You receive a compliant that some of the web-servers are no longer accessible. You attempted to ping the servers and find them to be reachable. Then you type the IP address and then you try on the browser, and discover it to be accessible. But they are not accessible when you try using the URL. What may be the problem? 2 Traffic is Blocked on TCP Port 53 O E Traffic is Blocked on UDP Port 54 O Traffic is Blocked on UDP Port 53 2 Traffic is Blocked on UDP Port 80

You receive a compliant that some of the web-servers are no longer accessible. You attempted to ping the servers and find them to be reachable. Then you type the IP address and then you try on the browser, and discover it to be accessible. But they are not accessible when you try using the URL. What may be the problem? 2 Traffic is Blocked on TCP Port 53 O E Traffic is Blocked on UDP Port 54 O Traffic is Blocked on UDP Port 53 2 Traffic is Blocked on UDP Port 80

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter7: Setting Up A Local Network

Section: Chapter Questions

Problem 5TC

See similar textbooks

Similar questions

On the receiver's return, I want all TCP traffic from my internal network to pass via the firewall. This traffic is allowed by what rule? Port 80/HTTP Standard Established ICMP
You are troubleshooting an issue and you think that it is a problem with the DHCP server configuration. Client get an IP address, they can ping IP addresses on the same network and on the internet, but they cannot pull up webpages. What is a likely cause of misconfiguration on the DHCP server? a.) incorrect ntp server b.) incorrect dns server c.) incorrect gateway d.) incorrect subnet mask
I want all TCP traffic originating from my internal network to be allowed back through the firewall on its return from the receiver. What kind of rule will allow this kind of traffic? Port 80 / HTTP Standard Established ICMP
What does a cybersecurity analyst know about their target if they receive a RST packet back from a target host? The target is using UDP rather than TCP. The target expects the PSH flag to be set. The destination port is open on the target host. The source port in the RST message is closed. Which one of the following could a cybersecurity analyst enumerate using wpscan on a WordPress site? Administrators Plug-ins Posts Versions What program would a cybersecurity analyst use to enumerate services? enum4linux Nmap Snmpwalk Smbclient
From your laptop, you need to remote into a switch to make some configuration changes.Which Transport layer protocol and TCP/IP port should you open in Windows Firewall tomake this work using Telnet?a. UDP, port 23b. TCP, port 23c. UDP, port 22d. TCP, port 22e. UDP, port 21
a)Write command-set that could configure a switch’s IP address 192.168.1.5 255.255.255.0 on vlan1. b)Write commands to configure a router’s IP address 192.168.1.1 255.255.255.0 on interface fa0/1.