By converting the circuit to the s frequency domain, find the V0(s) and V0(t) values. Note: X value =67

Q: The transfer function is, $(s² +s+2) s+3s +s +5s+10 G(s)H (s) =- Calculate the angle of departure of…

A: Open loop transfer function

Q: Find the Root locus : C(s) _ (K(S+2)(S+ 3) S(S + 1) R(s)

A:

Q: Using the root locus method find the gain (K) for the system having K(s+2)(s+4) (s+1)(s+3)(s +5)…

A: It is given that: GsHs=Ks+2s+4s+1s+3s+5ξ=0.246

Q: Determine i(1) if the transfer function H(s) = I(s) = 5 V(s) s2 + 2s + 6 s2 + 3s + 2 and v(t)=10e…

A: From the given question  Clearly they mentioned intial conditions for current hence by using inverse…

Q: Find the transfer functions from the following system. R(s) Y(s) 1/s 1/s

A: To find the transfer function we convert the given block diagram into signal flow graph.

Q: 3. Find the even and odd part of the signal *(n) = 2r(n);- 3 sn s3 Also plot *.(n) & x,(n) %3D

A: To find and plot the odd and even part of the signal x(n)

Q: Determine Foster and Cauer RL realizations for the following impedance functions: (S+2)(S+5) а.…

A:

Q: Find the time-domain of the following sources: V = 200<0° V and I = 10<45° A

A: Given: V=200∠0° V and I=10∠45° A

Q: Apply thevenin's theorem and find Vth and Rth

A:

Q: Q.7/ Write the general form of the transfer function G(s) = C(s)/V(s) for the electrical network…

A: Transfer function of the electrical network.  Transfer function = ratio of Laplace of output signal…

Q: I. Deduce the transfer function, T(s)-₁(s)/V(s) of the following network.

A: The required transfer function can be obtained by using the kirchhoff's current law that is mesh…

Q: Major: Signal and Systems for elecrtical engineering students Q: 4cos(x)+5sin(x) = A*cos(x-theta)…

A: It is given that: 4cos(x)+5sin(x)=A*cos(x-theta)

Q: Q3: find and draw the frequency domain of the following signals:- 1- 4 (cos^2 x10^6XTtt)+ 3…

A: Solution :- First resolve the above expression :- 1-…

Q: 1. Examine the stability of the system by showing the dominant poles / poles of a system (s-6)(s+15)…

A: Given: Poles at -3-4j , -3+4j, -9. Zeros at 6 , -15

Q: find the vales of the following functions at t = -1, -0.5 0, 0.5, and 1 sec 10rect(t)cos(2tt-TT/2)

A: Given functionf(t)=10rect(t)cos2πt-π2

Q: For the electric network shown in the next figure obtain: 1) The Transfer Function,…

A: According to guideline we need to solve only first question. According to question, find transfer…

Q: v,(t) v,(t) +vc(t) Output Input dv,(t) RC- + v,(t) = RC dt (1)*ap° dt Assuming the behavior of this…

A:

Q: Q4. A system has the following transfer function 00(s) 2 0₁(s) 3s² + 3s + 2 Calculate the undamped…

A: Given: A system has transfer function θ0sθis=23s2+3s+2

Q: he perlod of the function co Select one: O a. 1/4 sec O b. 1/8 sec O c. 8 sec O d. 4 sec

A:

Q: If F( s) = 6(s 2)(s + 2) s(s + 1) (s + 3)(s + 4) then f(oo) is %3D O 2 O None of the choices 8.

