Consider a computer that does not have a TSL instruction, but does have an instruction to swap the contents of a register and a memory location in a single indivisible action. Can that be used to write a routine enter-region such as that used with TSL? Give pseudocode for this routi

Consider a computer that does not have a TSL instruction, but does have an instruction to swap the contents of a register and a memory location in a single indivisible action. Can that be used to write a routine enter-region such as that used with TSL? Give pseudocode for this routi

Name: Consider a computer that does not have a TSL instruction, but doeshave
Uploaded: 2024-03-20T06:51:23.000Z
Channel: Bartleby
Description: Consider a computer that does not have a TSL instruction, but doeshave an instruction to swap the contents of a register and a memorylocation in a single indivisible action. Can that be used to write a routine enter-region such as that used with TSL

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter4: Processor Technology And Architecture

Section: Chapter Questions

Problem 2PE: If a microprocessor has a cycle time of 0.5 nanoseconds, what’s the processor clock rate? If the...

See similar textbooks

Similar questions

When a central processing unit (CPU) produces an interrupt, the processor is compelled to stop whatever it is working on in order to react to the signal that has been received. It has piqued my interest to learn more about the reasoning for pausing the procedure in order to finish the assignment. Let's begin by going through the steps involved in the process of interrupting, and then we'll move on to the steps involved in the process of executing. Explain?
What happens if VA page 30 is written even if an instruction was not accepted? An instance of a software-managed TLB would outperform a hardware-managed TLB in the following cases:
An interrupt from a CPU causes the processor to halt what it is doing and react to the signal received from the interrupt source. In order to finish this work, why should the operation be stopped? Let's start with the process of interrupting, and then go on to the process of executing the interrupting. explain?
What happens if an instruction is written to VA page 30 before it has been approved? In the following contexts, a TLB that is maintained by software would be more efficient than one that is handled by hardware:
MARIE saves the return address for a subroutine in memory, at a location designated by the JnS instruction. In some architectures, this address is stored in a register, and in many it is stored on a stack. Which of these methods would best handle recursion? Explain your answer. (Hint: Recursion implies many subroutine calls.)
Because of this, the CPU suspends any currently executing processes until the interrupt has been resolved. Interrupt service is the term used to describe this. What is the rationale for halting the procedure that is presently in progress? Isn't it possible, as an alternative, to just finish the presently operating operation and deal with the interruption afterward?
Assume that the state of the 8088’s registers and memory just prior to the executionof each instruction in problem 15 is as follows: * in photos*What result is produced in the destination operand by executing instructions (a)through (k)? *only h through k* (h) MUL DX(i) IMUL BYTE PTR [BX+SI](j) DIV BYTE PTR [SI]+0030H(k) IDIV BYTE PTR [BX][SI]+0030H
When a CPU interrupt occurs, the processor stops its current operation and reacts to the signal. Why should the operation be halted so that this may be performed? Let's begin with the process of cessation and then proceed to the procedure of execution. Explain?
For a computer's instruction set to be considered orthogonal, it must be able to produce a "backup" instruction for each main instruction. If I'm incorrect, someone please tell me.
Do you know what would happen if an instruction was rejected? When compared to a hardware-managed TLB, a software-managed TLB is quicker in the following scenarios:
Suppose we enhance a machine making all floating-point instructions run sixtimes faster. The execution time of some benchmark before the floating-pointenhancement is 20 seconds. What will the speedup be if 8 seconds is spentexecuting floating-point instructions (before the enhancement)?
For a microprocessor 68000 Motorola system, how many memory addresses which can be accessed by it? Prove it and justify the last address of the memory location. Then, sketch the memory map of it by using the address calculated.