determine horizontal reaction and vertical reaction at cw=17.7 instead of 4 Problem A: The beam shown is part of a walkway of a gymnasium. Thebeam ABC can be considered simply supported at B and C. The imposeduniformly distributed load is 4 kN/m, L1 = 1.50 meters, L2 = 6.0 meters andH1 = 7.0 meters. Determine the load carried by the column at B. *PROBLE M Aw( KN/m)ALIBレ2HI

Answered: Image /qna-images/answer/980e0dc9-0932-48d6-b4ca-f078ca53b83c.jpg

Answered: can be considered distributed load is 4…

Engineering

Civil Engineering

can be considered distributed load is 4 eters. Determine the

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1) What material has the most significance/importance in the modern construction? 2) Which material ...

A: M-Sand - Manufactured Sand Since we have very minimal of natural resource of Sand, Most of the coun...

Q: What are the agents that can be adsorbed by activated charcoal and agents that cannot be adsorbed by...

A: Activated charcoal adsorbs many substances such as alkaloids, vitamin Kantagonist, and acetaminophen...

Q: iven: -The members are a semi circular cross section with a radius of 16mm -Thickness of each memb...

Q: 12. What will be the total pressure (in kN) on a vertical square lamina submerged in a tank of oil (...

A: Given Data : S=0.9

Q: e design strength and ne compression mer

Q: E- Design a circular slab for a room 5 m in diameter (effective) with simply supported edge. Total s...

Q: Use midpoint method. Divide the whole interval into 8 subintervals. Use trapezoidal method. Divide ...

Q: Determine the available strength of a 10.0 ft double-angle compression member using A36 steel. 7oal:...

A: Given:- Two 5×3×1/4 angles are used back-to-back with a 3/8 in the gap The two angles are welded to ...

Q: Consider an inner beam-column joint in the ground floor roof of a eight storey building in Noida, U....

Q: A trapezoidal masonry dam is 10 m high and retains water upto the height of 8.5 m. The width at the ...

A: Given : 10 m high, top width = 3 m Bottom width is 6 m height of water is 8.5 m Maximum allowable co...

Q: Problem 6 A closed cylindrical tank contains 2m of water, 3 m of oil (s=0.82) and the air above oil ...

Q: reservoir of glycerin has a mass of 1,200kg and a volume of 0.952 m3. Find it’s (a)Weight, W (b) Uni...

Q: 3. A certain copper wire has a resistance of 25 ohms at 10°C. Take the temperature coefficient at 10...

Q: Diferen cee Chamicel Osyger Desnand) between Biocherncal Oxysen Denerel nt

Q: 9. A square lamina (each side equal to 2m) submerged vertically in water such that the upper edge of...

A: To find: What will be total pressure

Q: The profile of the ground surface along which the center line of the roadway is sloping uniformly at...

Q: For the truss given below, what is the restraint that can not be remove to arrive with a primary str...

Q: As shown below a rectangular R.C.C. column is subjected to compressive force P at an eccentricity of...

Q: If the diameter of a thin hollow homogeneous elastic tube is doubled while retaining the thickness, ...

Q: 6.) A 30 m steel ta pe supported at iis ends weighs 0-03 kg/m and is of st and ard length under a pu...

A: Given: Nominal Length of steel tape=30 m Supported at ends Weight of tape, w= 0.03 kg/m Standard Pul...

Q: Q8a. The beam section below is solid and homogenous and has the following dimensions: b1 = 65 mm (t...

A: To find centroid of channel section

Q: 12. What will be the total pressure (in kN) on a vertical square lamina submerged in a tank of oil (...

A: To find: Total pressure on lamina.

Q: 8. VA KN FIGURE NO. 3

Q: Calculate the minimum wall thickness for a cylindrical vessel that is to carry gas at a pressure of ...

Q: The upper, middle and lower hair reading is 2.45 m, 1.86m, and 1.27 m respectively. Determine the ho...

A: Determine the horizontal distance from the instrument to the the observed point.

Q: A box contains 500 envelopes, of which 75 contain $100 in cash, 150 contain $25, and 275 contain $10...

Q: 3. What is your recommendation for the maximum size of coarse aggregate for the following situation?...

A: Given: The thickness of the slab is 10 in. The clear cover is 4 in.

Q: The azimuths of the back and forward tangents (measured from North) of a simpl curve respectively ar...

Q: ethe problems belowt 1. 0 kap e ngure shows the cross wction of a circular steel tube that is filled...

A: Given data, Es = 29 x 10^6 psi Ec = 3.5 x 10^6 psi. Axial load = 200 kips Outer diameter = 6.5 inc...

Q: What is a Isohyetal method? What is a Thiessen Polygon?

Q: Draw the shear and moment diagram of the beam shown using the shear and moment equations. Identify t...

Q: FloorArea (Sq.Ft.) Offices Entrances Age AssessedValue ($'000) 4790 4 2 8 1796 4720 3 2 12 1544 5940...

A: To find - Which predictors are considered significant? Which predictors can be eliminated ?

Q: The displacement of the body

A: mechanics:

Q: E- Design a circular slab for a room 5 m in diameter (effective) with simply supported edge. Total s...

Q: Figure Q2(b) shows the isometric view and cross-sectional of a column. A 500 kN of load is acting 20...

Q: * TRIANGLAR CHANNEL WITRr ews INCLINED40° wimt THE HORIZENTAL IS LAID IN SPE.aCE n- 0.01. DETERMINE:...

Q: Situation VI: The profile of the ground surface along which the center line of the roadway is slopit...

Q: The plan of a reinforced concrete column section, and the distribution of strains at the ultimate li...

Q: The rigid bar AB of negligible weight is supported by a pin at O. When the two steel rods are attach...

