i need answer clerly Required Equipmem.-1- NE – 5552- Сараcitor 0.047uГ.4- D.C powersupply.R, + R,R, +2R,Duty Cycle =k =1.44f(R, + 2R2)* C etVccRIDischarge ·784R2O/PControl356ThresholdTrigger2C estRstCalculation:-1- Calculate theoretically the duty cycle & frequency of the circuit.2- Compare between the theoretical and excremental value offrequency and duty cycle.

The circuit diagram is shown below, where,The value of capacitor and resistors…

Answered: Calculation:- 1- Calculate…

Calculation:- 1- Calculate theoretically the duty cycle & frequency of the circuit. 2- Compare between the theoretical and excremental value of frequency and duty cycle.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. If the voltage…

A: given voltage across string unit=17.5kv no of insulator=3 shunt capacitance 1/10 th of the…

Q: Q1(6*1)/For the circuit shown in the figure below, using nodal analysis to find:

A: The solution can be achieved as follows.

Q: Each line of a three phase system is suspended by a string of three similar insulators. If the…

Q: Give an example of a power system with 4 shins(bus bar) and perform the following calculations on…

A: Bus bar is a basically a conductor which is made up of aluminum or copper. If there is large amount…

Q: What is load line and what is duty cycle?

Q: a) Define the meaning of the balanced three phase system.

A: 3 phase system means the power system which has 3 phases here generally considered by R B Y or a b c…

Q: Q1(6*1)/For the circuit shown in the figure :below, using nodal analysis to find

A: Given circuit-

Q: 5.Write the Overhead Transmission Voltages used in Sultanate of Oman.

A: To describe the overhead transmission line

Q: Determine the frequency and duty cycle

Q: Discuss the results of Waste Electrical and Electronic Equipment (WPRS)

A: when electrical and electronic equipment is not in use or broken and kept in a storage facility for…

Q: Explain the reliability of power supply in the distribution system. Justify your answer with real…

A: Reliability denotes the ability of a distributed system to deliver its services even when one or…

Q: For the network Determine re-

A: From the circuit, the value of the dc base current (IB) can be computed in the following way: From…

Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. If the voltage…

A: The solution can be achieved as follows.

Q: please write introduction about Analysis of 3 Phase star connected circuit Note:please write details…

Q: (ii) tränsmission efficiency *. Estimate the distance over which a Joad of 15000 kW at 0-85 n f can…

Q: In fault analysis the resistance of the power system network components is neglected and the…

A: Given In fault condition we neglect resistances True or false

Q: The value of value of voltage measured in residential convenience outlet is average voltage. True…

A: Average value is the average of the signal over the period of time. Where as rms value of the signal…

Q: Determine the instantaneous voltage utilizing component from voltages given.

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square…

Q: (c) Oman distribution companies charges for electricity using which type of tariff and list the…

A: Oman distribution companies charges for electricity using cost reflective tariff. Cost reflective…

Q: (a) Based on the relationship between the line and phase value of currents and voltage, show that…

Q: Q10/ For the network of Figure below, determine:

A: Given Data: hfe = 120 hie = 1.175 kohm hoe = 20 uA/ Rb = 330 kohm

Q: What is mean by duty cycle

Q: the power factor and transmission efficiency to be the same in the two cases. B) Give a reasonable…

A: Given We need to enumerate few questions based on feeder and transmission design. Please find the…

Q: Mention 3 disadvantages of renewable energy source.

A: In this question we need to mention 3 disadvantages of renewable energy source.

Q: rminal network to be im ng impedance and voltage nstrate with diagrams

A: The Thevenin's theorem states that a linear and bidirectional two terminal networks can be replaced…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square…

Q: What is GMD in power system, explain in breif.

A: GMD is defined as the geometrical mean distance, it is used for calculating the capacitance and the…

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-875…

Q: a) Find the IBC load current. b) Give the Vca line voltage

A: Find the IBC load current. b) Give the Vca line voltage.

Q: In class B chopper, which of the given statement is true The power flows always from load to source…

A: The power flows always from load to source

Q: The base current and base voltage of a 345 kV system are chosen to be 3000A and 300kV respectively.…

A: The solution is given below

Q: Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.

A: Ring DC distribution system: It is the system for distributing the power. In this system, the first…

Q: With a sketch of block diagram, describe the importance of smart grid in modern electric power…

A: Smart power grid integrate the various renewable energy resources such as wind farm,hydro electric…

Q: Use nodal analysis for the circuit

A: In this question, Use the nodal analysis, find the all unknown currents. Here depended and…

Q: / Plot the blocking voltage of the SCR at ?=0o for three-phase HWR. What is the value of PIV?

