Consider a 1,5m wide rectangular channel carries a discharge Q(m3/s). It is further observed from the specific energy curue that for the particular specific energy, the subcritical and supercritical depth is observed to be 0,5 m and 1,2 m respectively, The discharge (Q) in a rectangular channel will be m3/s. --

Consider a 1,5m wide rectangular channel carries a discharge Q(m3/s). It is further observed from the specific energy curue that for the particular specific energy, the subcritical and supercritical depth is observed to be 0,5 m and 1,2 m respectively, The discharge (Q) in a rectangular channel will be m3/s. --

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A wide rectangular channel excavated from clean earth with n=0.013 carries a unit of discharge of 4 m3/s per meter. a. Determine the critical depth. b. Determine the minimum specific energy in m. c. If the depth of flow is 1m, calculate the slope of energy line for normal flow conditions.
A 2.5 m wide rectangular channel has a specific energy of 1.5m when carrying a discharge of 6.48 m3/s. Calculate the alternate depths and the corresponding Froude numbers. [Note: This problem needs trial and error solution procedure.]
the celerity of the pressure wave is 976 m/s instantaneously in a 600 m long pipe from a reservoir with a diameter of 1.20m. The flowrate is initially 0.85 cu m/sec of water. Compute the water hammer at the valve if it is closed in 4 sec
A large tank contains water to a depth of 95cm. The water discharges from a sharp edged orifice of 39mm diameter and is collected in a circular tank of 515mm diameter. The water level in the cylinder rises 753mm in 3.2minutes. Calculate the discharge coefficient for the orifice.
Water on the horizontal apron of the 30 m-wide spillway shown in Fig. E10.8a has a depth of 0.2 m and a velocity of 6 m/s . Determine the depth, y,, after the jump, the Froude numbers before and after the jump, Fr, and Frz. ba width = 30 m Spilway apron V=6 m/s V=0.2 m Downstream
6. A 26-cm well penetrates 38 m below static water level (GWT). After a long period ofpumping at a rate of 2200 lpm, the drawdowns in the observation wells at 16 m and 38 mfrom the pumped well are 1.5 m and 0.8 m, respectively. Determine the following:a. the transmissibility of the aquiferb. the drawdown in the pumped well assuming R = 350 mc. the specific capacity of the well
For a wide open rectangular channel, if the critical velocity is 6 m/s, 1. What is the critical depth, in m. 2. Compute the minimum specific energy, in m. 3. Determine the critical flow if the width of the channel is 3 m, in m3 /s Solve all parts and correct answer
Pumping with a radius of 25 cm opened in an aquifer with an average thickness of 33 m with a free surfaceWhen the flow rate of 39.57416734 lt/sec is withdrawn from the well for a very long time, one of the pumping wells is 43 m and the otherThe water levels in the observation wells at a distance of 183 m are 30.66859298 m and 32.2787432 m, respectively.determined. The hydraulic conductivity of the aquifer (m/s) according to the data given in the Question 4 data sheet,the pumping well descent (m), optimum level descent (m) and optimum flow (lt/s)calculate.
Total head (energy) is constant along a pipe system and is 25 m. At Point B, the flow rate is 1.2 m3/s where the rectangular pipe has a height of .5 m and a width of .4 m. What is the static head at Point B, in m?
A 7350 m long, 1050 mm concrete pipeline connects an upstream reservoir (watersurface elevation 433.3 m) to a downstream reservoir (water surface elevation 423.1 m). Adischarge valve at the downstream end is used to control flow; when this valve is fully open,the measured discharge in the pipeline is 920 L/s under the naturally available head difference.(a) Assuming fully developed turbulent flow and that all other local losses are negligible,estimate the loss coefficient k for the fully open valve (assume f = 0.015).(b) Because of increasing urban development, the flow under the natural head difference isconsidered to be inadequate and it is proposed to increase this flow with pumping. The head-capacity curve for the pump can be approximated by the equation H = 8 – 3.5Q2 in which H isthe total dynamic head on the pump (in m) and Q is the discharge (in m3/s). What is thedischarge that can now be obtained from the system where the pump is installed at a cross-section of the pipeline?
A 45 cm well in an unconfined aquifer of saturated thickness of 45 m yields 600 lpm under a drawdown of 3.0 m at the pumping well, (a) What will be the discharge under a drawdown of 6.0 m? (b) What will be the discharge in a 30 cm well under a drawdown of 3.0 m? Assume the radius of influence to remain constant at 500 m in both cases
A tube well of 30 cm dia. is installed in a confined aquifer having 20 m thickness . Two observatory wells are installed at a distance of 120m and 160m from the center of main tube well. Under the constant Pumpage rate of 1500 L/min, the observed water depth in the observatory wells is 58m and 59m respectively. The radius of cone of depression was 300m and depth of water (H) at zero drawdown is 65 m. With the above data calculate: 1) Co-efficient of transmissivity (T) and Co-efficient of Permeability (K).