C В A F В C' (a) AND-OR gates

Q: The Fourier transform of a continuous-time function x(t) is X (f) = x(t) e-j ²nft dt Choose A or B…

A: For the above given time domain sequence we need to calculate its fourier transform. For the next…

Q: A) Define the following: 1. Optoelectronics. 2. LASER. 3. Optical Detector.

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: If a 10-A and a 3-A flow into a node, how much current must flow away from that node? A) 30 A B this…

A: In this question we will solve problem related to kCL....

Q: how can improve the spectrum O resolution?

A: Spectrum Resolution: Spectrum Resolution is also known as Frequency Resolution It is defined as the…

Q: a. Design a 6-bit binary weighted ladder with V₂ = 5 V, R=1 kQ and R, = 5 kQ, a determine i. what…

A:

Q: Q4) A 220 V d.c. shunt motor has an armature resistance of 0.5 ohm, and runs at 850 rpm., When…

A:

Q: 6. The input voltage to the single-phase to single-phase cycloconverter is 120V(rms), 60Hz.The load…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: resistor R is connected in parallel with a 10-ohm inductive reactance. The combination is then…

A: We need to find out the value of resistance for given circuit

Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…

A:

Q: Three impedances 10-j30 are connected in star across 100 volts 60 HZ Line to Neutral, Calculate a.…

A: Given, Three impedance connected in star are, Z=10-j30 Ω Phase voltage, Vph=100 V Frequency, f=60 Hz…

Q: Determine the remaining intensity of the light leaving through 8.3Km optical fiber if the…

A:

Q: 32 Ω 4Ω i(t) + v(t) 3 Η 1/27 F Figure 3 t = 0 60 Ω 12 Ω (24 v

A:

Q: Find the Fourier transform x(t) for the following figure -T T

A: Fourier transform:- It is generalization of complex fourier series. It is a tool to break the…

Q: A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 30°, through a…

A: Given data, ZL=-240+j120ΩVs=-240∠30°VXTr=j60ΩXC=-j120Ω

Q: For the following reading of circuit current are [8, 8.2, 9, 7.8, 9.1, 8.5, 7.7, 7.9, 8, 8.1] mA.…

A:

Q: Find the voltage V2 for the network 8 mA A + +V/₂- R₂ www 2.2 ΚΩ +

A: Given circuit is:

Q: c) Explain why current flow in a MOSFET transistor. Use a diagram to illustrate your answer.

A: We need to explain why current flow in a MOSFET transistor.

Q: Design a combinational circuit that compares two 4-bit numbers to check if they are equal. The…

A: Combinational circuit: This is an electronic circuit that is created by the different types of…

Q: At a modulation index of 2, how much power is in the first pair of sidebands of a 1000 watt FM…

A: In an RF source the transmitted power is the actual power produced at the output. Modulation index…

Q: Determine Vo2 A) -1.0 V B) -2.4 V C) -6.6 V -9.0 V -10 Vo Ge Si KK I 1.2kQ 3.3 K2

A:

Q: The Fourier transform of a continuous-time function x(t) is X (f) = * x(t) e-j 2nft dt -00 Choose A…

A: For the above given time domain signal we need to plot time domain and frequency domain analysis and…

Q: B: The frequency test data of certain elements plotted on the bode diagrams and asymptotically…

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Given load impedance, ZL=40-j30° On comparing with ZL=R-jXC

Q: The Fourier transform of a continuous-time function x(t) is X (f) = [² x (t) e-/12nft dt Choose A or…

A: For the above given signal we need to calculate its fourier transform and time and frequency domain…

Q: Determine the total charge entering a terminal between t = 1 s and t = 2 s, if the current passing…

A: Given, Current passing the terminal, i=3t2-t A To determine the charge entering a terminal between…

Q: the blocked rotor test is performed on a wound rotor motor and if the rotor  winding is kept open,…

A: Always remember , the current flows through a close path. When the rotor winding are open i.e., no…

Q: what is the difference between common collector simplifier, common base amplifier and common emmiter…

