Calculate the MAWQ for an electronic balance with a linearity of 0.001 g and an acceptable error of 5% or 0.05.
Q: 2- How much solution (in ml) of silver nitrate at a molar concentration of 0,0540 mol/l is needed as…
A: The double replacement reactions occur when ionic chemicals in a solution react with each other.…
Q: Using conversion factors, solve each of the following clinicalproblems:a. A nurse practitioner…
A: Ans: Given values: Stock of promethazine injection : 25mg/mL Dose required : 12.5 mg Ampicillin…
Q: 66. On this spirogram from a 25-year-old patient, the functional residual capacity is represented by…
A: The amount of air in the lungs is measured using lung volume and lung capacity. The amount of air…
Q: measured in the experiment is different from the Tm predicted from Marmur and Doty equation. please…
A: In 1962 Marmur and Doty discovered a linear relation between the base composition of DNA expressed…
Q: The table contain results of using highly accurate P-1000 micropipette. The res Target volume 1000…
A: A two-position plunger with friction "stops" is standard on most micropipettes. The loudness is…
Q: The elution order does not match the expected order for coconut oil and the peaks do not match.…
A: Introduction:- The wick, meat, and milk of the coconut palm fruit are used to make coconut oil, an…
Q: stion 11 Calculate the amount (grams) of solid KOH to prepare 50 ml of 5 mM KOH solution (Molar…
A: Molarity It is defined as the number of moles of a substance dissolved in 1 liter of a solution.…
Q: Using conversion factors, solve each of the following clinical problems:a. The physician has ordered…
A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: 20.28 The following initial velocities were determined spec- trophotometrically for solutions of…
A: Enzymes are proteins that can catalyze all biochemical reactions inside living organisms. They are…
Q: What is displacement value, why is it important in pharmacy calculation? In which pharmaceutical…
A: Pharmacy is the branch of health science that connects medical science with chemistry. It is…
Q: Which pharmaceutical products need specific gravity measurement? Mention three examples
A: Pharmacy is the branch of health science that connects medical science with chemistry. It is…
Q: 11
A: The three radioactive elements given in the question like 3H, 14C and 35S are small energy beta…
Q: Please discuss the value of international normalized ratio (INR) as a test. Why do you think this is…
A: PT test is the normal blood test conducted to record the time taken for blood to clot.
Q: In some cases, the Km and Vmax can be estimated by inspecting the values of the initial velocity (V…
A: Enzymes are proteins that catalyze biochemical reactions. They are classified into six classes-…
Q: Question 168cm and 57kg. What is the BMI?
A: Introduction The BMI is defined as the body mass index of a person and is found by dividing a…
Q: Derive the Michaelis–Menten equation.
A: Michaelis-Menten equation defines the rate of enzyme catalysis by relating the rate of reaction…
Q: Calculate the average dipole–induced-dipole interaction energy, in joules per mole (J mol−1),…
A: Interaction energy is the energy released or required for binding of two molecules together. It…
Q: The drug dosage for the patient is calculated using a BSA of 1.9m2. If the order is 15mg per m2, how…
A: The drug dose refers to the quantity of a drug prescribed by the physician to be consumed at any one…
Q: Table of caffeine standards concentration Sample Conc, ppm Std1 16 Std2 32 Std3 48 Std4 64…
A: Given : 16 ppm std 1 concentration MM caffeine = 194.19 g/mol
Q: give the respective the TOTAL DILUTION FACTOR of respective serial dilutions. show complete…
A: Introduction: A serial dilution is any dilution in which the concentration decreases by the same…
Q: What information can be obtained from a kinetic data where 1/v is equal to 0.5 min/mole, when 1/[S]…
A:
Q: A. Kinetics Data 1/[S], mM-1 0.5714 0.4608 0.3333 0.1818 0.0952 1/Velocity (min/mM) Uninhibited…
A: Enzyme is basically biocatalyst that increase the rate of chemical reaction without itself being…
Q: The amount of calcium in physiologic fluids can be determined by a complexometric titration with…
A: Titration is a common laboratory method of quantitative chemical analysis to deter mine the…
Q: At what concentration of S(expressed as a multiple of KM) will νo=0.95Vmax?
A: The enzyme catalyzed reaction is a biochemical reaction involving conversion of substrate molecules…
Q: You have a stock solution of 40% hydrogen peroxide. You need to make several dilutions for a…
A: Dilution of Hydrogen peroxide (H2O2): Dilution of Hydrogen peroxide (H2O2), is carried out by adding…
Q: Discuss the limitations of the lineweaver-burk plot and suggest alternative secondary plots and…
A: An enzyme is a biocatalyst that increases the rate of chemical reaction without itself being changed…
Q: (i) Define the Ramachandran plot (simply). (ii) Explain with one example (simply). (iii) how to…
A: Ramachandran plot is given by GN Ramachandran in 1963. This lot is used for the assessment of the…
Q: , cylindrical tube
A:
Q: 10. What is Relative Centrifugal Field (RCF, in g's) in a centrifuge with a rotor radius of 10 cm…
A:
Q: 6. If the y-intercept of a Lineweaver-Burk plot = 1.91 (sec/millimole) and the slope = 75.3 L/sec,…
A: From the Lineweaver Burk plot the following information is given that is 1.91 sec/millimole and the…
Q: When determining CFUs for a dilution of the same sample at 10-2 and 10-3 which of the following…
A: CFU/mL means the number of colony forming units present per mL of the sample. In the above case, two…
Q: Question attached
A: Molality: The number of moles of solute per kilogram of solvent is defined as molality.Molality is…
Q: Name and strength for three pharmaceutical products that its specific gravity should be measured ?
A: Pharmaceutical product or drugs are the compounds that are used to prevent, treat, cure, or diagnose…
Q: . Determine the corrosion potential and corrosion rate of an iron pipe carrying 1N sulfuric acid at…
A: 12) Answer Corrosion rate can be found out using the formula CR=Icorr×k Ew/dA,…
Q: What is the dose in mSv for 2.5 mGy of neutron exposure to the eye?
A: Consider 0.1 Gy x-ray Find the dose in my by using the relationSv = Gyx RBE
Q: If the diameter of the low power field is 1.5 mm, an object that occupies approximately a 1/3 of…
A: At low magnification the working distance is relatively long. As the magnification increases the…
Q: What is the principle involved in the Dinitro salicylic (DNS) colorimetric method?
A: DNSA refers to 3, 5-dinitrosalicylic acid. It is an aromatic compound. It is widely used in…
Q: KCI for injection contains 40 mEq in 20 mL. An order requires 15 mEq, how many mL are needed?
A: KCI for injection is a drug which is used to treat patients with a deficiency of potassium. This…
Q: During transfer of liquids using a micropipette:
A: Micropipettes are used in laboratory to measure volumes less than 1000 uL or 1 mL.
Q: Given the following, calculate Gk: ENa = +45 mV; Ek = -85 mV; ECl = -60 mV; GNa = 5x10-8 S; GCl…
A: During rest (no signaling), the voltage difference across the membrane of the cells is referred to…
Q: what are the complications or the low-reliability in determining the value of KM using graphical…
A: Michalis-Menten equation was discovered in 1913 by Michalis and Menten. According to Michalis-Menten…
Q: What volume of a 40% v/v solution must be used to produce 500mL of 5% v/v solution?
A: The concentration of a drug is generally determined by the dilution of the drug. Various types of…
Q: Instruction: Convert the following and show your solution: 1. 10 um to nm 2. 100 um to mm 3. 0.1 m…
A: Here, the question is to convert units of measurement and staining methods.
Q: Compute for the CFU/ml of drinking water. Is this Passed or Failed based on the Philippine National…
A: Drinking water is the water that is used in drink or food preparation. The potable water is that…
Q: estimate of 8.78 for the microscopic ionization constant pKp. Given this information, what is the…
A: Given, pK1 = 7.57 pK2 = 9.30 pKD = 8.78 pK1 = -log(K1)K1 = 10-PK1K1 = 10-7.57 = 2.69×10-8 pK2…
Q: A1 gm sample containing CaCO3 was burned so that all C03 was released from the model. If the…
A: Total sample = 1gm Weight after firing = 0.560 gm Amount of calcium carbonate present in 1gm = 1-…
Q: Imagine you will use a centrifuge in the laboratory indicating rpm and your protocol requires…
A: Centrifuge Device: A centrifuge is a laboratory apparatus that separates fluids, gaseous or…
Q: Graphically derive the value of KM from a Michaelis-Menten Plot
A: Enzyme is basically biocatalyst that increase the rate of chemical reaction without itself being…
Q: Consider the titration of 50.00 mL of 0.160 M NH3 with 0.200 M HCl. Calculate the pH at the…
A: Titration of NH3 and HCL is of a weak base and strong acid titration. Weak acids and bases do not…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- 1.If a standard dose of your medication is 28mg/kg how much of your medication ingrams, would you give if your patient weighed 177 Ibs? 2.If one tablet contain 1125 mg and the patient consumed 4 tablets did they overdose orunder-dose and by what factor (how much?After administration of 150 mg drug A in an oral tablet dosageform, the AUC was calculated to be 143.3 mg•hr/L. Afteradministration of 85 mg drug A in an IV injection dosage form,the calculated AUC was 208.6 mg•hr/L. What is the absolutebioavailability of drug A in the oral tablet dosage form? A. 39%B. 56%C. 69%D. 256%1. A prescription calls for 50 mg of chlorpheniramine maleate. Using a prescription balance with a sensitivity requirement of 6 mg, explain how you would obtain the required amount of chlorpheniramine maleate with an error not greater than 5%.
- 1. compute for patient B result of his chloride analysis with the following data using mg/dL unit factor: 355/ mg/dL , Absorbance sample = 0.2148, Absorbance standard = 0.3017 a. 24.8 mg/L b. 25.27 mg/dL c. 2.7119 mmol/L d. 252.7 mg/dL 2. an adult patient suffering from debilitation is supected of calcium deficiency. His doctor requested for calcium anaylusis with the following data gathered standard known value is B: Absorabance is 0.2876. sample absorbance is 0.4291 compute for the calcium in mmol/L a. 53.6mmol/L b. 5.36 mmol/L c. 11.9 mmol/L d. 119mmol/L 3. calculate the value of sodium where the PREC solution has diclored. data gathered are the following: Absorbance of Reagent Blank = 0.3124 Absorbance of sample = 0.114, Absorbance of standard = 0.275 value is 150mmol/L a. 108.2 mmol/L b. 170.4 mmol/L c. 795.72 mmol/L d. 79.5 mmol/L1. How many ml of amoxicillin will you add to your mini bag? 2. Calculate drip rate per minute for the minibag in gtts/min? 3. How many doses of amoxicillin will you get from the 10ml vial? Will you have enough amoxicillin to last 48 hours?Rp Dextrose hydrous 50.0 g Sodium Chloride 9.0 g Calcium Chloride 0.3 g WFI (Water for injection) qs… 1 L Calcium Chloride MW: 111; Sodium Chloride MW: 58.5; Dextrose MW: 198 a. Please calculate how many mOsmol/L is the above LVP solution? b. How many mOsm/L Ca++ and Na+ contain the above solution? c. What is the above LVP solution tonicity?
- Would it be more difficult to meet a 70 ppb one hour averaged standard or 70 ppb 8-hr averaged standard and why?Explain the reason for each of the following rules regarding micropipettes. a) Always set the micropipette within its designated range. b) Always use a micropipette with a tip. c) Always hold a loaded micropipette in a vertical position. d) Always release the micropipette plunger slowly.1. What volume of diltiazem HCl will you add? 2. Do you need to remove any of the 0.9% NS to account for the added volume of the diltiazem? 3. Assuming that the rate does not change, how long will this bag last for?
- Give paracetamol 100 mg IV every 4 hours for temperatture 38.5 celcius and above. How many ml will you administer?During transfer of liquids using a micropipette: What would it mean if the mean is very close to the expected value but your standard deviation is high ?1. The standard curve was prepared using BSA as a standard with a concentration of (2.0 mg/ml, 1ml). Fill in the table below and show the calculations for determining the final BSA concentration in each vial. Formula C1V1=C2V2