Q: Enlist the power quality issues for renewable energy integration

A: Renewable energy is also called green energy because it is generated from Energy resources which are…

Q: If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line…

A: Given values are - VS=20kVVR=15kVδ=20oX=5Ohm

Q: 122MbB =???b

Q: Question - Analyse the operating principles, and environmental impact of, existing and advanced…

Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. If the voltage…

A: The solution can be achieved as follows.

Q: 1. Explain the reasons for the low power factor in the power system network.

A: In power system, power factor become low only because of the use of highly inductive or capacitive…

Q: Suggest remedial measures to a facility manager who complains of low voltage at his facility.

A: The main causes for the low voltages are, Overloading the network Loose connection Wrong size of…

Q: In relation to ”smart grid”, discuss the attributes that make the grid smart.

A: The solution is given below

Q: A three phase transmission line to line capacitive reactance value is 12 ohms. If the charging…

A: It is given that: XC=12 ΩIC (per phase)=37 A

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-875…

A: Single phase transmission line, Cross section area a=0.875 cm2 P=220 kW V=3500 V cos ϕ=1Efficiency…

Concept explainers

Star Delta Conversion

Find the input resistance between points A and B of the following resistive network:

Question

i need answer clerly

Required Equipmem.-
1- NE – 555
2- Сараcitor 0.047uГ.
4- D.C power
supply.
R, + R,
R, +2R,
Duty Cycle =k =
1.44
f
(R, + 2R2)* C et
Vcc
RI
Discharge ·
7
8
4
R2
O/P
Control
3
5
6
Threshold
Trigger
2
C est
Rst
Calculation:-
1- Calculate theoretically the duty cycle & frequency of the circuit.
2- Compare between the theoretical and excremental value of
frequency and duty cycle.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

DEGREE: ELECTRICAL ENGINEERING SUBJECT/COURSE: AC CIRCUITS NOTE: Please solve in this way. 1. Please have a good handwriting, some of the answers are not readable. Thank you! 2. GIVEN.(include symbols and units) 3. REQUIRED/FIND/MISSING (with symbol/s) 4. ILLUSTRATION (Required). 5. STEP-by-STEP SOLUTION with Formulas and Symbols. No Shortcut, No skipping, and detailed as possible 6. FINAL ANSWERS must be rounded up to three decimal places PROBLEM: • A delta-connected load whose phase impedances are ZAB=50 Ω, ZBc=-j50 Ω, and ZcA=j50Ω is fed by a balanced wye-connected three phase source with Vp=100 V. Find the phase currents.
Explain in your own words and your own understanding (avoid plagiarism) why there's a need to do Power Factor Correction or Improvement in an Electrical Power System.
apply the P Petrick’s method to find the minimum SOP solutions for below question. f(a,b,c,d) = ...
Hi, pls help me answer the questions in this problem. Need it asap. Thank you so much.
Please answer ASAP for like this please Asap for like this please... Please
18. Why are signals that are in quadrature said to be orthogonal?A. They do not interfere with each other.B. They split into two paths. C. They can shift to one of two predetermined phase states.4D. The amount of data that can be transmitted over time
please solve all question 1.1) Calculate Vpk and Vpk-pk for 6 VRMS 1.2)Calculate Vpk and VRMS for 14.1414 Vpk-pk 1.3)Calculate Vpk-pk and VRMS for 20 Vpk 1.4)Calculate the time period for (a) 50Hz (b) 1kHz (c) 20kHz 1.5)Calculate the frequency for time period (a) 20mSec (b) 100uSec (c) 2 Sec
Using nodal analysis, demonstrate that I1 is equal to 0.7781∠(-161.9°) A for the circuit given.
ASAP ASAP ASAP previous answer is wrong
Please solve max in 30 minutes thank u Get system frequency response (?Ω)
WILL SURELY GIVE AN UPVOTETOPIC: AC MACHINE INSTRUCTIONS Please write clearly and understandable wayWrite all the corresponding Given with their corresponding symbols and unitsSolve in step-by-step, no shortcut (I need to learn as a beginner)Underline twice the Final Answer PROBLEM:Two transformers, each rated at 100 KVA, 11000 V/2300 V, 60 Hz, are connected in open delta on primary and secondary sides. A 120-KVA, 2300-V, 0.866-lagging-power-factor, three-phase, delta-connected load is connected to the transformer bank. What is the line current on the high-voltage side?a. 3.3 Ab. 6.3 Ac. 9.3 Ad. 1.3 A
explain plz, no ai