A: BJT is a 3 terminal device. The terminals are base, emitter and collector. BJT acts like amplifier…

Q: The signal x(t) cos2n70t+cos 2n120t is input to the square-law modulator system given below with…

A:

Q: A 13800 / 480 V, 3-phase transformer bank is connected as a wye-delta configuration. What must be…

A:

Q: Which of the following is NOT a measurement made by a BERT tester? O Bit error ratio O Errored…

A: Bit error rate testing, or BERT, uses specified stress patterns made up of a series of logical ones…

Q: For the following circuit, if R=2 02, L-150 mH, and C-150 mF, find the value of the mesh current it:…

A: In this question,  We need to determine the current i1  using the mesh analysis.  We know Capacitive…

Q: Use your own words to define the following concepts: a) c) b) Equilibrium Density of states Fermi…

A: (a) EQUILIBRIUM: According to the equilibrium equation, there can be no net force.The object should…

Q: 3- What is the meaning of "square-law" detection?

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A transmission line has the following line constants R=0.1Ω/ km, L=1.26 mH / km, C = 0.009 μF / km…

A: Given data, C=0.009μF/kmL=1.26mH/kmR=0.1Ω/kmG=0 Let, f=50Hzω=2πf   =2π×50   ≅314rad/sec

Q: Problems Find the system frequency response for the off two of a) 2y[n]-syn-1]+y(n-2] = X[n]-7x[n-1]…

A:

Q: The signal x(t) = cos2n70t+cos 27120t is input to the square-law modulator system given below with…

A:

Q: A load of 240 +j 120 is connected to a source of 480 V with a phase angle of 30°, through a…

A: Given :A load ZL=240+j120 Ω is connected to a source voltage:V=480∠30° V through a transmission line…

Q: 1kΩ 2A 2kQ la ib 2v 3kQ 1kΩΣ Vik id In the ckt. Given, find the values of : a.) v₁k: 13A b.) ia : _V…

A:

Q: i need the answer quickly

A:

Q: the steady state behaviour a control system, for different types of input, with the help. of static…

A: static error constant Kp=lims→0G(s) H(s)Kv=lim s→0 s G(s) H(s)Kv=lim s→0 s2G(s) H(s)

Q: 3. Bridge type Power Supply with Capacitor 12V AC Ripple D₂ C Charges Bridge Rectifier D₁ (a) Output…

A: It is given that:

Q: Find the Fourier transform x(t) for the following figure -T T

A: To find the Fourier transform of the given triangular wave x(t)  Amplitude A = 1  Width of base = 2T

Q: Determine: a) Tp b) %us c) T, and d) T, for a ± 2% band

A: The characteristic equation is made with the poles of control system. From that we can fine the…

Q: Which of the following statements incorrect? correct about primitive cell There is only one way of…

A: Which of the following statements incorrect? A) There is only one way of choosing primitive cell. B)…

Q: 4.In FSK modulation, if the mark frequency is 105kHz and the gap frequency is 115kHz, the maximum…

A: Bandwidth: This is the range of frequency in which different frequencies of the signal exist.…

Q: * Digital communication required more bandwidth than analog communication so that need more…

A: Why digital communication requires more bandwidth than analog communication because: A. Modulation…

Q: I. 1. Please research on the following items: Instrument Transformers A. Current Transformers ➤…

A: Given data, A) Current transformers:- Its operation, its types, and its applications. B) Voltage…

Q: Simplify the following Boolean functions, using four-variable Kmaps: F (A, B, C, D)=Σ(2, 3, 6, 7,…

A:

Q: A telephone cable has the following primary constants per loop -KM R=30 0, L-20 mH, C 0.06 F and…

A: Characteristic impedance-                     ZC=R+jωLG+jωC Ω where , ZC=Characteristic impedance R…

Q: Two impedances, A and B, are connected in parallel across a 120 V AC supply. The total current and…

A: Given the supply voltage= 120V AC  Current adjusted to = 20A and power factor is lagging. To know…