Calculate the difference A- B ifA=10236.87° and B=10253.13°. Show your solution graphically.

Q: A CT of nominal ratio 1000/5 A is operating with total secondary impedance 0.4+j0.3 N. (1 At rated c...

A:

Q: is the time interval required for the particle to go through one full cycle of its motion. it's the ...

A: The message signals have less frequency. With this less frequency, it is not possible for the messag...

Q: Given the notations F1 (A, B, C) = 1(0,1,2,4) F2 (A, B, C) = r(1,3,5,6) design a combinational circu...

A:

Q: 5. An ideal 300W transformer has an input current of 9 A and an output voltage of 230 V. Determine V...

A: Brief description: Transformer is an electrical device which is used to step up and step down the vo...

Q: A coil having an inductance of 50 mH and resistance 10 ohms connected in series with a 25 microfarad...

A: At resonance imaginary part of impedance is zero I.e, XL=Xc. Current at resonance =voltage/resistanc...

Q: Determine each statement if it is TRUE or FALSE. A1.  The system response when the initial conditio...

A: As we know that a system has two input response that are zero state response and zero input response...

Q: -j10 ww j22

A:

Q: Problem 2 For the circuit shown, use Nodal Analysis to determine the values of the voltages Va, Vh a...

A:

Q: The LDR has resistance 1M2 when the lights are off, and 10kN when the lights are on. DrB has a beefy...

A: The node voltage can be calculated by applying kirchhoff's current law in the node and by using the ...

Q: A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing posi...

A: Plot the waveforms with given data Current waveform come after voltage waveform with 36° lag Use the...

Q: 4. Obtain the power factor and the apparent power of a load whose impedance is Z=60+J40 OHMS when th...

A:

Q: 7. The equation of motion for a rotational mechanical system is jë + bò + k® = T(t) +G(t) 0(0) = 5, ...

A:

Q: armature winding of a 200-V, 4-pole, series motor is lap-connected. There are 280 slots and each slo...

A: We need to find out speed for given motor   

Q: the following Boolean expression F (A, B, C D) = B' +C'D + A'BD' using NAND gates ONLY. Note that co...

A:

Q: D Question 5 A dynamical is defined by the Frequency Response Function H(w) = a +2iw, with a=17.6. T...

A: The solution is given below 

Q: 3nu(-n) 0.1nu(-n) + 2nu(-n) Determine if stable system or not using infinite geometric series formul...

A: If the GM series converge to a finite value then the system is stable otherwise Unstable.  

Q: An engineer built the circult deplicted in the figure. Assuming E - 8.60 V and R- 5.30 0, find the f...

A:

Q: why is it important to know how to estimate the electrical materials, tools and PPE needed for the j...

A: It's critical to understand how to estimate the electrical materials, tools, and personal protective...

Q: Given the complex number A =10253.13°, calculate A". A+ A", and A-A".

A:

Q: 3. A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing p...

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are peri...

Q: [18] the current flows through the conductor from O the negative end to the positive one. the positi...

A: the current flows through the conductor from

Q: incult shown in tigure for the Coupled below, detexmine the value of current Î and Ig ssume V=loo.

A: The given circuit is shown below: V=100 V

Q: Which is not part of a cathode-ray tube oscilloscope? a. Electron gun b. Digital panel meter C. Fluo...

A: Considering the block diagram of cathode ray tube oscilloscope,

Q: Draw a sinusoidal voltage waveform with peak value of 200 volts and has an instantaneous value of 10...

A:

Q: Suppose x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10). Assuming fractions are truncate...

A: Given that, x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10).     

Q: Prove that the expression: F (A,B,C)= (A+B) (A+BC) +A'B'+A'C' =1.

A: This question belongs to digital electronics. It is based on the concept of simplification of the fu...

Q: simplify the expression f(x.y.z)=x+y'z+(x+y'z) times Q. Q is any expression.

A: We need to simplify the given Boolean expression

Q: R; + + VI Vz R1 VL

A: We need to find out unknown resistance and power rating of zener diode and load resistance .

Q: An N-channel JFET has IDSS = 16 mA and VP= -6 volts. Calculate the drain current and VDS (sat) when ...

A: JFET An N-Channel JFET consists of electrons as the charge carrier that constitutes the current flow...

Q: Calculate 1.) le, re 2.) Rin, RTH, Z1 3.) V1, V2, Vo

A: Note “Since you have posted a question with multiple sub-parts, we will solve first three subparts f...

Q: Question # 01: Apply the knowledge gained from the ac analysis of BJT to construct the AC equivalent...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Q. 3 Use any method of your choice and find the values of v, and i, in the circuit shown in Figure f...

A:

Q: Determine the waveform of the output voltage Vo in the network efficiently for sinusoidal input sign...

A: Find which diode is conducting in each half cycle then apply basic circuit laws to find he output vo...

Q: [10] In parallel branches, the current will be the same unless all the resistances are the same. Tru...

A:

Q: A series RLC circuit consists of R = 1000 ohms, L = 100 mH and C = 10 picoFarads. The applied voltag...

A: RLC circuit in series A resistor, inductor, and capacitor are connected in series across a voltage ...

Q: Which figure represents the Boolean expression, where O is the symbol for "exclusive OR" WΘΧΘΥΘΖ (A)...

A: Exclusive OR  A logical operator that results in zero when then the bits are the same. The result is...

Q: Design an op-amp circuit to yield the relationship shown in each equation. Vo = 8A + 8B – 3C – 12D ...

A: Op-Amp is a device or integrated circuit which is used to amplify the two input voltage difference.

Q: I WO 1oads are connected in parallel across a 12,470-V rms source. One load takes 23 kVA at 0.75 lag...

A:

Q: SA For the given circait, show that the power dissipated is 120 200 equal to the power supplied. 40 ...

A:

Q: (PLA)(implement all of them using one PLA). F(I3, I2, I1, Io, S1,So) = m11 + m36 + M47+ M59 F2 = S,I...

A:

Q: Modulation is the process of modifying a base signal with a carrier signal, and it is used mostly in...

A:   Given, In frequency modulation Carrier frequency (fc) = 570 kHz Amplitude of carrier signal (Ac) =...

Q: There are five cells combined in series to form a battery. A light bulb with a resistance of 4 ohms ...

A:

Q: A receiver requires 0.5 µV of signal for satisfactory reception. How strong (in microvolts) must the...

A:

Q: device for producing electrical current by moving a coil of wire in a [9] magnetic field is a electr...

A: None of the above Since answer is ELECTRIC GENERATOR Generator or alternator produces electricity by...

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 sin(wt+30°) V2(t) = 10 cos(wt+30°) V3...

A: In this question,  Voltage equations are given.  Write the phasor representation of the given voltag...

Q: → XCF) = SCf - 2000 +56(f+200) + [6(F-300)+ S(F+30) > XE) = 2-56(F-2000) +2-5 6CF+2000) + 1-5 6(F -3...

A:

Q: A 4-pole, 240V, wave connected shunt motor running at 1000 rpm and drawing armature and field curren...

A: SOLUTION- Given,  P =4  A = 2 (Wave connected)  N = 1000 rpm Z= 540 Ia = 50A If = 1 A    Eb= 240-50...

Q: Determine the current that flows through an 8n resistor connected to a voltage source v 110 cos 377t...

A:

Q: Draw a sinusoidal voltage waveform with peak value of 200 volts and has an instantaneous value of 10...

A:

Q: Two units, connected in parallel, are energized by an a-c source. If the component currents are 15 a...

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.