4.- For the circuit in the figure shown, use superposition to find i. Calculate the power supplied to the 3 Ω resistor. Note:(the final answer is in the images as verification) 4.15 Para el circuito de la figura 4.83 use la superposición parahallar i. Calcule la potencia suministrada al resistor de 3 0.ps122 A+,20 V16 Vwwww2. iz = [1/(1 + 13/2)]2 = 3/8 = 0.375i = 2.5 + 0.375 - 1 =1.875 Ap = i'R = (1.875)'3 = 10.55 watts

Answered: Image /qna-images/answer/5decb0b1-7fc0-4df0-9070-6e82605150f5.jpg

Answered: circuit in the figure shown

Engineering

Electrical Engineering

circuit in the figure shown

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 2. What best describes the circuit below? Explain your answer. R Vo Vi

A: Solve the problem

Q: Q3- Calculate the current supplied by the 30 V source and the current through each resistor in the…

Q: (a) What is the current through each resistor? (b) What is the power dissipated by each resistor?…

A: As per Bartleby policy we can answer only one part at a time, repost this question for others part.…

Q: For the circuit shown below, find, using the superposition theorem, (a) the current flowing in and…

Q: a) Write and solve the node-voltage equations for the circuit given below. b) Calculate the power of…

A: Part (a) :- Develop the node equation. By simplifying given circuit using source transformation…

Q: .. Consider the circuit shown below. 4k A 2k Vis (1 ) 2m A 4k В 10k 10V 4 V 5k (a) By hand, use any…

A: due to guidelines. we can solve first three subpart of the question.

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

Q: a) Find the Thévenin equivalent circuit for the portions of the networks external to points a and b.…

A: (a) Short-circuit the 10 V source, and then draw the circuit to find the Thevenin resistance.

Q: 1. Use nodal analysis to calculate the node voltage vN of the circuit shown in Figure 1 as a…

A: In this question , we have to find out node voltage using Nodal analysis...

Q: For the next 5 items, refer to the circuit below: 1. Write all nodal equations describing this…

A: As per our guidelines we are supposed to answer only 3 subparts. Kindly repost the other parts in…

Q: For the circuit shown below in Figure 1, derive the Norton equivalent circuit at the load resistor,…

Q: 4.55. A 4 kilo-ohm resistor is placed in parallel with the current source in the circuit. Assume you…

A: Given: A 4 kilo-ohm resistor is connected in parallel with the current source 'i'.

Q: Find the value of the voltage v in the network of Fig. 2.47.

Q: 1. The power consumed by the R3 resistor in the circuit given below, c. Calculate by Thevenin's…

Q: Using Mesh current method solve the actual voltages of 4 0,10 Q and 50 and actual current of 2 2 and…

A: The given circuit diagram is:

Q: Estimate the power dissipated in the resistor, 62 using Thevenin's theorem.

Q: Using the superposition theorem, 1- find Vo in the circuit , 2- the power ? absorbed by the 2 ohm

A: First we took the current source as 0 Then the circuit will be For this VOVo=2(2+3+5)* 12Vo=2.4 V…

Q: Find the Thévenin equivalent circuit for the portions of the networks external to points a and b.…

A: Calculate Thevenin voltage Vth across terminal ab: Apply voltage division:…

Q: b. A 3A current source is now attached across the 6-N resistor as shown in Figure 2.2, With switch…

Q: Obtain the node voltages in the circuit of Fig. 3.4. Practice Problem 3.1 1 2. Answer: v, = -6 V, v2…

Q: There are five electric appliances, viz. electric heater, electric lamp, an electric fan,computer…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: The source voltages vgl and v2 in the circuit in (Figure 1) are 12 V and 8 V, respectively. Part A…

Q: Dr. Yaseen H. Tahir We can note that IL and VL are same in both cases. Example: a) Convert the…

Q: Open Circuit Simulator App, Click on circuits tab on the top and select Blank circuit. Draw the…

Q: Calculate the power dissipated in each resistor in the circuit below using Mesh Analysis.

Q: 2/ Using Superposition theorem, determinethe current thcough q resistor.

A: The superposition theorem states that for a linear system the response in any branch of circuit…

Q: Using norton’s theorem and source conversion technique, compute the current through the 1 ohm…

Q: 4. Determine the Norton equivalent circuit for the network external to the 6 ohm resistor. R1 ll

A: The Norton's Equivalent circuit can be determined as follows.

Q: 1. For the circuit shown, a) What value of a is required for the interconnection to be valid? b) For…

Q: Consider the circuit given below. 10 Ω 5 A(1 4Ω 17 Q If V= 2 V, obtain a numerical value for the…

A: To find the mesh current i3 and power dissipated in 1 ohm resistor

Q: Example (1): Find the Norton equivalent circuit for the network in the shaded area, then calculate…

Q: Use the node-voltage method to calculate the power delivered by the dependent voltage source in the…

Q: Find the Norton equivalent circuit for the network in the shaded area of figure below

Q: 3. Calculate the mesh current 11 for the circuit below. *

A: The required mesh current can be calculated by using the mesh analysis of the given circuit. The…

Q: Using, necessarily, the superposition method, calculate the voltage that is applied on the terminals…

Q: 3.3 Homework: 1- Use KCL to obtain currents i,, i2, and iz in the circuit shown in below figure. 12…

Q: Explain your reasoning for each step of the analysis in detail. a) Determine the value of each of…

Q: 3. For the network in Figure 3 below, (a) Evaluate the value of the equivalent resistance, R for the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 7. The light bulb in the circuit below is rated 120-V, 0.75-A. Calculate the source voltage (Vs)…

A: In this question we will find source voltage....

Q: 0 For the circuit shown in figure (2), by using mesh analysis, 1-Find the current through the ( ,,l;…

Q: 1. In your circuit generators, measure: I, Vi, V2, V3, I1, I2, I3 2. Theoretically, calculate: I,…

Q: A voltmeter of sensitivity 1200QN, connect in parallel with the resistor reads 120V. The full scale…

A: Note: As image is not clean, it is confusing to identify the value of full scale of voltmeter ,…

Q: Determine the Norton equivalent of the given circuit as seen by terminals a and b. (There should be…

A: Norton's Theorem states that it is possible to simplify any linear circuit to an equivalent circuit…

Q: ote: Round off your answer in two decimal places. A. Find the Thévenin equivalent circuit for the…

Q: Make a solution by applying the mesh current method to the circuit below.

Q: 3. Sketch the schematic and then calculate the total equivalent resistance for a circuit described…

A: We need to draw schematic for given resistor combination and we will find out equivalent resistance.

Q: 17. Obtain the equivalent resistance Rab in each of the circuits given. (Note: in the second…

Question

4.- For the circuit in the figure shown, use superposition to find i. Calculate the power supplied to the 3 Ω resistor.

Note:
(the final answer is in the images as verification)

4.15 Para el circuito de la figura 4.83 use la superposición para
hallar i. Calcule la potencia suministrada al resistor de 3 0.
ps
12
2 A
+,
20 V
16 V
ww
ww
2.

iz = [1/(1 + 13/2)]2 = 3/8 = 0.375
i = 2.5 + 0.375 - 1 =
1.875 A
p = i'R = (1.875)'3 = 10.55 watts

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Determine the color codes required if you need the following resistors for a project: a. 1.2 kΩ ± 20 % , 0.1% reliability b. 820 Ω ± 10%, 0.001% reliability c. 3.3 MΩ ± 5%, 1% reliability
Hi, for the attached question if he asked for Rth between a and b, it will be Rth= 12//6//7 =28/11 ohms?
If IC=3.95mA and IB=50µA, then IE calculates out to be: a 3.45mAb 4mAc 79mAd .075mA
R-L-Series CKT.show your solution
The value of R to be used is 4 ohms. please use nodal if possible
QUESTION 4 What is the total area for the following Copper wire run? Three-3/0 AWG type THW Stranded One-2 AWG type THW Stranded One -6 AWG type THW Stranded a 0.5176 in² b 0.9702 in² c 1.141 in² d 0.4344 in²
V=6V, R1=2kOhm, R2=2kOhm, C=5.5nF Please answer in typing format please ASAP for the like please clear
In the circuit given below R=4Ω and R=10Ω as they are defined as; RL to load resistor How many watts is the maximum amount of power that can be transferred?NOTE: Please enter your answer as 2 digits after the comma.
I know Vx is 5.049 and Ix is NOT -2.27
Question Vvv Bartleby guideline both question all part work u
Voltage V1 and current thru R1 current thru R2
What is the voltage will produce 3A through a circuit that has 15ohms of resistance?