Answered: Can the regulator given in Figure Q4.b…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Question

Can the regulator given in Figure Q4.b be used to regulate the output of a full-wave
rectifier, given the specifications for Io and Vpk in the Table 4 above?

The rectifier voltage varies between 0.7Vpk and Vpk (that is, the ripple voltage is 30%
of Vpk). The value of the Zener voltage Vz is 5.6 V, and the Zener diode power rating
is 2W. The regulator must supply to the load the current of at least Io mA.

mA = 160

V = 22v

To answer this question, you need to determine the value of the resistor R for the
output requirements specification for Io and Vpk given in Table 4.

Question
part
Q4.a, b
Q4.a
Q4.b
Parameter
Load current
Io [mA]
Ripple voltage as
percent of peak,
X [%]
Peak rectifier
output voltage
Vpk [V]
Value
100+10F
10+A+B
20+A+B
Table 4
Example:
Student ID=210123456:
F=6
A=1, B=2
A=1, B=2
lo 100+60 160 mA
X= 10+1+2= 12%
Vpk = 20+1+2 = 22V

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions