Calculate the area (in sqm) of the cross-section of ranges DF. (Type your answer using 2 decimal places, numerical value only, no need to include the units). Note. First vertical distance from "F" is 6.9 m (if not readable) 10.0 4.826 25 14.0 (1.4 3.7 3.7 7.5 5.4 7.4 59.0 5.3 15.0 8.2 20.0

Calculate the area (in sqm) of the cross-section of ranges DF. (Type your answer using 2 decimal places, numerical value only, no need to include the units). Note. First vertical distance from "F" is 6.9 m (if not readable) 10.0 4.826 25 14.0 (1.4 3.7 3.7 7.5 5.4 7.4 59.0 5.3 15.0 8.2 20.0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: noves on a line from (2,3) to (6,5) assume that the distance is measured in meter. How much work is…

A: Given:- F=15N V=3i^+4j^ To find:- Work done

Q: Find distance db

A: To find distance db

Q: -8.6 Use integration to determine the coordinates of the centrc une region shown. Answer: x= 2.86 ft…

A: To find centroid

Q: Solve for the missing line details: latitude, departure, distance, and bearing. Lot Side Length (m)…

A: To find. Missing details of the lot. Length Bearing. Latitude Departure

Q: Compute the missing side AB. (Type your answer using 2 decimal places, numerical value only, no need…

A: A closed traverse ABCDA is given in which the bearing of all lines are given and distances of line…

Q: Q.3. A levelling table is given below. a) Calculate the elevations of every station given in the…

Q: Calculate the y-coordinate of the centroid of the shaded area. The triangle is equilateral.…

Q: Find the interior angle Bat point 2inside the basel ne of polnts 12 and 3. Please do not write any…

A: given, point x y 1 2420.25 1512.48 2 2221.24 1550.79 3 2526.97 1570.24

Q: Problem 3: for the following manometer drawn bela Note: Not drawn to scale 30cm

Q: Adjust the measurements given in the drawing below and determine the coordinates of point B. Assume…

A: yA (y-coordinate of A) = 1756.17, xA (x-coordinate of A)=1944.79 yMk1 (y-coordinate of…

Q: What is the length of the dividing line? (Type your answer using 2 decimal places, numerical value…

Q: Calculate the y-coordinate of the centroid of the shaded area. The triangle is equilateral. -32 107…

A: The given figure is shown below:

Q: In the accompanying tabulations, the length and direction of one side are unknown. LINE AB BC…

A: A closed traverse bearing and length have been given in the tabulated form and it has been asked to…

Q: 1. Compute the omitted measurements for lines 3-4 and 4-5 Latitude Departure Line Bearing Distance N…

Q: a. What is the cross sectional area in sq m of the rive? b. Assuming that the discharge in the end…

Q: Find the interior angle B at point 2 inside the baseline of points 1,2 and 3. Please do not write…

A: Given, point y x 1 1512.48 2420.25 2 1550.79 2221.24 3 1570.24 2526.97

Q: compute the distance DB

A: The given data is as follows: Length of baseline, AB=400 mAngle DAB=27∘30'Angle CAB=78∘30'Angle…

Q: Problem 2- Find the coordinates of center-of-gravity (X,9) for the following part: 50 20 15 010 15…

Q: Q1: determaine the coordinates of the centeroid of the shaded area 20 40 50 20 40 30 140

A: The polar coordinate system is a method to calculate points in the system location by proper…

Q: Find the angle between the two planes 4x-y+3z=12 and x+2y+4z=4. Make a sketch of your answer.

Q: The accompanying tabulation gives elevations of points over the area of a 30m by 40m city lot. The…

A: An Imaginary line on the ground surface joining the points of equal elevation is called a contour.…

Q: Locate the x position of the centroid for the parabolic area. Type your answer including units…

Q: Determine the length of distance BC

A: The given table shows the bearing of closed traverse. It is required to find the distance of line…

Q: Given the 10m-grid elevations, find the volume, using Grid Method, Simpson 1/3 rules 2n4 Degree) and…

A: The grid corners are plotted on the ground and spot levels are identified by level. Normally the…

Q: LINE AB BC BEARING N70°55 E DISTANCE (m) 43.73 29.91 S05°30' E S 30°44' W S 86°40 W N 23° 4T W CD DE…

A: given - field notes of closed traverse to find - missing data

Q: 960 cm ← la 980 Scale 1:25,000 1000 ELEVATION 1000 IN METERS

Q: Determine the coordinates of the centrond of the shaded area. 25 80 y I Answers: X = i i 45 25 * 165…

Q: The distance from A to B as measured is 165.2 m. If the 50 m tape used is 0.01 m too long, what is…

Q: Complete the missing data. Plot the traverse using an appropriate scale. LINE DISTANCE (meter)…

Q: Determine centroidal coordinates of the volume. 610 mm 813 mm 1220 mm wu 099

A: Consider the figure,

Q: Given: Lines Distances Вearing S 73°21'E S 40°10'E S 26°42'W N 14°20'W N 12°20'E А-В 247.20 В-С…

A: Given The bearings are given in quadrant bearing system we will change them into whole circle…

Q: FUNDAMENTALS OF SURVEYING 1 All azimuths are measured from South. All angles must be written to the…

A: The length of line can be determined by using the coordinates. NOTE: As per guidelines we need to…

Q: Calculate the area of the rectangle where the coordinates are given in meters as shown in Figure…

Q: The left and right water edges of a river are 2.75m, and 62.45m, respectively, from an initial…

Q: Plot the open compass traverse tabulated below. Use convenient scale. Line Length (m) Bearing АВ…

A: The handmade drawing of traverse is attached which will give you idea about the plot.

Q: EX2: A close traverse shows tabulated values of latitudes and departures Lines Latitude Departure…

A: Given :- a tabulated value of closed traverse

Q: Calculate the y-coordinate of the centroid of the shaded area. The triangle is equilateral. 26 55 77…

Q: Q16 - A distance shown with 12 cm in the 1 / 600.000 scaled map I. It is indicated by 20 mm on the…

Q: Given the tabulated measurement of the closed traverse as shown. Determine the missing data. Line…

Q: Compute the missing side AB. (Type your answer using 2 decimal places, numerical value only, no need…

Q: Calculate the area (in sqm) of the cross-section of ranges DF. (Type your answer using 2 decimal…

Q: 4. Given an illustration and table. Find the total area. A SURVEYOR BEARING DISTANCE 510.52 m 432.12…

Q: Determine the total perimeter of the lines that form the boundary of the shaded area in the Figure.…

A: Given:-

Q: 1. INTERPOLATING CONTOURS GRAPHICALLY. The accompanying tabulation gives elevations of points over…

A: Given, Horizontal scale 6 cm =10 m Index contour=880,885,890 and 895

Q: line from A to B 5 cm on a map with scale 1/2500. This line must be fixed on ground surface if the…

A: Given Scale = 1/2500 Note Correction due to slope is always negative.

Q: The lengths and W.C.B. of the sides of a closed traverse ABCDEFA are given below. Prepare a Gale's…

A: Solution I have only solve gale chart part Given table Line Length (ft) W.C.B. AB 6 47012'17"…

Q: What is the Easting coordinates of Point B (3 decimal places), given the coordinates of Point A (EA,…

Q: In the accompanying sketch, a vertical angle of −14°30' is read to a target 1.75m above point M. The…

Q: Convert this graph to absolute and relative Cartesian coordinates. 1.00 0.75 2.00 1.50 1.25 0.50…

Q: In a survey of a piece of oceanfront property, measurements of the distance to the water were made…

