Can a graduate in civil engineering course sign plans and supervise construction projects, even though he/she did not pass the board exam? Explain.

Q: Solve using cantilever method

A:

Q: The locating engineer a railroad curve runs a 6⁰ curve to the PCC, 250m long from the PC of the…

A: A railroad curve is given, IT has been asked in the question to determine the length of chord…

Q: Question 6: Can the coefficient of restitution be equal to 1 in reality? Write 1-2 sentences to…

A: Factual based question is asked, please refer step 2 for detailed explanation and solution.

Q: 10 N 10 N 20 N E M 10N B 6.0m 4.0m L 8 BAYS @ 3.0 m EACH 20 N - The force at member IK is equal to O…

A:

Q: The bell crank, which is in equilibrium under the forces shown in the figure, is supported by a…

A: step 1-

Q: Question 1: A girl and her 40kg dog are out walking one summer day when they come to a road they…

A:

Q: A simple circular curve connects two straights (AB & BC) intersected at point B, Station 2+000. If…

A:

Q: 3- In the seams, it is preferable to use a weaker mortar than that used for tying bricks

A: Mortar- It is a construction material. It is used to bind bricks, stones, etc and for plastering the…

Q: 80KN 200mm 80mm 80mm 120mm

A:

Q: Geotechnical Engineering How important Atterberg Limits?

A: Introduction: Atterberg limits are the methods to measure the water contents in the soil. It is also…

Q: 80 kN 6 m 40 kN 6 m B -10 m 10 m

A:

Q: Water that flows freely downward through voids between soil particles is called: A gravitational…

A:

Q: The given girder has beams framing into it at the ends and at every L/3 point. The beam carries a…

A: A beam is a structural element that is predominantly subjected to transverse loads with minor axial…

Q: Given: 110°26’48” 105°55’04” 113°15’34” 100°35’24” 109°47’20” misclosure = 10" correction = 2"…

A: Solution Interior angles: 110°26’48” 105°55’04” 113°15’34” 100°35’24” 109°47’20”  Sum of Interior…

Q: A timber beam of rectangular cross section 250 mm depth x 50 mm width is simply supported over a…

A:

Q: A steel band 8mm thick is to be pulled on to a cylinder 30cm in diameter. The internal diameter of…

A:

Q: From the table shows a summary of a liquid limit and plastic limit test. Compute the plastic limit.

A:

Q: on at the bottom of th ostatic pore pressure nodels at 2250m:

A: Numerical analysis -the part of arithmetic that arrangements with the turn of events and utilization…

Q: n TABLE Q2(b): ) Convert the rainfall depth into cumulative raint ) Develop the rainfall intensity…

A: Mass curve is plot between cumulative rainfall depth on y axis and time on x axis Hydrograph is plot…

Q: Arectangular beamof width (b) 230mmandeffective depth (d) 450 mm is reinforced with four bars of 12…

A:

Q: 2. What is the probability that a 50-year river level will occur within the next 10 years at any…

A:

Q: Reasons for the following: 2- The need for the lintel to connect with the floor (ceiling) above it

A: Lintel- When holes such as doors, windows, and other openings are required to provide a building…

Q: Draw the free-body diagram and solve for the support reactions of the following beams:

A: ASKED: To determine the support reactions for the given beam.   The support reactions for the given…

Q: What is the beam deflection at point C when P = 10 kN, L = 1.5 m, E = 200 GPa, and I = 20E6 4? mm

A:

Q: bf = 154.6 mm tr =16.8 mm hw = 301.8 mm flanges tw web %3D %3D tw =(t, - 3) mm b;

A: Part A  Area of the section=  Area of the top flange+ area of the bottom flange + area of the web…

Q: ty of each leg is limited to 87 Ibs onlh

A:

Q: From the given Fink Truss, Identify all the zero force members. -2.4m -2.4m -2.4m 2.4m 2.4m 2.4…

