(c) Which of the following would be considered control volume system? a Tire b. Piston-cylinder device C. Boiler d. A balloon filled with nitrogen e. Mixture of liquid water and air in a closed bottle
Q: Required information A garden hose attached with a nozzle is used to fill a 20-gal bucket. The inner…
A: A=π4(d)2=π4(112)2=0.00545ft2vavg=5.8fts-1
Q: Determine the discharge of a flowing fluid from a nozzle, whose specific gravity is 1.3, the nozzle…
A:
Q: 1. Find the height of the water in the figure shown neglect effect of air. PB = 0.2 ke/cm² PA =…
A: Given data in question Pressure at point A and B Depths Specific gravity To find out Value of H…
Q: In a given setup as defined by the figure below, determine the rate of change in terms of h(t) given…
A:
Q: Example Problem: Venturi meter system. The venturi meter shown in figure blow carries water at 60°C.…
A: P1=PA+γWy+1.18PA-PB=γ0.46-1.18+1.25×γw1.18PA-PBγ=-0.72+1.27×1.18PA-PB9.65=-0.72+1.27×1.18PA-PB9.65=0…
Q: The venturimeter shown has an pipe diameter of 500mm and narrows to a throat diameter of 200mm. If…
A: This term water flow rate refers to the amount of water that can theoretically escape from the pipe…
Q: A container is filled with 0.675 liter of fluids at pressure of 2000 kPa. When the pressure…
A: Given data- initial volume=0.675liter initial pressure=2000kPa final volume=0.670liter final…
Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm diamater orifice under a…
A: Given, Diameter of the cylindrical tank, D= 400mm Diameter of the orifice, d= 30mm Constant head, H=…
Q: In the figure, there are major and .minor losses in the system Vent 10 A 15 psig SA V ol Pump Vent Z…
A: The statement is true.
Q: Determine the density of Air at 84° F and 1 atm pressure. Assume laws of ideal gases holds.
A: Note : As per our guidelines for a multiple question only one question can be solved for other…
Q: Q2) There is gate inclined by 50° that separates a fluid from water on the left. Calculate he volume…
A: Introduction- Atoms and molecules make up a fluid. The distance between molecules varies by orders…
Q: Q28/Find the value of pressure of compressed Air in Pipe No. (1), if pressure of water in Pipe No.…
A: Given data Height of mercury columns Pressure of pipe 2.
Q: 2. Consider a double fluid manometer attached to an air pipe shown. determine the specific gravity…
A:
Q: A closed container contains 1.8m of oil (SG = 0.8) and above the oil, the absolute air pressure is…
A:
Q: Determine the diameter of the nozzle, if the flowing fluid in the nozzle has a specific gravity of…
A: To Determine Diameter of the nozzle, D
Q: Which of the following best describes a Venturi Meter? an opening having a closed O perimeter in a…
A: Venturimeter are Flow Measurement Instruments Which uses a converging section of pipe where we apply…
Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12…
A: As per guidelines of bartleby, experts are allowed to solve only first three subparts. Please post…
Q: Air P 76 kPa Consider a double-fluid manometer attached to an air pipe. If the specific gravity of…
A: Specific gravity of fluid2, SG2 =13.55Atmospheric pressure. Patm =100KPa.
Q: The discharge of air through a 600-mm pipe is 4 m3/sec. Compute the mean velocity in m/sec
A: Diameter of pipe=600m Discharge=4m3/s
Q: As shown in the figure below, a Venturi meter is installed on a 300-mm diameter pipe whose maximum…
A:
Q: Find the pressure in the pipe. Oil SG 0.79 370 kPa Gasoline SG 0.70 Air 45 cm 50 cm 22 cm Pipe 10 cm…
A:
Q: The average speed (in feet/second) of blood that flows in the needle if the piston being vithdrawn…
A:
Q: A rectangular vessel 200 mm x 300 mm x 500 mm in height contains oil having a specific gravity of…
A: Apply standard formula for orifice
Q: . A simple mercury manometer connected into a flow line gives reading as shown in the figure. Local…
A:
Q: The flow from a lawn sprinkler is 140 L/min, B₂ = 180° as shown in the figure below and the total…
A: step 1-
Q: Venturi meter is used for measuring the flow rate of fluids in pipeline ..... Compressible O…
A: ANSWER: Both Top
Q: 9- A bowling ball of mass 7.5 kg travelling at 10 m sec-rolls off a horizontal table 1 m high.…
A: Mass=7.5kg Vx=10m/s
Q: The pipe flow in the figure is driven by pressurized air in the tank. Assuming f = 0.012 and the…
A: Diameter of pipe=50mm Q=18.5L/s f=0.012
Q: 5- tire having a volume of 5 ft contains air at a gage pressure of 36 psi and a temperature of 80 F.…
A:
Q: Q3) A Your company has been asked you to design a storage tank for liquid petroleum gas. The…
A:
Q: Oil discharges from a 250mm diameter pipe through a sharp crested round orifice, 100mm in diameter…
A: Given data in question Diameter of pipe and orifice Specific gravity Deflection in manometer…
Q: A fluid is flowing in a pipe 8 inches in diameter with a me an velocity of 10 feet/second. The…
A: Given data: Diameter of the pipe = 8 inch=0.667 feet Velocity , v= 10 ft/s Pressure, P=5 psi=720…
Q: The venturi meter shown 200 mm inside diameter in figure carries water at 60° C. The specific…
A:
Q: Consider incompressible , frictionless flow of a fluid in a horizontal piping. The pressure and…
A: Bernouli's Theorem for frictionless flow is given as; For a horizontal flow, the equation becomes;…
Q: A venturi meter fitted to a pipe of 400 mm in diameter and has a throat diameter of 200 mm. Find the…
A:
Q: A fountain ejects water through the two nozzles A and B, which have inner diameters of 10 mm. The…
A: Given: The inner diameter is 10 mm. The velocity of flow at point C is 1.1 m/sec. The diameter of…
Q: The venturi meter shown below carries water at 60°C. The inside dimensions are machined to the sizes…
A:
Q: tank contains ail sp. gr. 0.80, gasoline sp. gr. 0.90 and seawater sp. gr. 1.03. If the depths of…
A:
Q: epth of flo
A: Given data depth of flow at the point as 5m width=1m
Q: glecting air resistance, if the maximum height of a vertical jet of water from a nozzle can reach…
A: h=5m To find diameter of nozzle
Q: A pump takes water from an 8 inch suction pipe and delivers it to a 6 inch pipe in which the…
A:
Q: Calculate the flow rate through the system
A: Answer We can use Bernoulli's energy equation to calculate the flow rate through the system Consider…
Q: Q.15 Water is flowing through two pipes one of 10 mm diameter and second of 5 mm diameter and both…
A:
Q: For the system below assume frictionless one dimensional flow. A circular nozzle with prescribed…
A: (1)Determine the force applied on the plate and the velocity in section 1 (D1) of the nozzle.…
Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…
A:
Q: TIA the formula. 191 Air (y w0.20 bem ELABORATE 48 in Try to solving these problems: 30 1. Estimate…
A:
Q: Compute the absolute pressure in KPA of a given tank if a barometer reads 820mmHg and a pressure…
A:
Q: Water is pumped from reservoir A at elevation 250 m. The pump is close to reservoir A and is at the…
A:
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- Kindly show complete or detaled solution. A rectangular water tank is divided by a partition into two chambers, as shown. In the bottom of the partition is a round, sharp-edge orifice with a diameter of 150 mm. The coefficient of discharge is equals to 0.62. At a certain instant, the water level in B is 2.5 m higher than A. How long will it take for the water surfaces in the two chambers to be at the same level? a. 399 s b. 157 s c. 279 s d. 220 sOrifice Given:As = 3m2C = 0.92Ao = 0.01m2 Determine the time for the depth of liquid in the tank to be 0.8mA proposed elevated tank for a certain community has a diameter of 72 inches and a height of 120 inches. It is to draw water by a pump from an aquifer down below the ground. Two steel hoops, 24.4 in2 in cross section, are installed around the tank, one at the bottom and one at the top, to prevent the bursting of the tank by the water pressure inside. (Use unit weight of water, water = 62.4 lb/ft3). Note: h = 8.881ft. a) Compute the internal stress at the bottom of the tank (in psf). b) Determine the tensile stress at the top (in psi). c) Determine the tensile stress at the bottom (in psi).
- 1.) 38 lps of water flows through 90 m of a 6 inches nominal diameter, schedule 40, cast iron pipe. The pipe contains two 90o -standard elbows, two full-open gate valves, a full-open angle valve, and a backflow limiter (check valve). The discharge is located 6 m higher than the entrance. Consider the water viscosity of 0.01002 Poise.a) Determine the total head loss in the pipe line.b) What is the pressure difference between the two ends of the pipe? Use the Moody’s equation for the friction factor.Soda ash liquor having 1250 kg/m³ density and 1.2 cP viscosity flows through a 215m length of a 150mm-ID steel pipe. The equivalent length of the fittings may be taken as 70 pipe diameters. A venturi meter with the throat diameter of 75 mm is installed in the line shows a differential column height of 26 mm on a mercury manometer. What is the flow rate in kilograms per second? The roughness of the inside surface of the pipe is 0.0000457 and a flow coefficient of the venturi of 0.985.A. 8.54B. 12.62C. 15.21D. 17.50Oil is being transported at a rate of 20gal/min through a 2-in schedule 40 steel pipe (ID = 2.067in). The oil has a viscosity of 20cP and a specific gravity of 0.85. The line is slanted, and the static pressure at one point in the line is 45 psig. Calculate the static pressure (in psig) at a location in the line 200 feet further along flow direction and 50 feet lower in elevation.
- A fluid is flowing in a pipe 8 inches in diameter with a mean velocity of 10 feet/second. The pressure at the center of the pipe is 5 psi and the elevation of the pipe above the assumed datum is 15 ft, compute the total head in feet if the fluid is a) water, b) oil (sp gr = 0.80), c) molasses (sp gr = 1.5) and d) gas (w = 0.040 psf)A firehose discharges 5 l/s. The nozzle inlet and outlet diameters are 75 and 25 mm respectively. Calculate the forcerequired to hold the hose in placeA water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tabk in L/min is: A.25 B.5 C.11 D.7
- A proposed elevated tank for a certain community has a diameter of 72 inches and a height of 120 inches. It is to draw water by a pump from an aquifer down below the ground. Two steel hoops, 24.4 in2 in cross section, are installed around the tank, one at the bottom and one at the top, to prevent the bursting of the tank by the water pressure inside. (Use unit weight of water, water = 62.4 lb/ft3) note : (h in ft.) = 8.523a) Compute the internal stress at the bottom of the tank (in psf). b) Determine the tensile stress at the top (in psi).c) Determine the tensile stress at the bottom (in psi).The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank at the ground level and the nozzle at the end of the hose is pointed straight up. The tank cover is airtight, but the pressure over the water surface is unkown. Determine the minimum tank air pressure (gage) that will cause a water stream from the nozzle to rise 72 ft from the ground. Include your fbd. Choices: A.13.5 psi B.16.5 psi C.15.5 psi D.14.4 psiA 30m long, 20mm diameter steel pipe is used to drain an oil tank determine the discharge when the oil level in the tank is 4m above the exit of the pipe. Neglect minor losses, (assume f = 0.12)