A: Given data, E for steel = 200 Gpa Cross section area of AC = 300 mm² Cross section area of BD = 250...

Q: A vertical parabolic curve of length 180m has the following specifications. The point of interaction...

A: Vertical curves are utilized to give continuous change between two adjoining vertical grade lines. T...

Q: A rectangular channel: width: 25 ft wide depth: 5 ft flowing with a mean velocity of 2.55 ...

A: We will equate energy at both sections.

Q: Suppose that in a senior college class of 500 students it is found that 210 smoke, 258 drink alcohol...

Q: find the values of x * 2x, + 3x2 + 2x3 =3 4x1 – 5x2 + 5x3 = -7

A: Calculate the value of X1,X2 and X3 by using matrix method, AX=B A=2324-55-37-2 B=3-75 , X=X1X2X3 N...

Q: The beam section below is solid and homogenous and has the following dimensions: b1 = 65 mm (top fl...

A: Given: The value of b1 is 65 mm. The value of b2 is 65 mm. The value of b3 is 25 mm. The value of d1...

Q: The homogeneous bar AB weighing 2000 lb. is supported at either end by a steel cable. Calculate the ...

A: Given data in question Length of bar Working stress of steel cable Weight of bar To find out Small...

Q: Given the following data gathered from an altimeter survey: Elevation of the high base, 818 m, eleva...

Q: weir that will increase the

Q: If there are 10 different sandwiches, 12 different side dishes, om which to choose, how many lunch s...

A: Probability: option c

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

determine horizontal reaction and vertical reaction at c
w=17.7 instead of 4

Problem A: The beam shown is part of a walkway of a gymnasium. The
beam ABC can be considered simply supported at B and C. The imposed
uniformly distributed load is 4 kN/m, L1 = 1.50 meters, L2 = 6.0 meters and
H1 = 7.0 meters. Determine the load carried by the column at B. *
PROBLE M A
w( KN/m)
A
LI
B
レ2
HI

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine support reaction. Given a=5 m b=10 m P=30 KN
An L = 38-ft-long soldier beam is used as a key component of an earth retention system at an excavation site. The soldier beam is subjected to a soil loading that is linearly distributed from wA = 430 lb/ft to wC = 270 lb/ft, as shown. The soldier beam can be idealized as a cantilever with a fixed support at A. Added support is supplied by a tieback anchor at B, which exerts a force of P = 5000 lb on the soldier beam at a = 29 ft. Determine the horizontal deflection of the soldier beam at point C. Assume EI = 3.8 × 108 lb·in.2. Deflection is positive to the left.
If the beam carries a moving uniform load of 136 kN/m and concentrated moving load of 114 kN. Using theinfluence line diagram, (a) determine the maximum +M due to loads at C (b) determine maximum +V at C
The frame (Figure 1) has dimensions H1 = 4 m , H2 = 3 m , L1 = 5 m , and L2 = 10 m and supports two lateral loads P1 = 10 kN and P2 = 12 kN . a) Use the portal method to determine the shear at J. VJ = ? b) What is the vertical reaction from the ground on the base of the column at AA? Let a positive reaction be pointing upward. Ay = ? c) What is the vertical reaction from the ground on the base of the column at B? Let a positive reaction be pointing upward. By = ?
An L = 23-ft-long soldier beam is used as a key component of an earth retention system at an excavation site. The soldier beam is subjected to a soil loading that is linearly distributed from wA = 410 lb/ft to wC = 290 lb/ft, as shown. The soldier beam can be idealized as a cantilever with a fixed support at A. Added support is supplied by a tieback anchor at B, which exerts a force of P = 4500 lb on the soldier beam at a = 18 ft. Determine the horizontal deflection of the soldier beam at point C. Assume EI = 6.4 × 108 lb·in.2. Deflection is positive to the left.Answer:vC = Type your answer here in.
A propped beam has a span of 7.2 meters is simply supported at C. It carries a concentrated load of 60 kN, 3 meters from C. EI = 3000 kN.m2. reaction at C, in kN angle of rotation at C deflection at B, in mm
Solve for: 1. Maximum W in kN if each leg resist 10.098 kN. 2. If W is 49 kN. what is the force resisting of leg DA? 3. If W is 51 kN. what is the force resisting of leg BA?
Refer to the beam loaded as shown. (a)What is the Value of horizontal reaction at the fixed support?(b)What is the value of resulting couple at A?
The frame shown in Figure is hinged at E and roller supported at A. Determine the horizontal and vertical components of the hinge forces at B. a.) Bh= 24 KN & Bv=56 KN b.) Bh=48 KN & Bv= 81 KN c.) Bh=24 KN & Bv= 81 KN d.) None of the Above e.) Bh= 48 KN & Bv=56 KN
The frame has dimensions H1 = 4 m , H2 = 3 m , and L1 = 6 m , and supports two lateral loads P1 = 10 kN and P2 = 12 kN . The area of column AE is 40 cm2 and the area of column BF is 80 cm2 . Gy = 13.3 kN Ax = 11.0 kN a) What is the horizontal reaction from the ground on the base of the column at B? Let a positive reaction be pointing to the left. Bx = ?
2. A 7-meter simple beam has one of its supports at the left end and the other is placed 3m from the right end carrying a triangular load of 0 to 18kN/m that varies 0 kN/m at the left support and terminates with 18 kN/m at the second support. Exactly at the free end, the beam is also carrying a concentrated load of 20 kN. What is the reaction at the right support of the beam?
The inverted T section of 6 m overhang bearn has the properties shown. The beam carries a uniformly distributed load W_{0} over its entire length and a concentrated load of 5 KN, 3 m from the rightmost support. Determine W_{0} if f b(T) =30 MPa and f b(C) =70 MPa