A:

Q: 2. Find the transfer function, 8₂ (S)/F (s), of the mechanical system below: T(1) fo 1 kg-m² 1…

A:

Q: 1- Derive the transfer function of the electric circuits. x(t) R Ac y(t) source HH

A: The s-domain transform of the given circuit is

Q: Which of the following points is NOT on the root locus of a system with the open-loop transfer…

A: Given  G(s)H(s)=ks(s+1)(s+3) s=0 s=-1 s=-3

Q: ww 12Ω ww ww 25 2 3 H 60 Ω in ll ww

A:

Q: Example 1 (Group Activity): Obtain the response, v.(t) of an RC circuit when the input, vị(t) =…

A: Given

Q: The transfer function is, s(s² +s+2) sʻ +3s³ +s² +5s+10 Calculate the angle of arrival of the…

A: The root locus plot is the plot of movement of poles and zeroes when the open loop gain is varied.…

Q: For an RLC circuit, if the complex power S for the whole circuit is S=10260°VA, then: * P=8.66 W,…

A:

Q: For the circuit shown below, obtain the voltage transfer function H,(w). R, R:

A: We need to find out transfer function for given circuit

Q: 2 A system has a transfer function G(s) = %3D . Is the system stable? (s-9)

A: If the transfer function of the system contains the poles which is available on the Right side of…

Q: V,(s) for the V,(s) Find the transfer function, circuit given below. 100 kN 100 kN 1 µF 100 kN 1 µF…

A:

Q: 2. Show that lo e is a solution of the differential equation IR + L=0 Where lo is the current at t =…

A:

Q: Obtain the response, v, (t) of an RC circuit when the input, v;(t) = 5e-3tu(t) Expression for…

A:

Q: Find the R and C magnitudes in the given circuit.

A: Given Data: V = 20∠0I = 5∠30L =0.1 H

Q: G(s) = s(s+3) OR docks e) State the effects of adding poles to G(s)H(s) on the root locus. having

A: The effect of adding poles to G(S)H(S) is as follows:

Q: ot locus for all values of K ranging from 0 to * by K G(s)H(s) = · s(s+4){s² +4s+ 2 salient points…

A: It is a locus of roots of the characteristic equation when the gain parameter is varied from 0 to…

Q: K G(s)H(s) = where K >0 ... (2) s(s + 1)(s+2)(s+ 4) Sketch the root locus. The sketch must be…

A:

Q: The phase criterion for the root locus is -자- 1 G(s) K 1 K = G(s) O 1+ KG(s) = 0 QUESTION 2 The…

A: 1. General characteristic equation is given by  1+G(s)H(s)=0 If k is a gain and H(s)=1 then the…

Q: 1. For the circuit shown, find the transfer funtion H(s) = V , /V , (s). s=j@. 0.2 F V; + 0.1 F 5Ω

A: To solve above problem, one should know about transfer function of a system. Transfer function of a…

Q: x(t) 4 A y(1) = [ x(7) dr x(1) :) dt 0 1- -A (a)

A: Given yt =∫-∞txτdτ

Q: A system with zero initial conditions has the closed loop transfer function. 3+4 (s+1)(8+4) T(8) :…

A: Given close loop transfer function is -

Q: 0.50 H 7Ω 0.50H 4 2 This circuit can be represented by the transfer fumction 12(s) Vs(s) bis s2 +…

A: According to question we have to find the value of b1, a1, a0.

Q: Using the Parseval theorem, find the energy of the following signal. x[n] = 3sinc(n/5)sin(2πn/8)

A: We need to calculate the energy of the signal: x[n] = 3sinc(n/5)sin(2πn/8) using Parseval theorem.

Q: PROBLE M 8.10 Consider the circuit illustrated

A:

Q: Consider the root locus diagram shown below. Im k = 0 k = 0 Re k=0 The root locus intersects the…

A: In this question we have to find the intersecting point in the root locus

Q: Determine i(t) if the transfer function I(s) s2 + 2s + 6 H(s) 5. s2 + 3s + 2 %3D V (s) and v(t)=10e…

A: Laplace transform of the voltage given above :- v(t) = 10e-3tu(t)V(s) = 10(s+3)       Put the value…

Q: Determine i(f) if the transfer function I(s) V(s) s2 + 2s + 6 = 5. s2 + 3s + 2 H(s) and…

A: Given , I(s)V(s)=5s2+2s+6s2+3s+2v(t)=10 e-3tu(t)

Q: Find the expression for the overall system transfer function of the system below. K X(s- |(s+1)(s+2)…

A: In this question we will find overall transfer function of given control system.....

Q: The complement of the following function F(x.y,z)-Sum(2,3,6) is given by: Note: Prod is the product…

A: