200 21200 2Vs O 90 v600 224022402(c) Measure and record the current and voltage.V, =I =Return the voltage to zero and turn off the power supplyVdcAde(d) Calculate the equivalent resistance of the circuit using the values obtained in c).Equivalent Resistance, R = V/I, =(e) Disconnect the power supply and measure the total resistance of the circuit using your DMM.Ohmmeter Reading, Req =Ωeq(f) Using the indicated values of the resistors in the circuit, calculate the equivalent resistance.Calculated Equivalent Resistance, Reg =ΩFeqIs there a good agreement between the ohmmeter measurement of equivalent resistance,your computed equivalent resistance of (d) and the circuit calculated equivalentresistance of (f)?

The solution can be achieved as follows.

Answered: (c) Measure and record the current and…

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter13: Heating Control Devices

Section: Chapter Questions

Problem 28RQ

See similar textbooks

Similar questions

The power usage of a DC strip heater can be determined in either of two ways: (1) Heater resist- ance and voltage drop can be measured simulta- neously and power computed, or (2) heater voltage drop and current can be measured simultaneously and power computed. Instrument manufacturer specifications are listed (assume 95% level): Ohmmeter: - 1 Ω = Resolution, 0.5% =Uncertainty (% reading) Ammeter: 0:5 A = Resolution, 1% =Uncertainty (% reading) Voltmeter: 1 V = Resolution, 0.5%=Uncertainty (% reading) For loads of 10 W, 1 kW, and 10 kW, determine the best method based on an appropriate uncertainty analysis. Assume nominal values as necessary for resistance, current, and voltage.
The rating of a plant is as below: 325 MW of wind capacity, 215 MW of solar power, 750 MWh/day of battery storage. Cost of batteries: 189 $/kWh Calculate the LCOE of the battery system if the round trip efficiency is 95% and the battery life is 12 years. A. 545.06 $/MWh B.45.42 $/MWh C.0.045 $/MWh D.0.022 $/MWh *pls show work and ensure it matches with the multiple choice options provided above*
, calculate the internal resistance of thepower supply.
1) Can you use the experiment of Measurement of Direct Current and Voltage to verify ohm’s law?2) What will happen if, by mistake, the ammeter and voltmeters in the circuit are interchanged?3) What are the possible errors that can be expected in this measurement?
Everything is given just explain properly Calculate the power dissipated by the voltmeter and by resistor R given figure when (a) R = 250 ohm and (b) R = 2 Mohm. Assume that the voltmeter sensitivity (sometimes called the figure of merit) is 10 Kohm/V.
Please answer the "required" section and show full solutions Given: Ra= 10 ohms Rb=12 ohms Rc=12 ohms REQUIRED: -total current of system - total resistance of system
A constant current of 3.119A for 4 hours is required to charge anautomotive battery. If the terminal voltage is 119+ t/2 V, where t is inhours, (a) how much charge is transported as a result of the charging? (b)how much energy is expended? (c) how much does the charging cost?Assume electricity costs 0.19 cents/kWh. Put an illustration figute with compelte solutions, step by step, kindly handwritten it. THank you!
1. In an electric circuit where the voltage is 100 V and the resistance is 25 kilo-ohms, what is the current? a. 4 mA b. 25 mA c. 25 A d. 40 A 2. The ability of a 1/4 watt resistor to give off heat is related to its a. type of material b. mounting hardware c. type of conductance d. physical size 3. The three important ratings all resistors have are a. resistance, tolerance and wattage b. size, shape, and wattage c. length, diameter, and ability to give off heat d. wattage, length and voltage
.i. An electric heating element to dissipate 580W on 240V is to be made from nichrome ribbon 1mm wide and thickness of 0.005mm. Calculate the length of the ribbon required if the resistivity of nichrome is 1.1x 10-6Ωm.ii. The resistance of a coil aluminum wire at 21OC is 210Ω. The temperature of the wire is increased and the resistance rises to 240Ω. If the coefficient of resistance of aluminum is 0 .0039/°C at 21°C, determine the temperature to which the coil has risen.b) A capacitor is constructed with parallel plates and has a value of 50pF. What would be the capacitance of the capacitor if the plate area is doubled and the plate spacing is halved?
Which is the source to drain current of the circuit shown below? 158.3675 uA 1.34 uA 1.34 mA 324.1629 uA
A voltmeter having sensitivity of 200 ohm/volt reads 119 V on its scale of 219 V when connected across an unknown resistance in series with a multimeter. When the multimeter rads 5mA, calculate the error due to the loading effect of voltmeter. Also calculate the error if the milliammeter reads 800mA and voltmeter reads 40V on its 219 V scale.
3.Question (a) Look up the definition of unit for clothing insulation, called “clo” value. Convert 1.5 clo to a value with an unit in international standard. (b) In the winter, people wear more cloth to keep themselves warm. You have the option of wearing 2 jackets that are 0.3 cm thick or 1 jacket that is 0.6 cm. Assume they are made of the same material and neglect any effect from cloth openings. Which option should you choose to keep you warm? Draw a thermal circuit to help with your discussion.

SEE MORE QUESTIONS

Recommended textbooks for you

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning