Categorize the signal shown in figurel as: 1- Even, Odd signal, or neither odd nor even. 2- Periodic or non-periodic signal, and If periodic find its period, and its angular frequency. 3- Energy or power signal, and find the Energy or averaged power of it. Figure 1 X(1) 4.5 n 0 4

Q: Q4\ design synchronous counter with irregular binary count sequence shown in below using negative…

A: Design synchronous counter with irregular binary count sequenc shown  in below using negative edge,…

Q: * * If the sinusoidal current (i = 6 sin 1000 t), then the angular velocity of this waveform will be…

A: In this question,  We need to choose the correct options We know standard signal of current i= Im…

Q: Two mutually coupled inductors L1 and L2 are connected in series between terminals (a) and (b). If…

A: Given data, L1=20 mHL2=12 mHLT=24 mH

Q: In a Two port network analysis, if the output port is short circuit, we will put a in the input port…

A: In this answer we will find the solutions to the above two questions by using the concepts of…

Q: Fig 7. Shows the circuit diagram which a student used in the implementation

A:

Q: For the circuit below Junction voltage is 0.7V the +ve and -ve peak of the output waveform is +10V…

A:

Q: What are the conditions to be satisfied for the root locus to exist at any point in s-plane

A: The conditions to be satisfied for the root locus to exist at any point in the s-pane are:  Angle…

Q: 02: A resistor denoted as Re, is connected in series with the capciter in the circuit in Fig. Q2…

A:

Q: The unit of inductive reactance is (a) Henry (c) Tesla (b) Weber (d) Ohm

A: From given units: Henry is the unit of Inductance Weber is the unit of magnetic flux Tesla is the…

Q: The total inductance for the following three coupled coils is 13 10 12 O 11 m 7H 4 H 2 H m 8 H 5 H…

A: When current enter or exist at the same polarity Leq=L1+L2+2M When current enter or exist at the…

Q: A circuit consisting of a coil with inductance 10 mH and resistance 20 2 is connected in series with…

A:

Q: نقطة واحدة نقطة واحدة * * Admittance, represented by the symbol Z, is a measure of the opposition to…

A:

Q: 5. Design and draw an impulse commutation circuit, where the discharging time is 10us, initial…

A: Given the discharging time is 10us, initial capacitor voltage is 5V and constant load current is 2+…

Q: The message signal given in the figure below is used in both FM and PM. Given that the maximum…

A: We need to find out ratio phase constant and frequency constant .

Q: Which of these equations is correct (choose one only) ? O V1= A*V2 - B*12 O V1= A*V1 - B*12 O V2=…

A: Given ABCD parameters relations..

Q: In a transistor

A:

Q: 5. Determine the mesh current i, and is in the following circuit. 2 Ω 12 V V www 4Ω 12 Ω 9 Ω www 12…

A: Given circuit,

Q: A LED which bright one color when forward and another color on reverse is called One directional LED…

A:

Q: aranteed availability of AWS S3 is __

A: AWS S3 : AWS S3 is known as amazon simple storage service which main function is to store the object…

Q: In connecting ideal single-phase transformers in parallel, how will the load be shared if the two…

A: Parallel connection of transformer represents that the it must have same KVA ratings, number of…

Q: 5. Calculate all unknowns for the following circuit. + V₁ W R₁-200 20 V Ry R₁-25 11 www R₂150₂ 5

A: Given circuit: E=20 VR1=20 ΩR2=15 ΩR3=25 ΩRT=?Is=?V1=?V2=?V3=?

Q: ease show solution . Find the inverse Fourier transform of the following signals. (a) X (jw) =…

A:

Q: b. Consider the periodic triangular waveform, x(t) shown in Fig. 3. i. ii. iii. x(t) 20 0 T Fig. 3…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: The message signal given in the figure below is used in both FM and PM. Given that the maximum…

A: We need to find out the ratio of Kp and Kf .

