Question

Calculate the total air required to oxidize 200g of solid waste if the chemical composition 

= C12H32O8 

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Civil Engineering

Environmental Science

Related Civil Engineering Q&A

Find answers to questions asked by students like you.

Q: Please answer question asap

A: Click to see the answer

Q: Load Combinations The following table contains the results of several analyses for the reaction at t...

A: Data given: Asked: Largest compressive force Largest tensile/uplift force What is the worst shear/...

Q: solve this

A: Calculate the moment of inertia of the given figure about its NA: Calculate the location of CG from...

Q: From the given profile leveling notes, what is the difference in elevation between station 5 and 2? ...

A: Given: The leveling notes are given below, Station BS FS IFS Elevation BM1 0.95 ...

Q: Solve for x

A: Given: X2+1<34+5X

Q: A line has a magnetic bearing of S 41° 30’E when the declination was 1° 30’E. what is the true bea...

A: Data given: Magnetic bearing = S41°30'E Declination = 1°30'E Asked: True bearing of the line if a lo...

Q: 1-2 Determine the equations for slope and deflection of the beam shown by the direct integration met...

A: Consider the free body diagram of the beam shown below. Consider the equilibrium moment about point...

Q: The vertical bar is cantilevered to the floor asshown. Determine the moment of the loadsat B.

A: In trapezoid ABCD has a UVL so for converting UVL into point load, Here a = 500 ,b = 1300 and h= 1.8...

Q: A new construction site requires 1500 m3 of moist compacted soils. The design specification of the f...

A: Click to see the answer

Q: Covernt from English to Metric Units. Your final answer should be in Metric Units. Write your step b...

A: Click to see the answer

Q: please answer the question given

A: VA = 5t1/2 m/s To find acceleration at x = 0.3 m and t = 1 s

Q: What error results on a 200-ft sight with a level if the rod reading is 5.815 ft but the top of the ...

A: Given data: The line of sight is L=200 ft. The rod reading is s=5.815 ft. The total height of rod is...

Q: Covernt from English to Metric Units and Draw FBD. Write your step by step solutions.

A: Data given: Asked: Determine the internal normal force, shear force and bending moment act at poin...

Q: If the reaction rate coefficient of BOD is 0.3 1/d at 20 oC, what will it be if the temperature is d...

A: Click to see the answer

Q: Determine the centroid ( x and y [this is x bar and y bar] ). If the centroid is at the line of symm...

A: The given figure is shown below:

Q: 225. Determine the forces in members IH, AH, and BC of the truss. State if the members are in tensio...

A: Consider the figure,

Q: Refer to Figure 8.23. Given: • H, = 6 m • H, = 1.5 m Draw a flow net. Calculate the seepage loss per...

A: Click to see the answer

Q: We want to construct the truss structure shown in Fig. 2. The structure has been designed to carry a...

A: Solution-

Q: lonic solutes typically dissolve in nonpolar solvents. True False

A: Following is the given statement: Ionic solutes typically dissolve in nonpolar solvents. The stateme...

Q: Please solve fast!

A: Given: Original length of rod, l = 300 mm Tensile stress, σ = 500 MPa Modulus of Elasticity, E = 200...

Q: Solve for x 5-5x>7x+16

A: Given: 5-5x>7x+16  

Q: Adjust the given traverse busing the Transit Rule.  Express all values up to 3 decimal places if gre...

A: Data given: Line Distance Latitude Departure KL 55 18.057 -51.951 LM 48 19.651 43.793 MN 36...

Q: (c). The magnitude of stresses have been applied on soil element where Normal vertical stress is 120...

A: Normal stresses are given and we have to find the stresses on the inclined plane given in question w...

Q: Please solve. Handwritten solution is also fine.

A: Given: Original length of rod, l = 300 mm Tensile stress, σ = 500 MPa Modulus of Elasticity, E = 200...

Q: Problem 2: Classify the following soils using USCS Sieve analysis- Percent finer Soil No. 4 Na. 200 ...

A: Data given: Asked: Classification of soil as per USCS and AASHTO  

Q: The bell crank, which is in equilibrium under the forces shown in the figure, is supported by a 25-m...

A: Given: The diameter of the pin is 25 mm. The thickness of the pin is 30 mm. The tensile working stre...

Q: A 51° 126° 15° 5.0000 B

A: From above figure, From opposite angle, we get,  ∠b = ∠a = 15° From alternate angle, we get, ∠ c = ∠...

Q: Briefly describe the slope-area method of discharge estimation and list its advantages and disadvant...

A: 1)When it is not possible to make direct measurement especially during floods, slope-area method is ...

Q: Table Ps.7 mcafue S22.4 523.4 wet mars Gl 52 1.6 491.7 492.1 491,6 Ory mus 6) Absurb ptur "% 2.4 215...

A: Water Content  is the ratio of mass of water in soil to that of dry mass of soil It is denoted by w...

Q: A Bar JK uniformly weighing 34 kN ln is being supported by Strut MN and a hinge at J Consider these ...

A: Click to see the answer

Q: Q#2: (a). What is consolidation? Explain the concept of NCR and OCR with examples [in your own words...

A: Consolidation and the concept of NCR and OCR are explained in the next step. 

Q: 1. A groundwater contains the following constituents: CO2 = 9.6 mg/L Ca2+ = 95.2 mg/L Mg2+ = 25.8 mg...

A: The dosage of lime can be calculated as: Now, it has been assumed that the lime is 90% CaO by weig...

Q: Find the 2nd derivative of y=x(2x+1)3

A: Click to see the answer

Q: It is proposed to add activated carbon to treat a storm stream with a pollutant concentration of 5.1...

A: Given: The influent concentration is 5.1 mg/L. The mass of activated carbon is 22 kg. The equilibriu...

Q: At what angle must the 800-N force be applied in order that the resultant of the two forces has a ma...

A: Consider the figure,

Q: Please use Mohr's Circle.

A: Principal stresses = σ1, σ2 

Q: A lagoon with volume 1200 m^3 has been receiving a steady flow of a conservative waste at the rate o...

A: Given data: Volume (V) = 1200 m3 Rarte of the waste (Qi ) = 100 m3/day Concentration starting (C) = ...

Q: (See Attached picture of truss) 2.  Since  the reaction force at point A is 8975 #, The reaction for...

A: Given Data: The reaction force at point A is RA=8975 lbs. The reaction force at point H is RH=7625 l...

Q: Define different types of stresses, strains and material constants

A:  

Q: The moist weight of 4050cc of soil is 8.277kg. If the moisture content is 17% and the specific gravi...

A: Click to see the answer