Calculate the energy stored in a 1000 μF capacitor at t = 50μs if the voltage across it is 1.5 cos 105t volts. The answer is 90.52 uJ but I can't figure out what I am doing wrong. Can someone help me

Calculate the energy stored in a 1000 μF capacitor at t = 50μs if the voltage across it is 1.5 cos 105t volts. The answer is 90.52 uJ but I can't figure out what I am doing wrong. Can someone help me

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 22RQ: What is the unit of measurement for the strength of a...

See similar textbooks

Related questions

Q: In the circuit shown, the switch has been in position a for a very long time before it moves to…

Q: Determine the damping ratio (zeta - C) of a system from analysis of its differential equation, given…

Q: sion 7 et red d out of question Find Vo using voltage divider. To 12 V +1 + Οι 12V O d. -3V O e. 8V…

Q: In the following circuit, find the current Ilx, and the voltage V1, For IL = 3.6 mA. R w 2 km2 6 mA…

A: In this question, We need to choose the correct option We need to determine the Current Ix and…

Q: 3.17 Using nodal analysis, find current i, in the circuit of Fig. 3.66. 4Ω 60 V Figure 3.66 For…

A: Given: Circuit diagram,

Q: 110v R₁ 105 R4 152 R3 15-2 R2 103 RS wwww 154 RC 15 Ra Ra wwww 205 R8 wwwwww 25-4 Rio 201

Q: The triangular voltage pulse shown below is applied to a 200 mF capacitor. a) Write the expressions…

A: Capacitor has two conducting plate seperated by insulating medium. Capacitor store energy in form of…

Q: 7VAC

A: Diode is an uncontrolled semiconductor device which operates in either ON state or OFF state. If…

Q: A 25 MVA, 11 kV, 3-phase alternator has xd" 0.3 pu and Zo = 0.2 pu. It's = 0.25 pu, Z₂ = neutral is…

A: Given- 25 MVA, 11kV, 3-phase alternator, Xd=0.25 pu,Z2=0.3 pu,Zo=0.2 pu, To Find- The fault current…

Q: 7. The Zener diode in the voltage regulator circuit shown in the figure below has the following…

A: Zener diode is a type of diode which allows the reverse current within certain sets of reverse…

Q: Three parallel resistors have a total resistance of 500 ohms. If two of the resistances are 1 and 5…

A: We need to find out unknown value of resistor for given combination of resistor .

Q: For given value of the circuit, Vsupply = 120 V, and with R₁= 2002, R₂-30.0, R3=75, R4=300, R5=…

A: The required parameter can be calculated by using mesh analysis and ohms law. By using the mesh…

Q: A 20KW short shunt generator with a terminal voltage of 250V has armature, series and shunt field…

Q: (b) Two long parallel wires are a distance d apart and carry equal but opposite currents I, as shown…

A: Magnetic field density due to a long current-carrying wire is directly proportional to current and…

Q: Answer the following questions. 1. When two resistances are connected in series a) They must both…

Q: 3. Find current I in the circuit 50/0° 12 Ω Μ α 2Ω 4 Ω m -j3 Ω b -4 Ω Η 8 Ω C j6 Ω 8 Ω

Q: For given value of the circuit, Vsupply = 120 V, and with R₁= 2002, R₂=30.0, R3=75, R4=3052, R5=…

A: Given: Circuit diagram with the voltage source and the resistances.

Q: Find the Thevenin equivalent at terminals a-b of the circuit given below, where V=85 V. + Vo ww 10…

Q: In the following circuit, find the current Ix, and the voltage V1, For IL = 3.6 mA. R 2 kf2 6 mA…

Q: (c) Prove, using the definitions of sinh and cosh in terms of the exponential function, that…

A: Given: Function, cosh(2x)=1+2sinh2(x).......(1), And we know, coshx=ex+e-x2,sinhx=ex-e-x2.

Q: Series coefficient ao (trigonometric form representation) for the function f(t), defined on [-2,2],…

A: We need to find out the Fourier series coefficient for given signal .

Q: 1.4 1.3 1.2- 1.1- 0.9- 0.8- 0.7- 0.6- 0.5- 0.4- 0.3 0.2- 0.1 0+ 0 X:0.691 Y:1.249 X:0.394 Y:0.901…

A: Given the plot between voltage and time X axis is time Y axis is voltage We need to find Vp, Vfinal,…

Q: :?For the shown Network, what is the region of operation of the npn transistor 300 ΚΩ 12 V lb 4,7 ΚΩ…

A: If transistor collector to emitter voltage is >0 then transistor is operating in active region.…

Q: B)Express the signal shown in below II, Xcn) 111 II -3 2315

Q: :For the shown Network and using the re-model, compute the output resistance Zo 62 ΚΩ li 470 uF Zi t…

A: We need to find out the output impedance for given circuit .

