Choose correct answer: Consider an insulated system with piston and cylinder arrangement in which helium gas is present. If 100000 J of work is given to the helium gas, then the change in internal energy is _________ A. 100 kJ B. -100 kJ C. 10000 J D. -100000 J

Choose correct answer: Consider an insulated system with piston and cylinder arrangement in which helium gas is present. If 100000 J of work is given to the helium gas, then the change in internal energy is _________ A. 100 kJ B. -100 kJ C. 10000 J D. -100000 J

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 30RQ: A gas is compressed inside a compressor's cylinder. When the piston is at its bottom dead center,...

See similar textbooks

Related questions

Q: Draw and label the P-V and T-S diagrams. A spark ignition engine takes in air at 14.7 psia and…

A: Given: A spark-ignition engine whose initial pressure is, P1=14.7 psi. The initial temperature of…

Q: team at 5 MPa and 400 °C expands polytropically to 1.0 MPa according to pV 1.3=C.Determine the work…

A: Given Data: Initial pressure, P1=5 MPa Initial temperature, T1=400 C Final pressure, P2=1.0 MPa

Q: A fixed volume insulated tank, which was initially empty, was connected by a valve to a distribution…

Q: Entropy generated due to the heat transfer

A: Given data; An amount ,Q=100kwOne side of wall is maintained ;T1=1270C=127+273=400 KOther side of…

Q: 3.1 kg/s of air expands through a turbine from 8 bar, 800 K to 1 bar, 400 K. The inlet velocity is…

Q: 3. A cup of coffee that has been left on a table to cool to room temperature. Is the process…

A: No this process is not reversible,because when coffee cooled down to room temperature the it will…

Q: a) the volume at state 1. b) the air mass per cycle. c) the heat addition per cycle, in kJ.

Q: A system executes a cycle during which there are three heat transfer Q12 = 200 kJ, Q23 = - 25 kJ,…

Q: A-3.2. Suppose a large tank of water with a temperature of just over 0 C we put in a 100 g ice cube.…

A: GivenT=0oC=273.15Km=100g=0.1kgQ=33kJ

Q: Questions 56-60 are based on the information given here. Air, as an ideal gas, undergoes a…

Q: 2.5 lbm of ammonia in a piston-cylinder assembly undergoes a refrigeration cycle consisting of 4…

A: Given data,

Q: A 3 m3 air tank has an initial pressure of 120 kpa and 35oC. The heat is added until its pressure…

Q: When there is heat loss in a system, how can you increase the work output? a. Increase inlet T at…

A: Answer: The correct answer is option (a).

Q: This application can be said a closed thermodynamic system Water heater Air compressor O

A: To select the correct option.

Q: How much heat, KJ must be transferred to 20 kg of air to increase the temperature from 20oC to 280oC…

A: Givenairm=20kgT1=20oCT2=280oC

Q: Air in an internal-combustion engine has 440°F, 150 psia, with a volume of 3 ft. Combustion heats it…

A: As per our guidelines we are supposed to answer only first 3 sub-parts. Kindly re post other parts…

Q: Work done in a free expansion process is (a) +ve (b) -ve (c) zero (d) none of the above

A: Free expansion is the process in which gas expands without any resistance or pressure from the…

Q: 1 MT/h CH4 (liq) is heated to 44.85 deg C from 31.85 deg C, 400 kPa. What is the duty of the heater…

Q: Heat in the amount of 7.5 kJ is added to a closed system while its internal energy decreases by 12…

Q: A frictionless piston-cylinder assembly initially contains B m3 of air at A kPa pressure. In this…

Q: 13- Gas in a cylinder sealed by a sliding piston, receives 39.9 kJ of heat and expands by 0.2 m'…

Q: QUESTIÓN 56 A fluid at 0.8 bar occupying 0.09 m² is compressed reversibly to a pressure of 10. 1 bar…

A: Given data state 1 p1 = 0.8 bar V1 = 0.09 m3 state 2 p2 = 10.1 bar specific volume (v2) = 0.7…

Q: Saturated steam at 329.3 degree Celsius undergoes an isentropic process until it reaches a pressure…

A: Given Data The temperature of the steam is T=329.3°C=602.3 K. The pressure of the steam is P=1.6…

Q: t=270°C s= 6.5 kJ/kg-K What is the state of the pure substance?

A: It is not necessary for a pure material to consist of only one element or compound. As long as the…

Q: From a state defined by 285.3 psig, 100ft3 and 240F, helium (R=386.04 ft-lbf/lbm-R, k=1.666)…

Q: piston-cylinder assembly contains 2 Ib of water, initially at 100 Ibf/in.2 and 500°F. The water…

A: Given-Data:- m=2l P1=100psiT1=500°Fx3=60%=0.6T3=300°FP3=66.9psi To-find:- Work and heat transfer

Q: Steam flows isentropically through a nozzle from 1550 kPa, 288°C to 980kPa. For 453 g/s determine a)…

A: Given:P1=1550 kPaT1=288°CP2=980 kPam=0.453 Kg/s

Q: find the work done in the whole process in kJ. Draw the P-V diagram for the cycle.

Q: ith 3% moisture, 2.5 kg of steam has an enthalpy of 6600 kJ. It is heated at constant pressure to a…

Q: A rigid container contains gas at 2 bars. Additional gas is pumped into the system till the pressure…

Q: A closed rigid container has a Volume of 1 m^3 and holds air at 344.8 kPa and 273 K. Heat is added…

Q: 1. A nonflow (closed) system contains 1 kilogram of an ideal gas (C,=1.0 kJ/kg.K, C, =0.713…

Q: 1- A steam turbine receives (600 kg/hr) of steam at (25 bar, 350 C°). At a certain stage of the…

Q: -1682 Btu. Determine (a) T2 and T3, (b) the work of the cycle, in Btu; (c) QA, (a) the thermal…

A: Given: !-2: Polytropic compression 2-3: Constant pressure heat addition 3-4: Constant volume heat…

Q: An electric heater consumes 2.1 kW of electricity at steady state to keep a house at 25 °C The…

Q: W2 m In a four stage compressor, if the pressure at the first and third stage are 1 bar and 16 har t…

Q: What is the pressure of refrigerant 134a with a temperature of –12.73 °C and a dryness of 0.816?

A: Given data:

Q: There are 3 kg/min of steam undergoing an isothermal process from 30 bar and 350 oC to 7 bar. (note…

Q: A driver fills an 18.9L steel gasoline can with gasoline at 15 deg C right up to the top. He forgets…

A: Write the given data. T1=15 °C=15+273=288 KT2=42 °C=42+273=315 KV1=18.9 L

Q: An automobile tire initially contains 0.25lb of air at 30psig, 70F and has an automatic valve that…

Q: 6. Air in an internal-combustion engine has 440°F, 150 psia, with a volume of 3 ft. Combustion heats…

A: As per the policy i can answer only 3 subparts

Q: What is the effect of overdamped state?

A: Overdamped: When the damping factor is greater than unity than it's called overdamped. An overdamped…

Q: Carbon Dioxide is contained in a piston-cylinder assembly and undergoes a cycle made of the fol-…

A: Given data as per question

Q: 12) The air conditioner removes 2.7 kJ of heat from inside a house with 450 m² of air in it. At a…

A: The given values are - Q=2.7 kJ, m=585 kg, C=1.01 kJkg°CLet us take ∆T=Temperature change due to…

Q: Steam expands adiabatically through a turbine at steady state. The entering stream is at 750…

Q: A pump handling a liquid raises its pressure from 2 bar to 20 bar. Take density of the liquid as 870…

A: Given:- Intial pressure = 2 bar Final pressure = 20 bar Density of liquid = 870 kg/m3 To…

Q: 5. A rigid tank of 1 m³ contains nitrogen gas (N2) at 600 kPa, 127 °C. By mistake someone let 0.5 kg…

A: NOTE:-As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: A soup is set to boil. When the soup reaches 170°F, remove it from the heat and set it on the…

A: Initial soup temperature, Ti=170oFRoom Air temperature, T∞=80oFAfter time t=2min, soup temperature,…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Choose correct answer:

Consider an insulated system with piston and cylinder arrangement in which helium gas is present. If 100000 J of work is given to the helium gas, then the change in internal energy is _________

100 kJ

-100 kJ

10000 J

-100000 J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How many Btu/h would be produced in a 12-kW electricheater?
From a state defined by 285.3 psig, 100ft3 and 240F, helium (R=386.04 ft-lbf/lbm-R, k=1.666) undergoes an isentropic process to 0.3psig. What is the Final temperature (R)
From a state defined by 285.3 psig, 100ft3 and 240F, helium (R=386.04 ft-lbf/lbm-R, k=1.666) undergoes an isentropic process to 0.3psig. What is the change in internal energy? (BTU)
2.1 Taking the recent World Energy Council and United Nations resource-base figures forthe total amount of fossil energy in the ground worldwide as 356,000 quads, how longwill it take to exhaust our fossil resources, assuming that we can recover one-half of theresource base and that usage grows at 3% per year? The world currently consumes about400 quads of primary energy per year, of which 85% is from fossil sources. (Hint: youwill need to account for the compounding, exponential growth effect of the 3% per yearincrease in consumption.)
A furnace heats water at a saturated state with a pressure of 1 bar. How much heat is given When the water condition in the tank is 15 bar and 500°C. Specify: a) Heat needed? b) Internal changes in energy? c) Work done?
A gas cylinder with interior volume 11.6 L holds compressed air at 17.4 MPa. The cylinder is joined by a hose of negligible volume to a second cylinder that’s been pumped down to vacuum. When the valve on the full cylinder is opened, the air expands to fill the entire system, all the while maintaining a constant temperature. If the energy that becomes unavailable to do work is 171.8 kJ, what’s the volume of the second cylinder (L)?
A rigid container contains gas at 5 bars. Additional gas is pumped into the system till the pressure reaches 12 bars. Find the amount of the work done on the container if its volume is 3 m^3? a)none b)2100 kJ c)1500 kJ d)2000 kJ e)3600 kJ
t=270°C s= 6.5 kJ/kg-K What is the state of the pure substance?
11. an ideal gas with MW= 33 is contained in a flexible tank. it is heated from 258.71 C to 559.35 C. if the change in internal energy is 178 kJ/kg, what is work in kJ/kg
2.5 lbm of ammonia in a piston-cylinder assembly undergoes a refrigeration cycle consisting of 4 processes: • Process 1-2: Adiabatic compression from a saturated vapor at 0°F to 70 lb/in", 100°F. • Process 2-3: Isobaric compression to a saturated liquid • Process 3-4: Polytropic expansion with n = 0.25 until TA =T • Process 4-1: Isobaric expansion (a) Sketch the cycle on p-v and T-v coordinates (b) Determine the work and heat transfer in each process, in BTU (c) Determine the coefficient of performance
Heat in the amount of 7.5 kJ is added to a closed system while its internal energy decreases by 12 kJ.a. How much energy is transferred as work?b. For a process causing the same change of state but for which the work is zero, how much heat is transferred?
A soup is set to boil. When the soup reaches 170°F, remove it from the heat and set it on the kitchen counter. The air in the kitchen is 80°F, and the soup in the bowl is 120°F after two minutes. After removing the soup from the heat, how long will it be 90°F?