Concept explainers

Pressure and Stress

Question

Solve as soon as possible like 5 minutes thsnk you

Calculate the area (in sqm) of the cross-section of ranges DF. (Type
your answer using 2 decimal places, numerical value only, no need to
include the units). Note. First vertical distance from "F" is 6.9 m (if not
readable)
10.0
4.826 25
14.0
(1.4
3.7 3.7
7.5
5.4
7.4
59.0
5.3
15.0
8.2
20.0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Rewrite the following in station notations: a. Stake located 10,682.325 m frombeginning b. Stake located 2,345.21 ft from beginning (ans: a. For metric system, Sta.10 + 682.325 b. For English system, Sta. 23 + 45.21)
Explain the following: a. Azimuthb. Bearingc. Traverse d. Meridiane. Longitude and Latitude
The ground distance as corrected from temperature sag and pull correction is 10,000 meters. Ifthe sea level reduction factor is 0.9998756 and the grid scale factor is 0.9999, compute the griddistance of the same line A. 9997.756 B. 9997.576 C. 9996.756 D. 9995.767 E. none of the above
compute the distance DB
answer ASAP! UPVOTE WILL BE GIVEN! PLEASE WRITE THE COMPLEETE SOLUTIONS AND LEGIBLY! FUNDAMENTAL OF SURVEYING The left and right water edges of a river are 3.75m and 65.25m, respectively, from an initial reference point. Verticals are located at distances of 11.25, 19.25, 27.25, 35.25, 43.25, 51.25, and 59.25m, respectively, from the reference point. The corresponding depths of verticals are 5.2, 9.7, 9.6, 10.0, 10.4, 10.0 and 4.2 meters. Mean velocities in the verticals are 0.16, 0.60, 0.75, 0.92, 0.97, Activ 0.98, and 0.65 m/sec, respectively. Disregarding the end to sections, determine the following: Discharge & Mean velocity of the river.
UPVOTE WILL BE GIVEN! Write the solutions legibly. Answer in 2 decimal places. FUNDAMENTALS OF SURVEYING The left and right water edges of a river are 2.75m, and 62.45m, respectively, from an initial reference point. Verticals are located at distances of 11.25, 19.25, 26.75, 34.45, 40.95, 46.95 and 54.45m, respectively, from the reference point. The corresponding depths of verticals are 5.0, 9.6, 9.8, 10.0, 10.4, 10.0 and 4.8 meters. Mean velocities in the verticals are 0.16, 0.60, 0.75, 0.92, 0.97, 0.98, and 0.65 m/sec, respectively. Disregarding the end sections; a. What is the cross sectional area in sq m of the rive? b. Assuming that the discharge in the end sections of the river to be zero or negligible, what the total discharge of the river in cum/ sec? c. What the average velocity of the river in m/sec?
Line AB has the following data: Latitude = -588.25, Departure= +78.34, DMD = +78.34. Determine the double area (2A)
Geometric space, i need solutions in 10 minutes please. MCQ/Find the horizontal distance AD. If BD and CD were 30m and 80m respectively A-19.45 m B-14.45 m C-11.25 m D-18.27 m E-14.85 m F-13.26 m
are taken (0 setting out @ HW: From the base line AB, the linear measurements (offsets) are ; EF. find CD . DE knowing that AB = 170°5- rectangular fence CD)
A given traversed has the following results: Total perimeter= 3,615.40m, Total Departures = 1,842.64m, Total Latitudes= 1,868.94m, Latitudes= +0.68, Departures= +0.42m. For line BC distance equals 394.60m and its latitude is 249.40N and departure is 364.20E. Compute the correct distance and bearing of line BC.
Line AB has an azimuth of 322° 40' 20" (origin point is B). Find the principal angle in degree for line AB Round to the nearest 2 decimal places and enter the unit. Note: Give me clear calculations
In the quadrilateral ABCD the sides were measured as follows: AB, 8.34 m; BC 7.77 m; CD, 8.99 m; and DA 14.83 m. If the angle between sides AB and BC is 117.85 degrees, determine the area of the quadrilateral. PLEASE NEED ANSWER IN 10 MINS. SORRY BUT IT HAS NO DIAGRAM PRESENTED.