Q: Find current I, in the following circuit using the phasor approach, if Z₁ = 40, Z₂=j30 £2, Z3= 402,…

Q: QUESTION 5 is P 0.8 pf lagging + Vo P 0.9 pf lagging For the circuit shown above, what is the…

A: We need to find out output voltage for given power .

Q: 1. A single phase, 60Hz, 20-km short transmission line receives 700 MW at 0.95 lagging pf at 327.8…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 2. Find the output waveform Vi +10 V -10 V <<- 1 mS V DZR Vo 2 V

Q: Input, u(t) G(s) = 4 s² + 2s + 10 Output, y(t)

Q: The electric field is E = ax +ây + 3â, and &-5 on the side containing the point of origin from the…

A: We need to find out tangential component of electric field in medium second , we will use boundary…

Q: Determine the value of gain K to make the system stable

Q: Hw.2) In the circuit below, you are required to calculate V2, which makes the current (ix) flowing…

A: The required parameter can be calculated by using the superposition theorem and it states that the…

Q: Are pulse generators and signal generators the same?

A: Given: Pulse generator and Signal generator

Q: Plot the amplitude and phase spectrum (single and double sided) for the following signal:

A: It is given that: f(t)=-2+10sin(2π×105t-20°)-14cos(6π×105t+30°)+7sin(4π×105t-50°)

Q: For the bridge circuit given, Vsupply = 70V, and R₁= 206, R₂=40N, R3=37.5N, R4=509 and R5= 1009. For…

A: In this question, We need to determine the value of Rb . We are solving this problem using the…

Q: The plane interface between two dielectric is given by 2x+3z-4 for source-free medium. On the side…

A: We need to find out the normal vector for the given surface .

Q: Write the Verilog code for an 8-to-1 multiplexer using the if-else statement

A: We know that mux is a combinational circuit which produces output based on its input lines.

Q: calculate the apparent power

Q: Find the currents of each resistor using super position method. Where, VLeft = 160V; VRight = 180V;…

Q: 3. The switch in the circuit below was in position 1 for a long time before moving to position 2 at…

A: In this question we need to find obtain an equation for the capacitor voltage for given condition.

Q: QUESTION 6 P 0.8 pf lagging + 0 For the circuit shown above, what is the input power factor angle?…

A: The circuit is shown below: The source current is given as: is=I1+I2 The complex power supplied…

Q: 17.Derive the equation that links voltage,charge and capacitance.

A: The objective is to determine. Q=CV Here, Q is the charge, C is the capacitance and V is the…

Q: Assume k will result in marginally stable system. Construct the root locus for the negatively unity…

Q: A 3.0 MΩ resistor and a 1.0 μF capacitor are connected in series with an ideal battery that has an…

Q: Find the output of the receiver system shown below. The receiver is also known as the "quadrature…

Q: Why is a additional control signal necessary for a bjt and not a necessary for a diode?

A: Types of semiconductor device Uncontrolled Device ( Diode) Semiconductor device ( SCR)…

Q: 5. Transform these sinusoids to phasors: - (a) i = 6 cos(50t – 40°) A (b) υ V= -4 sin(30t + 50°) V

Q: Determine the damping ratio (zeta - 2) of a system from analysis of its differential equation, given…

Q: at 0.86 lag Ay Asphone, 4 poke, 230 V, Solte I'm drang a 6o A Current from the supply Pif. If the…

A: Induction motor working Principle When an ac supply is connected to a stator it creates a rotating…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A 811 uF capacitor has an initial voltage, v(0) = 1 V. If the current flowing through the capacitor is i(t) = 18 mA, what is the voltage v(t) across the capacitor, at time t= 12ms? Enter your answer to 3 significant figures.
calculate the heart rate in beats perminute for R=150 kΩ, C=6 μF, if the capacitor discharges when itsvoltage reaches 60% of the source voltage Vs
The current in a 25 mH inductor is known to be −10 A For t≤0 and (−10 cos 400t−5 sin 400t) e−200t A for t≥0. Assume the passive sign convention. At what instant of time is the voltage across the inductor maximum?
An uncharged 0.2 μF capacitor is driven by a triangular current pulse. The current pulse is described by i(t)={0,t≤0;5000t A,0≤t≤20 μs;0.2−5000t A,20≤t≤40 μs;0,t≥40 μs. Derive the expressions for the capacitor voltage, power, and energy for each of the four time intervals needed to describe the current.