800 kW of heat is added to a heat exchanger with 16 mol/s ethylene flowing through. The fluid enters started at 200°C. What is the final temperature, if the pressure is held at 1 bar?

Q: I need solution please with steps Figure 22 (B) (B) Calculate the enthalpy change for 1 kg of water ...

A:

Q: In stripping In> En-1 O True False

A:

Q: How many SCF of an ideal gas are required to fill a (100 ft') tank to a pressure of (40 psig) when t...

A: Given:  Volume = V = 100 ft3  Pressure = P = 40 Psig = (40 + 14.7) Psia  = 54.7 Psia  Temperature = ...

Q: Water flows through a pipe at an average temperature of 7-50°C. The inner and outer radii of the pip...

A: Given: The pipe has an inner radius of r1 = 6 cm and outer radius ry = 6.5 cm, The average temperatu...

Q: Salt water is kept in a cylindrical column of cross-sectional area 31 cm2 and height 63 cm. The salt...

A: Given, The area of the cylinder, A = 31 cm2 The height of the cylinder, H = 63 cm The salinity of th...

Q: Organic compounds that contain terminal carbonyl group. O ketone O aldehyde O ether O alcohol

A:

Q: Calculate the entropy change, in calories/degree, that accom- panies the separation of four componen...

A: The separation can be thermodynamic and spontaneous when change in entropy is greater than zero. Thi...

Q: When wauld a mole balance on a system be equal to "In = Out" ? Select all conditions that are requir...

A: Given: Mole balance of system equal to "in = out". Select the condition which are true.

Q: Example 4.7: What is the maximum temperature that can be reached by the combustion of methane with 2...

A:

Q: Given: Fin width: 90 mm Fin length: 45 mm Fin thickness: 5 mm Thermal conductivity of fin material: ...

A: The heat transfer through a rectangular fin is given as follows: qfin = hPkA(To-T∞)×tanh (mL) (Watts...

Q: 7. A container was found to weight (80.0 g) while evacuated. The container then was filled with oxyg...

A:

Q: Combining 5.0 L of a 5.0 mg/L ethanol solution with 10.0 L of a 15 mg/L ethanol solution results in ...

A:

Q: Determine the Miller-Bravais indices for plane shown below. ja2 a3 a1

A: Determine the Miller-Bravais Indices for given plane.

Q: One mole of n-butane is held in a varying-volume reactor where its gas and liquid phases are in equi...

A: Given: T=1000c P=15.41 bar compressibility factor for Redlich kwong cubic equation of state for satu...

Q: 4. A soap bubble of d mm diameter is observed inside a bucket of water. If the pressure inside the b...

A: The pressure inside a soap bubble is always greater than the atmospheric pressure. It is because of ...

Q: In the determination of the liquid-vapor phase diagram of 2 components A and B, the following data a...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: 4. When 1,000 [bbl] of mud have to be increased from 10 [ppg] to 13 [ppg] mud weight by adding API B...

A: Given data; Initial density of mud = 10 pounds per gallon (ppg) Final density of mud = 13 pounds per...

Q: Compressibility factor-reduced pressure plot on reduced coordinates facilities use only one graph fo...

A:

Q: Where is hydrocarbon gas used in the cooling process?

A: 1,1,1,2-Tetrafluoroethane is a hydrofluorocarbon (HFC) and haloalkane refrigerant . It is also know ...

Q: production of C is carried out in a batch reactor maintained at a constant temperature of 100°C and ...

A:

Q: Q16:- A light oil is to be preheated before being fed to a distillation tower. The preheating is to ...

A:

Q: 23. Pressure variation for compressible fluid is maximum for which of the following kind of process?...

A:

Q: Calculate the heat absorbed by the dipsidium CaMgSi2O6 when the temperature of the mineral increases...

A: Heat transferred to the disodium is equal to the molar content. As the temperature increases, heat i...

Q: A vapor-compression refrigeration system is conventional except that a countercurrent heat exchanger...

A: Given: At the conditions of point, 2 i.e. Saturated vapor t = 266.33 K & P = 33.110 psia in tabl...

Q: The gas may be produced by several methods:

A: There are many types of gases we get as a product and coproduct in our chemical and petrochemical in...