A: To Determine all the zero force members in the given fink truss

Q: For the 3500-lb car, determine (a) its mass in slugs, (b) its weight in newtons, and (c) its mass in…

A: 1 lb = (1/32.174) slug So,  3500 lb = 3500/32.174 slug = 108.784 slug

Q: measures from which the performance of the cities and municipalities are to be gauged in terms of…

A: 1. The first measure of smart city and municipal performance in terms of innovation is degree of…

Q: 3. A steel rod having a cross-sectional area of 450 mm² and a length of 185 m is suspended…

A: Self weight = 7850kg/m3= 3465.3825 N L = 185m A = 200mm2 E = 200GPa   It has been asked in the…

Q: The altitudes of a star at upper and lower transits of a star are 70°20' and 20°40' respectively;…

A:

Q: If a body looses half of its velocity on penetrating 3 cm in a wooden block, then how much will it…

A: The values given in the question are as follows: The body looses half of its velocity on penetrating…

Q: SITUATION 2: The truss has the following configuration where e is 45 10 kN 15 kN K M G 17.5 kN 7.5…

A:

Q: The rigid bar ABC, initially horizontal, is pin supported at B, connected to a shear spring at A,…

A: Solution-The given values are as follows L = 1.5 ft  A = 1 in2  E = 10,000 ksi  Thermal expansion…

Q: The rise of mercury in barometer is indicated as 80 mm. What is the atmospheric pressure (kN/m2) at…

A:

Q: 1. A metal wire 25 ft long, hanging vertically, supports a load of 750 lbs. Neglecting the weight of…

A:

Q: 3.11 The moist density of a soil is 1750 kg/m³. Given w = 23% and G, = 2.73, determine: a. Dry…

A: γd= 1750kg/m3w = 23% = 0.23Gs= 2.73   And it has been asked in the question to determine the Dry…

Q: 1. For the 3500-lb car, determine (a) its mass in slugs, (b) its weight in newtons, and (c) its mass…

A:

Q: The waterline section of a barge is as shown.    a) Calculate the total area (m^2) of the barge…

A: Neutral axis : There are no longitudinal stresses or strains along the neutral axis in the…

Q: Determine the unknown values of a given closed traverse: Line Latitude Departure DMD DA AB 49.29…

A:

Q: An I.S.L.B. 300 @369.8 N/m transmits an end reaction of 260 KN to the web of I.S.M.B. 450 @ 710.2…

A:

Q: Q3): Choose the correct answer for the following: 1. A particle that is slowing down is: a.…

A:

Q: (Past Board Exam Problem) A beam is simply supported on a span of 5meters and carries the following…

A:

Q: If the soil sample is ha natural moisture cont indoy he ligu of 0 55 th liau

A:

Q: For the intersection curve (R= 30 ft) at First Street, station E (8 + 38) to station H: . Compute…

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Design an l-section purlin, for an industrial building situated in the outskirts of Allahabad, to…

A:

Q: 3.7 Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory…

A:

Q: Which of the following might a suitable floor framing system for columns on a 20 ft x 60 ft spacing…

A: The 3rd and 5th options are correct. Plywood and wood joists are suitable as well as economical for…

Q: The rise of mercury in barometer is indicated as 80 mm. What is the atmospheric pressure (kN/m2) at…

A: Given data- rise of mercury H=80 mmTo Find-The atmospheric pressure P

Q: Question 5: Each sled dog can pull with 100 [N] force on ice. If both sled teams start from rest,…

A:

Construction Documents

Construction documents are the branch of architectural design and a vital field of the architectural process. We must not mistake the construction documents as a schematic design, wherein it involves sketching, model making, and so on. They provide guidance and instructions to the contractor or the subcontractor and they will study the architect’s building design, question the design professionals if needed, create a project manual and schedule for the successful construction of the proposed structure. Construction documentation acquires the detailed building permits and the design-build is initiated.