Can ripple factors be grater then unity . Justify?
Q: What is Per Unit System? In the given picture, would there be any difference in calculation of the…
A: The per-unit value of any quantity is defined as the ratio of actual value in any unit to the base…
Q: A second order system Shown s(st) Find tootpotryts, also find an express for unit Step respon se af…
A: This is a good question based on control system subject . In this i you remember the formula then…
Q: Which of the following is more likely to cause problems with motors? a) positive sequence harmonics,…
A: Which of the following is more likely to cause problems with motors? Negative sequence harmonics,…
Q: e waveform shown. Find the ripple factor y, 6 volts and V2 = 12 volts.. t(seconds)
A: Since there are multiple questions uploaded within a single question, so solving the first question…
Q: Application of load flow in power market?
A: There are various applications of load flow. Some of them are mentioned below, It is used to…
Q: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…
A: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…
Q: explain the operating principle of single phase 2S-2P PMSM based on 3D design illustration.
A: According to the question, explain the operating principle of single-phase 2S-2P PMSM based on 3D…
Q: Describe the effects of harmonics on power distribution system.
A: Harmonics are the undesirable noises in the power distribution system.It usually occurs due to the…
Q: Q.6 (a) Explain in detail the four-quadrant operation of chopper and how it is differed from dual…
A: Operation of four quadrant chopper four quadrant chopper consists of four semiconductor switches and…
Q: A step-down chopper, with voltage source 20V. If the duty cycle is 50% and chop frequency is 0.1Hz,…
A: In this question , step down chopper is given...We have to find out ON time of chopper and average…
Q: 2. When a large shunt capacitor is suddenly connected in parallel with the load bus in the…
A:
Q: The steady state stability limit of a synchronous machine connected to infinite bus is 2.2 p.u.…
A: Given: The steady state stability limit of synchronous machine, Pss=2.2 p.u. The infinite bus…
Q: Given the following performance criteria: 2% settling time less than 1 second, overshoot less than…
A: It is given four different sets of closed loop poles from that pole locations we need to tell…
Q: Calculate the impedance ?? for the maximum average power transfer in the circuit shown in Figure 3.…
A: In this answer we will try to find out the answer by developing the thevenin's equivalent of the…
Q: Kindly explain the methods of reactive power compensation in power systems.
A: The methods for reactive power compensation are nothing but the methods by which poor power factors…
Q: 1. In the waveform shown. Find the ripple factor y, if V1 = 8 volts and V2 = 10 volts- V(Volts)| V2…
A:
Q: For type A chopper, dc source voltage = 250 V, load resistance = 10 Ω. Take a voltage excess of 2V…
A:
Q: Determine VP(sec), VP (out), PIV, Vp(rect), Vr(p-p), VDC and the ripple factor, r
A: The Given circuit is To find Vpsec,Vpout,PIV,Vprec,Vrp-p,VDC and the ripple factor.r
Q: The power factor of synchronous generator (connected to infinite bus) can be controlled by the O a.…
A: As per our company guidelines we are supposed to answer only first question kindly repost other…
Q: Write the procedure steps for paralleling two DC generators T TTArial
A: when the power requirements are higher then it is not possible to supply high power demand using…
Q: Derive net RMS EMF induced in the stator winding, when there is an influence of 1st, 2nd harmonics.
A: EMF induced due to first harmonics is = RMS value is =
Q: The Hellmann formula describes? (a) solar irradiance depending on the thickness of the cloud cover.…
A: The velocity of wind varies with the height above the ground.
Q: L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm,…
A: According to the context of the given question, it is required to determine the number of times…
Q: Two alternators rated 400 MW and 600 MW are operating in parallel. The droop characteristics of…
A: In this answer we will find the load shared by both the alternators and also find the frequency at…
Q: a) How many MVAr of shunt capacitors are required to increase the power factor on a 10 MVA load from…
A: Note: Since you have not specified any question to be answered, as per our honor code, we are…
Q: Induction motors and power factor correction capacitor banks are examples of nonlinear loads. True…
A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…
Q: We use two identical transformers in experiment: (Parallel operation of two transformers) to achieve…
A: In order to achieve the condition of parallel operations of two transformers the given below…
Q: Source Transformation method I=? V50ohm=? P50ohm=?
A: By source transformation voltage source with series resistor can be replaced by current source with…
Q: 10 + 16 * 10-3P. = 16 1- (3 * 10-*P, + 2 × 10-$P;) 8+ 18 + 10-P, 1- (3 * 10-*P2 + 2 * 10-5P,) = 16…
A:
Q: What are symmetrical components and why are they used
A: Characteristic of three phase balanced system: Each phase is displaced by 120° phase angle. Each…
Q: For type-A chopper of. dc source voltoge = 230 V, load resistance = 102. Take a voltage drop of 2 V…
A: Given values are - VS=230VVD=2VDuty ratioD=0.4 Given that chopper is type-A so that it is step down…
Q: how to chang temperature flow to laminar flow
A: The Laminar Flow The Laminar flow number of the lower gas laminar in the tube is analyzed by very…
Q: What is voltage stability? How is reactive power linked with the voltage stability in the power…
A: Voltage stability is characterized as the capacity of the power system to support fixed passable…
Q: 6. In symmetrical components, if IR1 90° What is the value of Ip ? 100 z 30° and Iy2 = 20 -
A: From the symmetrical components
Q: The annual load duration curve for a typical heavy load being served by a steam station, a…
A:
Q: Write the types of power factor improvement.
A: Power Factor: The ratio of real power to that of the apparent power is known as power factor.
Q: A surge of 100 kV travels along an overhead line towards its junction with a cable. The surge…
A: Given, A surge travels along an overhead line towards its junction with a cable is, V= 100 kV The…
Q: 041 A single area consists of two generating units, unit 1 of 600 MVA with speed regulation of 6%…
A: GENERATOR : generator is a device used in electricity generation that transforms motive force…
Q: The amplitude of the sinusoidal symmetrical AC component of the three-phase short-circuit current of…
A: The sinusoidal symmetrical AC component of 3-phase short circuit current of the machine is given as:
Q: v) Define the term of degree of compounding in DC generators. What are the applications of different…
A: Degree of compounding is defined by the number of turns in series field winding and shunt field…
Q: UDng a ITIe Core in high frequency transformers. c- Discuss, different applications of iron cores of…
A: C)For magnetizing or demagnetizing a iron material, some energy is expended. The energy expended…
Q: Two alternators rated 400 MW and 600 MW are operating in parallel. The droop characteristics of…
A: The solution is given below
Q: A generating system contains three 20 MW generating units each with a 3% FOR and one 45 MW unit with…
A: A table for unit system capacity outage is shown below:
Q: Explain the phase advancer method in power factor improvement?with a proper diagram.
A: According to the question we have to explain the phase advancer method in power factor improvement ?…
Q: 4. (a) What is leading and lagging power factor? and discuss about the reasons for the low power…
A:
Q: 8- What do you understand from the load curve and what information are converged by a load curve.
A: The following are the information obtained from load curves. 1. Load duration curve determines the…
Q: Discuss about generator modeling and drive the formula for the real and reactive power supply it .
A: Generator modeling - The simplest sophisticated modeling in a system stability tool are generator…
Step by step
Solved in 2 steps with 1 images
- The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.While the instantaneous electric power delivered by a single-phase generator under balanced steady-state conditions is a function of time havi ng two components of a constant and a double-frequency sinusoid, the total instantaneous electric power delivered by a three-phase generator under balanced steady-state conditions is a constant. (a) True (b) FalseConsider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to