Q: A tire is inflated to a gage pressure of 35 psi at a temperature of 0ºF. Calculate the maximum tempe...

A:

Q: Mass of water (V2): 100g Mass of Coffee (Feed slurry): 3g Assume that: • 85% of coffee will be leach...

A: The given process is known as leaching. The slurry which consists of A, B, and C is fed to the leach...

Q: Hot waters enters a radiator at a rate of 0.5 kg/s, losing heat from 100°C to 75°C. Air flows across...

A: Given data: Mass flow rate of water = 0.5 kg/s Initial temperature of water = 100 0C Final temperatu...

Q: 3) The molar heat of formation of NHẠNO3 (s) is -367.54 kJ and those of N20 (g) and H20 (1) are 81.4...

A: Note: The reaction given is not balanced properly, the correct reaction is given as follows: NH4NO3(...

Q: Nitrogen is to be liquefied in a simple Linde process. The feed and recycle are mixed, compressed to...

A: Drawing of the process:

Q: Q18:-Calculate the work in (hp) required to pumplb of water per minute from 100 psia and80°F tol000 ...

A: Given: m=1 lbmin=0.0166 lbsecP1=100 psia=100 lbfin2T1=80 °FP1=1000 psia=1000 lbfin2T1=100 °Fρ=62.4 l...

Q: A first order system with transfer function G₂ = Y(S)/X(s) = 1 /(s+1) is subjected to input X(t) = t...

A:

Q: Why is it critical for the ph to be 2 or below. In a lab discussing the effect of pH on food preserv...

A: Microorganisms, including yeasts, molds, and bacteria, are sensitive to a food’s pH. Very low  pH va...

Q: A monoatomic ideal gas expands adiabatically and reversibly from 300 KPa to 100 kPa in a piston-and-...

A: Given data: Monoatomic ideal gas T1 = 315 C = 588 K P1 = 300 Kpa P2 = 100 Kpa Find the T2.      

Q: The graph below represents the value of concentration versus position for different times (t1, t2 an...

A:

Q: Which of the following MNPS (or synthetic analogue) prevent heart disease and stroke? Select one or ...

A:

Q: Q12:- Detergent with a specilic gravity of 0.96 flows from a storage tank to a washing machine by gr...

A:

Q: 1) Draw the following mechanical model and strain behavior during a constant stress is applied and r...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Please recreate this graph in a clearer version

A: The graph between N and xA, yA is given.

Q: The industrial production of the ammonium nitrate fertilizer entails an exothermic reaction of anhyd...

A: the balanced reaction of Nitric acid formation is NH3+HNO3→NH4NO3

Q: Q4// A sample of oil with boiling point of 255 C and specific gravity (at 15.5 C) 0.85: 1-Calculate ...

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub-...

Q: (Video 5 Example 4.6: Calculate the standard heat of the following methanol-synthesis reaction at 80...

A:

Q: Calculate the pressure of hydrogen required to stop corrosion of cadmium at 25°C in deareated water ...

A:

Q: Q.9A heat exchanger is used to cool a hot hydrocarbon liquid flowing at rate of 200 Kg/hr from 150° ...

A:

Q: The industrial production of the explosive ammonium nitrate fertilizer entails an exothermic reactio...

A:

Q: 1. Find the AH° of the following reaction, 1 CH,(2) + =0-(9) – CO(g) + 2H2(g) - Using the following ...

A: Given: CH4(g)+2O2(g)→CO2(g)+2H2O(g)                         ∆H°=-802 kJCH4(g)+CO2(g)→2CO(g)+2H2(g)  ...

Q: You raise the pressure of a gas at constant temperature in a closed system. The entropy of the gas, ...

A: To choose the correct option that answers the blank.

Q: Example 4.7: What is the maximum temperature that can be reached by the combustion of methane with 2...

A:

Q: An effluent containing an algae in suspension with solid and water densities of 2600 and 1000 kg m-3...

A: We are given the following information   Height = 5 m time = 30 min = 1800 s viscosity = μ = 0.001 k...

Q: carbon atoms Compounds in which one or more aromatic carbon ring systems are present Compounds with ...

A: