Answered: Calculate the pressure due to a column…

Calculate the pressure due to a column of 5.0m of (a) water, (b) mercury of sp. gr. 13.5, and (c) an oil of sp. gr. 0.8. Take density of water =1000 kg/m3.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: 10. How far below the water surface is it necessary to immerse a vertical plane surface, 1m square,…

A: The Centre of pressure is defined as the point of application of the total pressure on the surface…

Q: Compute the pressure @ point n ( Pn ) as shown by the differential manometer in KPa if pressure @…

Q: Compute the height of oil column if density of oil is 900 km/m3, density of water is 1000 kg/m3 and…

A: Given density -> oil -> Po = 900 kgm3 (Assuming B above point A )water-> Pw =…

Q: A barge is 15 ft wide and 40 ft long and fl oats with a draftof 4 ft. It is piled so high with…

A: Given data as per question Width of barge = 15 ft Length of barge= 40 ft Draft = 4ft let M is…

Q: Compute the value of pressure at depth of 12.16 m from top of water

A: Given:depth, h=12.16 m

Q: If the piston and water (p = 62.4 Ibm/ft) are accelerated upward at a rate of 0.4g, what will be the…

A: Given dataa=0.4gρ=62.4 lbmft3Z=2ftTo find pressure

Q: Find height of water column corresponding to pressure of 70 KN/m2

A: Given data, P=70KN/m² =70000 N/m² Let the density of water d=1000 kg/ m³

Q: Determine the height of an oil column of specific gravity 0.8 in 1) meter of Hg 2) in meter of oil…

Q: For the compound manometer shown, calculate the pressure at point A.

Q: A circular tank of diameter 1.25 m contains water up to a height of Sm. An orifice of 50mm diameter…

A: Given: The diameter of the tank is d=1.25 m. The height of the water initially is h1=5 m. The…

Q: Find height of water column corresponding to pressure of 66 KN/m2

A: To determine the height of water column.

Q: A hollow steel tube (diameter = 4.14 cm) is sealed at one end and loaded with lead shot to give a…

A: From the buoyancy, the weigh of volume of water displaced will be same as the weight of the steel…

Q: An oil drum of 500 mm diameter and 1.5 long is to be rolled across a footstep of 100 mm high. Find…

A: Determine the net quantity of mass inside the cylinder. Now substitute the required value in the…

Q: An oil drop with the diameter of 1mm, is in the contact with the air with the pressure of 80 KN/m2.

A: The given values are - d=1mm , Patm=80 kNm2The surface tension of oil-air is generally taken as-…

Q: A vessel, cylindrical in shape and closed at the top and bottom, contains water upto a height of 700…

Q: Calculate the pressure at the bottom of the ball-shaped tank, 3.4 cm in diameter, filled with peanut…

A: Given: The diameter of the tank is D=3.4 cm. The specific gravity of the peanut oil is SG=0.92. The…

Q: Compute the pressure at depth of 0.99 m from free surface of water

A: GIVEN DATA- Water is given as fluid we have to find pressure at depth of 0.99m from free surface

Q: Determine the height of an oil column of specific grav 0.8 in meter of Hg 2) in meter of oil column…

A: Here, p=25 kPa, S01.8i.e. ρoil=ρ0=ρwS0=1000×=8000 kg/m3

Q: [Stability] A 10-cm by 10-cm wood (sg = 0.65) with a length of 2 m is placed in water. Determine the…

A: Given data cross-section dimension of wood is 10 cm*10cm the specific gravity of wood (S.G) = 0.65…

Q: formulas, clear

Q: Newfound lake, a fresh water lake near Bris has a maximum depth of 60 m, and the mea pressure is 91…

A: given:depth of lake h=60matmospheric pressure p=91kpa

Q: d, is fitted to the outlet pipe of a pump with diameter D. Let h; be the height of the section 0-0…

Q: Calculate the height of a column of water equivalent to atmospheric pressure of 1.02bar if the water…

Q: Q (1);-From sece-level find the T,P.p,a.u at 16 km? Q (2);- Two ofih

A: Solution: Air properties changes as the elevation from the sea level changes.

Q: two for ces of magnitude p and zp ad is then thero minimum reseltent body on a

Q: Problem 2 Hinge A stop-block on the edge of the gate at B will break whenever the force reaches…

Q: Find height of water column corresponding to pressure of 40 KN/m2

A: Given data, Pressure is 40 kN/m² Let the density d=1000 kg/m³

Q: If a cylindrical hydrometer of 40 gm is immersed in a fluid with a specific gravity of S-0.68for a…

A: Given: The mass of cylinder hydrometer, m = 40 gm The specific gravity of fluid, S = 0.68 The depth…

Q: Diagram of the problem, necessary formulas, clearance and numerical solution Calculate the pressure…

Q: A CLOSED RECTANGULAR TANK 4m LONG, 2m WIDE AND 2m H16H iS FILLED WITH WATER A DEPTH OF 1.8m. IF THE…

A: Given:- Rectangular tank=L×B×H=4×2×2 Water-filled Hwater=1.8m Force on a rear wall, F=200kN=200,000N…

Q: The upper edge of a vertical trapezoidal gate is 1.60m long and flush with the water surface. The…

A: Given Length = 1.6 m Vertical edge 2 m, 3m To find Location of force Pressure of force

Q: Compute the pressure at depth g 5.33 1m from free surface of water.

A: Given data : Depth=d Acceleration due to gravity=g Density of water=ρ Required : Pressure

Q: Discussion: 1-The thrust force increases with increasing depth of immersion, and the relationship…

A: Hydrostatics Law: According to Hydrostatics Law, the pressure in a vertically downward direction in…

Q: , find height

A: Given; Pressure of gas bulb A is , 50 cm of HGAtmospheric pressure =46 cm of HG

Q: Calculate the pressure due to column of 0.4 m of mercury(s=13.6). Take density of water = 1000…

Q: An open cylindrical tank 3ft in diameter and 5ft high contains 3ft of water. If the tank is rotated…

Q: An oil drop with the diameter of 1mm, is in the contact with the air with the pressure of 80 KN/m2.…

A: Basics of Fluid mechanics are used.

Q: 5. The gas used in a gas engine trial was tested. The pressure of gas supply is 10cm of water…

Q: 3.106 A sphere of radius 25 mm, made from material of specific gravity of SG= 095, is sub merged in…

A: Given data radius of sphere R = 25mm = 0.025m Specific gravity of material SG = 0.95 Radius of the…

Q: Explain the use and limitations of manometers. Then suggest two points for using welltype manometer…

A: Manometer is an instrument used to measure the pressure of the fluid flowing through a pipe.…

Q: A cylindrical platform of diameter of 2.82 m and height 4.1 m floats in saline water (density = 1026…

A: Given Calculated e) as 17293.23kg and f) as 675.65kg/m3 Need help with g), h) and i)

Q: B) A rectangular gate (length 3m, wide 1m) inclined at 50⁰ with the horizontal level and hinged at…

A: Length of the gate, L==3 mWidth of the gate, w=1 mInclination angle between the gate and horizontal…

Q: Problem 2 Hinge A stop-block on the edge of the gate at B will break whenever the force reaches…

Q: Calculate the weight of 10 kg block, when it is fulley submerged into the water?

A: Given:Mass of block,m=10KgSo,Weight of block,W=(10×9.81)N⇒W=98.1NWe know:Density of water,ρ=1000Kgm3

Q: an oil drum of 500 mm diameter and 1.5 long is to be rolled across a footstep of 100 mm high.find…

A: Given Data: The diameter of the drum is, d=500 mm. The length of the rod is, l=1.5 m. The height of…

Q: How the problems involving Manometer being solved? Explain and discuss

Q: A cylinder of radius 0.5m and height 4m is rotated at 10 rad/s about its vertical axis. If the…

Question

Calculate the pressure due to a column of 5.0m of (a) water, (b) mercury of sp. gr. 13.5,
and (c) an oil of sp. gr. 0.8. Take density of water =1000 kg/m3.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Calculate the pressure of an oil of sp.gr. 0.8, and a mercury of sp.gr. 13.6 in N/cm3. Take density of water, ρ = 1,000 kg/cu.m
At what depth below the surface of the oil, relative density 0.8 will produce a pressure of 120 kN/m2. What depth of water is this equivalent to?
Calculate the pressure due to column of 0.4 m of mercury(s=13.6). Take density of water = 1000 kg/m^3.
A drum of height h and area A, standing and open to the atmosphere at its top, is filled with water. Assume that at the bottom of the mantle, a hole of cross-sectional area a is drilled. How long will it take for the drum to empty?
an oil drum of 500 mm diameter and 1.5 long is to be rolled across a footstep of 100 mm high.find the minimum push required at the top of the drum.take density of the oil as 1kg/litre.neglect weight of the drum.
The specific gravity of Hg is 13.6 and the specific gravity of glycerin is 1.26. Forthe manometer shown, calculate the difference in pressure between points A and B
An oil drum of 500 mm diameter and 1.5 long is to be rolled across a footstep of 100 mm high. Find the minimum push required at the top of the drum. Take density of the oil as 1 kg/litre. Neglect weight of the drum.
A solid wood cylinder of specific gravity 0.6 is 600 mm indiameter and 1200 mm high. If placed vertically in oil with SG of0.85, would it be stable?
Calculate the specific gravity of mater having a mass of 8.35x10-³ kg which displace 0.25 mL when immersed in water.
Diagram of the problem, necessary formulas, clearance and numerical solution Calculate the hydrostatic pressure experienced by an Olympic swimmer at the bottom of a pool 5 m deep.
Compute the height of oil column if density of oil is 900 km/m3, density of water is 1000 kg/m3 and the difference in levels between points A and B of 10 cm.
pressurea are sometimes determined by measuring the height of a column of liquid in a vertical tube, what diameter clean glass tubing is required so that the rise of the water at 20°C in a tube due to capillary action (as opposed to pressure in tube) is less than h=1.0mm