Calculate the pressure at a point 349 mm below the surface of the mercury in a vessel. Express the answer in Pascal.
Q: For the beam shown, calculate the magnitude of the bending stress (in psi) at the bottom of the beam…
A:
Q: A A = 900 mm² P₁ 500 mm A = 2000 mm² P₂ B +250 mm + FIG. P2.59 A = 1200 mm² с D -350 mm →
A:
Q: PROBLEM 7 Determine the coordinates of the centroid of the shape given below. y 0.8 m 0.6 m 1.0 m X
A:
Q: S 0 Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter,…
A:
Q: A 400 mm square column carries a dead load (Gk) of 1050 kN and imposed load (Qk) of 300 kN. The safe…
A: Answer We are given Foundation Load Dead Load Gk = 1105 KN Live load Qk = 260 KN Column Load Dead…
Q: 4-5 t Q7:- Find I.L. (BG-), Then compute be developed (GH) for along the bottom bottom cord B D C₂ F…
A:
Q: It is desired to pump 390 liters per second of water from a stream to a pool as shown in the figure…
A: Q = 390L/s = 0.39m3/s
Q: 5 A single axial load of magnitude P = 15 kips is applied at end C of the steel rod ABC. Knowing…
A:
Q: Why the bearing capacity of soil reduces when the groundwater table rises up to the ground surface?…
A:
Q: Determine the foreces in the members marked by “x” in the truss loaded as shown at the right. Use…
A: This question is related to the structure analysis.
Q: Q2: Determine the state of stresses at point A on the cross section of the pipe shown in Fig. D=50mm…
A:
Q: For the retaining wall below, determine the total active force per unit length of wall using Rankine…
A: Given data in question Angle of internal friction Height Sand Unit weight To find out Total…
Q: The reinforced concrete beam shown has a width of 380 mm and a total depth of 580 mm. It is loaded…
A:
Q: Determine the deflection at C and the slope of the beam at A, B and C using Area-Moment Method. EI…
A: Determination of deflection at A and slope at A,B,C using Area Moment Method####
Q: Design the steel reinforcement for short column(400x600mm) under the load Pu=1500KN use d-500mm&…
A: As per Bartleby's guidelines we are supposed to answer only first question. Kindly repost other…
Q: Sec.: C rce and bending moment diagram for the beam sh bending moment. Notice that, at point (D)…
A:
Q: Determine the support 1201b/ft A reactions -4'- 6¹
A:
Q: Consider the application of a material as a bed frame. which among the following materials is the…
A:
Q: 120 kN/ (1) Sm E
A:
Q: Determine the 5-day BOD (in mg/L) for a 15 ml sample that is diluted with dilution water to a total…
A:
Q: Q.2- Answer with true and false, and correct false statements. EVENTE U from the int increasin. 3-…
A: Part 4 Minimum concrete cover thickness depends on the exposure environmental conditions and…
Q: SYSTEMATIC ERRORS IN TAPING + TAPE IS NOT OF STANDARD LENGTH A building 38 × 45 m is to be laid out…
A:
Q: 100KN 20 kN/m 1 If 4m 2m 5m t 20 KN 1.5m
A:
Q: 1. A soil has an average soil moisture content of 36.5% at field capacity and 13.5 % at permanent…
A: Given, FC = 36.5% PWP = 13.5% γb = 1.6 g/cm3
Q: 1. Determine the magnitude and type of force in each member of the truss shown by the method of…
A: Determine the magnitude and type of force in each member of the truss shown by the method of joints.
Q: What is the maximum diameter of aggregate in cm?
A: This question is related to the Design concrete structures.
