Completely solve and box the final answer. Write legibly 2. Calculate the convective heat transfer in KW from air to the circular tube 7.7 meter long with an inside diameter of 127.7 mm. Tube’s temperature along the entire length is 27.7ºC. The average temperature of hot air flowing through the tube is 127.7ºC. Convective film coefficient is 27.7 W/m2-ºK.

Completely solve and box the final answer. Write legibly 2. Calculate the convective heat transfer in KW from air to the circular tube 7.7 meter long with an inside diameter of 127.7 mm. Tube’s temperature along the entire length is 27.7ºC. The average temperature of hot air flowing through the tube is 127.7ºC. Convective film coefficient is 27.7 W/m2-ºK.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.36P

See similar textbooks

Similar questions

Select the letter of the correct statement. Write the answer with calculations, drawing, rules or explanation 2-) A scientist suggests the following correlation be used for square tubes in a liquid cross-flow situation (Nu = 0.102 Re0.675 Ppl/3). Water (k = 0.61 W/m.K, Pr= 6) flows across a 1-cmsquare tube with a Reynolds number of 10,000. The convection heat transfer coefficient is:(A-) 5.7 kW/m?.K(B-) 8.3 kW/m?.K(C- ) 11.2 kW/m?.K(D-) 18.1 kW/m?.K.
Completely solve and box the final answer. Write legibly. 9. A steam pipe having a surface temperature of 573 K passes through a room where the temperature is 25C. The outside diameter of pipe is 0.11 m and emissivity factor is 0.69 . Determine the radiated heat loss for a 5 m pipe length.
Water at temperature of 20 °C is flowing inside a straight, smooth pipe with flow rate of 0.05 m3/h . With which pipe diameter will the flow transition from laminar to turbulent? Kinematic viscosity of water at 20 °C is 1.005·10-6 m2/s. Round off the answer to one decimal digit in cm, but enter the answer without the unit.
Two endlessly long flat plates, separated by 3 inches in distance but with a thickness of 5 inches, each transport alcohol (5 m/s, 1 Pa·s, S.G. 0.89 (ref. water at 4 degrees Celsius) to a given location with a specific velocity. Prove that the Reynold's number of the following problem is a value approximately around 90-100.
For the flow geometry from the top of a flat plate, the velocity profile around the plate is given as v (y) = ay+by^2-cy^3, and the temperature profile as T (y) = d+ey+fy^2-gy^3. Derive the mathematical expressions that give the regression coefficient and the heat transfer coefficient. CREATE THE KNOWN AND UNKNOWN BY DRAWING THE SHAPE OF THE ORGANIZATION AND WRITE ALL THE ASSUMPTIONS IN DETAIL
Topic: Heat transfer Completely solve and box the final answer. 1. A 20degC water flows to 50cmx60cm flat plate with velocity of 5.2m/s . The flat plate surface temperature is maintained at 40deg C. The air flows parallel to the 50cm side of the plate. If the kinematic viscosity of water is 78x10-8 m2/s, at what length the flow become turbulent?
Topic: Heat transfer Completely solve and box the final answer. A 20degC water flows to 50cmx60cm flat plate with velocity of 6m/s . The flat plate surface temperature is maintained at 40deg C. The water flows parallel to the 50cm side of the plate. If the kinematic viscosity of water is 78x10-8 m2/s, What is the local heat flux (Q/A) at the end of the plate (k=0.72 W/m deg C, Re=3840000, and Pr=0.7)?
Air flows inside a tube 60 mm in diameter (d) and 2.1 m long (l) at a velocity w = 5 m/sec. Find the heat-transfer coefficient α if the mean air temperature tf = 100oC. Note: Write your answer in space provided without the unit (the answer is in kcal/m2-hr-oC, one decimal places)
Liquid biofuel (density= 789 kg/m3) is being pumped from a storage tank through a pipe with 1-inch innerdiameter (ID). The fuel is being pumped at a rate of 3.00 gallons per minute. In this process, what is thekinetic energy transport rate (Ėk) in units of horsepower (hp) and ft•lbf/sec.
An expression for the laminar velocity profile on a flat plate is u=C1sin(C2y)+C3 Where the argument of the sine function is in radians. Using the three common physicalconditions that the velocity profile should satisfy, determine a) the constants C1, C2, and C3.b) the nondimensional velocity profilec) the boundary thickness (δ/x) as a function of lengthd) the skin friction coefficient, Cf as a function of lengthe) displacement thickness (δ*/x) as a function of lengthf) the momentum thickness (θ/x) as a function of lengthg) the drag force (FD) on both sides of the plate
Solution on all other sites including this site are wrong Only attempt if previously not attempted. Answer part a and b A) Among the nondimensional numbers, in free convection, average Nusselt number depends on only Grashof and Prandtl numbers. only Grashof number. Rayleigh number. Reynolds number. B) For ideal gases, the specific heat capacity at constant pressure, thermal conductivity, dynamic viscosity, and Prandtl number are independent of pressure. How will the ratio of thicknesses of velocity boundary layer and thermal boundary layer change if pressure is increased from 1 atm to 5 atm for the flow of an ideal gas over a flat plate? We need to know the actual fluid properties to tell It will remain the same. It will decrease by a factor of 5. It will increase by a factor of 5.
If forced convection uses Reynolds number to account for fluid movement during forced convection, what dimensionless number is used for natural convection? A. Nusselt number B. Einstein number C. Grashof number D. Prandtl number