megajoules (A) AH =...

A:

Q: Parallel flow of atmospheric air over a flat plate of length L=3 m is disrupted by an array of stati...

A: The average coefficient for the convection of the entire plate is to be calculated along with the ra...

Q: In the SYNTHESIS OF BIODIESEL, in what state and shape, does transesterification favors the product ...

A: Biodiesel is conventionally produced by transesterification of organic matter such as vegetable oils...

Q: Do a diagram with the following information: ΔrxnH° = 691.52 kj mol-1 ΔfH°[CO2(g)] = −393.41 kJ mol-...

A: Given data: The standard heat of formation of reactants and product are given. ∆Hf0 [CO2 (g)] = –393...

Q: One kg of carbon for complete combustion requires __________ kg of air. In a heat treatment furnace...

A:

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of 1,4...

A: Given: ρ=1030 kgm3μ=2.12 cP    =2.12×10-3 Pa·sm˙=1405 kgsD=70 mm   =0.07 m

Q: k1 k2 In the following reaction in series A B C, the reactions are considered as 1st order. 1=k1 [A]...

A:

Q: 2. If 0.20 mol of hydrogen and 0.20 mol of iodine are initially introduced into 0.500 L reaction cha...

A:

Q: If you touch the sides of a beaker containing NaOH being dissolved, will it feel warm or cold to tou...

A: when NaOH is mixed in water, it gets readily dissolved. Dissolution of NaOH is highly exothermic rea...

Q: Q.1. A siphon is used to draw water from a large container as indicated in Figure. The inside diamet...

A: Given: Inside diameter of the siphon line from point E to B (Din)=0.04 m Diameter of the nozzle at ...

Q: Why is it important to indicate the wavelength of light used in your experimental data and on the Be...

A:

Q: Heat Transfer Question

A:

Q: 10.73 The normal melting point of benzene, C,H, is 5.5°C. For process of melting, what is the sign o...

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you wan...

Q: A lead ore, galena, consisting mainly of lead (II) sulfide, is the principal source of lead. To obta...

A: The given reactions are PbSs+32O2g→PbOs+SO2(g)     ∆H=-415.4 kJ        ........(1)PbOs+Cs→Pbs+COg   ...

Q: A petroleum reformate stream of 4,000 bbl/day is to be contacted with diethylene glycol to extract a...

A: Given: 4,000 lbdayof petroleum reformate steam 5 volumes of diethylene glycol to extract aromatics f...

Principal Quantities and EOS

A physical quantity represents the physical state of a system. It is expressed as the product of a number and unit. The basic quantities used in science are length, mass, and time. The principal quantities are the quantities that are independent of other quantities.