Q: Do you know how a diode and an LED are related to semiconductors? Use a diagram with a short…

A: LED  The LED should be connected in forward bias in an electronic circuit.  The polarity should be…

Q: G is equal to

A: The block diagrams are reduced with some rules. two of those rules are given below  If two blocks…

Q: Problem Find the values of the input and output impedances. Determine the closed-loop voltage gain.…

A: For the given op-amplifier circuit the following parameters are given. Aol=50,000Zin= 4 MΩZout=50 Ω…

Q: The signal x(t) = cos2n70t+cos 27120t is input to the square-law modulator system given below with…

A:

Q: Figure (b) illustrates the piecewise linear approximation of the I-V characteristics of a non-linear…

A: Diode has the two terminals and one PN junction. It conducts during forward bias and behaves as open…

Q: In a two port network, when 12=0, V2=4 V, 11= 3 A and V1 = 3 V. C is equal to O 1.333 Siemens O 0.75…

A: We need to find out value of C for given parameters

Q: 2. Convert from Hexadecimal number to Octal number (3B.E) 16 Your answer

A:

Q: The min and max value of RL to keep VRL = 5V is * + V₁ = 50 V 1 kQ2 www R V/₂=5 V IZM= 32 mA Iz O200…

A: In this question,  We need to choose the correct option What is min and max value of load resistance…

Q: Q4: Show how to PSK modulate and demodulate the data sequence (01101). Assign two full cycles of…

A: 4. Given, PSK modulator has  Input data sequence = 01101 Number of cycles of carrier for each data…

Q: The effect of rain attenuation at high frequencies is minimized if vertical polarization is used.…

A: The attenuation in the communication process which is caused by rain is known as rain attenuation…

Q: One of the applications of the mutual inductance is Wireless Charging of Electrical Vehicles O…

A: Application of mutual inductance is

Q: An AC voltage represented as -196+j75 V, has a magnitude (in volts) of: 150 210 None of the other…

A: Given: An AC voltage represented as V=-196+j75 volts

Q: 1. What is the advantage of angle modulation for (noise and interference), the bandwidth of…

A: Angle modulation: It is a technique where the phase or frequency of the carrier signal changes in…

Q: Let x[n] = { 1.0, 3.0, 4.0, x[-1]=1.0, x [0] = 1.25, 2.25, 1.4). Calculate the DTFT X (eja).

A: Given here discrete signal xn and asked to find the DTFT Xejw.   let xn be discrete sequence then…

Q: In an overhead transmission line, if 'L' is the length of span in meters, 'w' is the weight of…

A: Given: In an overhead transmission line, Length of span in meter is L Weight of conductor per meter…

Q: Consider the parallel RLC circuit of Fig. 16.57. Fir v(t) and i(t) given that v(0) = 5 and i(0) = -2…

A: Given data, v0=5 V, i0=-2 A Circuit diagram is given as,

Q: A DM system is designed to operate at 3 times the Nyquist rate for the signal with a 3 kHz…

A: In this question we will find maximum amplitude of input for which the delta modulator doesn't show…

Q: What is the unit impulse response of the system shown in figure for t≥ 0? R(s) 1 (s + 1) 1. S C(s)

A: Given system: Unit impulse response, ht=? for, t≥0

Q: ********** One of the Zener diode applications is Current regulator Power regulator O Voltage…

A: - Zener diode is special type of diode which is generally operated in the reverse bias condition.…

Q: Q2: B: system, the output signal to quantization ratio is to be hold to a minimu of 25 dB. If the…

A: Signal power is given by, S.P=Am22 Noise power is given by, Noise power = △22

Q: -wn below. Please note, iL(0) = 0 and vo(0) = o because For all t<0. using Thevenin equivalent 6 2/s…

A:

Q: Q14) Shortly answer ONE of the following: 1- There are two methods to reconstruct analog signals…

A: FIND: (1) there are two methods to reconstruct analog signals from discrete signals, ZOH and FOH.…

Q: Q3: Find the current and power supplied by the battery to the given circuit. 4 K A 6 K www P = 12 V…

A: Given circuit,

Q: 14. Determine whether the following system is controllable and observable CHE KHE y=[1

A:

Q: Find Vo in the circuit using mesh analysis in the fig.below. 12 V 10 V 6Ω ἐπ 2Ω Μ ΤΩ

A: Given circuit,

Q: Find: Ib, Ic, Vce, Vb, Vc, Vrb Vre, & Vrc Note: show your solutions no solution means wrong answers.…

A: For the given common emitter amplifier circuit we need to calculate all the DC parameters by using…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.