Q: (3) Find the deflection at point B of the uniformly distributed simply supported beam shown in Fig.…
A:
Q: 3. A 16 mm steel bar AB and a 25 mm steel bar BC support a load P = 7,500 N as shown. If E = 200…
A:
Q: SHOW THE PROCESS Solve the structures shown using the Moment Distribution Method. After that,…
A: Solution: Moment Distribution method: Fixed unit moment: Span AB: MFAB=-wl230=-800×16230=-6826.6…
Q: Required information The rotating-cylinder viscometer in the image shears the fluid in a narrow…
A: Given:- The rotating-cylinder viscometer shears the fluid in narrow clearance ∆r The magnitude of…
Q: A Marshall specimen is prepared for bituminous concrete with a bitumen content of 5 percent by…
A:
Q: Required information When a person ice-skates, the ice surface actually melts beneath the blades so…
A: Friction force Friction is the resistance to movement that occurs when two surfaces glide or roll…
Q: Question 1 A concrete column 1500mm high is reinforced with 5 steel bars as shown in Figure 1. A…
A:
Q: In a city, the population to be served: 78,320 and per capita waste generation is 0.85 kg/capita/day…
A:
Q: Determine the deflection at C and the slope o ant. A
A:
Q: It is also required to specify terminology such as "repository, modeling tool, documentation…
A: Answer Repository- Repository is a place, room, or container where something is deposited or stored…
Q: Q1/ Draw the distribution of the effective stress for section A-A in the following soil profile: A…
A: Given, Soil profile diagram Load = 150 kN
Q: For a wet season, estimates wastewater flows per hour for a community has two zones, residences and…
A: Waste water Rainwater runoff and human activities produce wastewater, which is a contaminated form…
Q: The design of a city water supply is shown below. Pipe 1 is 300 mm diameter and 900 m long, Pipe 2…
A:
Q: Q2/ Determine the consolidation settlement for the foundation shown in the figure below. The soil…
A: Assume pressure distribution to be 1H:1V So, n = 1 For Clay 1 γsat1 = (G+e)γw1+e or, 18 = (2.65 + e…
Q: For the beam and loading shown, determine the slope and deflection at the free end. The…
A: beam arrangement is given as shown in the figure above and it has been asked in the question to…
Q: H.W 4 A simple beam on a 10 ft span supports a uniform load of intensity 800 lb/ft (see figure). The…
A:
Q: A water tower supplies water through the plumbing in a house. A 2.40-cm-diameter faucet in the house…
A:
Q: For the beam and loading shown, determine the slope and deflection at the free end. The…
A:
Q: A W m B T n C
A:
Q: A rectangular suppressed weir of length 1 m is constructed or cut at the top of a tall rectangular…
A:
Q: 20 kN N/m m * 15 kN/m 4 m R₂ 10mm Bean
A:
Q: 3. A pump draws water at 300 liters per second from reservoir A and lifts it to reservoir B as…
A: The given data is shown below: Q=300lpsEfficiency=80%
Q: Mother is a proper noun -1 True O False O Jalal is a common noun -2 True O False O Faten is a common…
A: 1. Answer:- True Explaination:- Actually the word mother is the common noun but it will becomes to a…
Q: A printing machine is to be installed at a cost of 38000 in a press. Assuming the life of the…
A: given cost of machine S=38,000life n=25 yearscompound interest i=5%salvage value=3500
Step by step
Solved in 2 steps with 1 images
- SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?An astronaut has a mass of 68 kg. What is the weight of the astronaut on Earth at sea level? What are the mass and the weight of the astronaut on the Moon, and on Mars? What is the ratio of the pressure exerted by the astronauts shoe on Earth to Mars?If the pressure in a tank is 319 kPa, find the equivalent pressure head (in meters) of a liquid having a specific gravity equal to 5.807. Round off to three decimal places.
- If a pressure gauge on a compressed air tank reads 120 atm, assuming standard atmospheric pressure at sea level, what is the absolute pressure of air ina. mm Hgb. pascalc. meters of waterd. centimeters of mercuryIf the pressure in a tank of oil (sp.gr.=0.80) is 400 kPa, what is the equivalent head in meters of oil?If local atmospheric pressure is 755 mm of mercury, calculate (i) the absolute pressure of air in the tank, and (ii) pressure reading at A (Figure 3).
- What is the absolute pressure inside the tank after it was submerged in a liquid if the volume of the air inside decreased by 25%? Atmospheric pressure = 101.325 kPa 135.100 kPa 145.778 kPa 152.353 kPa 141.638 kPa1. If the pressure in a tank of oil (s = 0.80) is 60 lb per sq.in., what is the equivalent head: (a) in feet of the oil; (b) in feet of water; (c) in inches of mercury?The figure below shows a closed tank that contains gasoline floating on water. Calculate the air pressure above the gasoline. The container is vented to the local atmosphere. What is the absolute pressure at the surface of the mercury and at the bottom of the container (kPa)? Assume the conditions of the standard atmosphere prevail for pressure. Use sg = 13.54 for the mercury
- 3. Situation 1 - The pressure on a closed tank reads 58.86 kPa. What is the equivalent height, in meters, in terms of mercury? Round off to three decimal places.Determine the pressure difference between points A and B in kPa. Given Specific Gravities: Benzene = 0.88 Kerosene = 0.80 Mercury = 13.6 Water = 1 Air = 0.0012What is the pressure of the air in the tank if z = 40 cm, y =100 cm, and x = 80 cm?