Consider a gas discharge tube (like the one used to discover cathode rays) where low-density hydrogen gas is enclosed. We recall that atoms are excited from the ground state. What minimum voltage should be applied to the electrodes in order to produce the a) The 1st four long wavelengths observed in the Balmer series. b) Which one(s) of the assumptions of Bohr describes best this problem?
Q: For a diffraction grating of 650 lines / mm, we detect the fourth order diffraction at the angle of ...
A: Given: The diffraction grating of is N=650 linesmm=650 linesmm×1000 mm1 m=650000 linesm. The order o...
Q: A 20-g mass is moving in the +x-direction at 50 cm/s, while a 4.0-g mass is moving in the –x-directi...
A: Given Data:Let:m1=20 g=0.02 kgv1i=50 cm/s=0.5 m/sv1f=30 cm/s=0.3 m/sm2=4 g=0.004 kgv2i=20 cm/s=0.2 m...
Q: What is the Poynting vector of an EM wave in vacuum and what properteis of EM wave does it represent...
A:
Q: The reaction below shows an interaction between a quark and a lepton. The X represents an unknown pa...
A: a. the answer to this part of the question depends on the type of quark given "d", (its type is not ...
Q: Consider the long (L> b) cylindrical shell of inner radius a = R and outer radius b = 3R as shown in...
A: Given, Permeability of free space,μ0=4π×10-7T.m/ARadius,r=b-a=3R-R=2R=4cm=4×10-2mCurrent,I=1A We hav...
Q: You have a telescope that consists of two converging lenses which are placed a distance apart which ...
A: The ray diagram for the telescope with longer focal length lens as objective lens and shorter focal ...
Q: Two long straight aluminum wires, each of diameter 0.40 mm, carry the same current but in opposite d...
A: Given3 density of aluminum = 2.7 gm/cm3 =2700 kg/m g = 9.80 m/sec2 l = 1 md = 0.4 mmso r = d/2 = 0.4...
Q: Help needed part A b thanks in advance
A: Given, Focal length, f=25 cm a. Object distance, u=p1=26.1 cm Let image distance be v. From lens equ...
Q: d. A carbon resistor is to be used as a thermometer. On a winter day when the temperature is 32°F, i...
A: The resistance for a varying temperature can be written as; R=Rref1+α∆There, Rref resistance at the ...
Q: a) First order special relativity corrections to the energy levels of a one dimensional harmonic osc...
A: First order special relativity correction to the energy is given by Er=-12mc2[E2-2E<V>+<V2&...
Q: O THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN BELOW. vo An electron at point A as sho...
A: Given data: vo=2.9×106m/s, distance between A to B=6(cm) radius=3(cm)=0.03(m) mass of electron, me=9...
Q: an isolated atom of a certain element emits light of wavelength 520nm when the atom falls from its f...
A: Given, Planck's Constant,h=6.626×10-34JsSpeed of light,c=3×108m/sWavelength from fifth to second exc...
Q: A 60.0-cm length of wire carries a current of 10.0 A. It is bent into an equilateral riangle loop an...
A: Given Length of wire=60cm Current=10A Magnetic field=0.750T
Q: An electric generator contains a coil of 100 turns of wire, each forming a rectangular loop 50.0 cm ...
A: Induced EMF or electromotive force is the potential difference developed in a coil due to change in ...
Q: Kindly answer 13.77. Thank you.
A: Given Current (I) = 200 A Time duration (t) = 6 hours Voltage (V) = 0.30 V
Q: homework help
A: The given two waves given as A and B are traveling in the opposite direction having same amplitude f...
Q: μ_0 = 4π×10^(−7) T.m/A
A: Given, Seperation distance,d=1mAngle,θ=40Diamter,D=0.40mm=0.40×10-3mDenisty of aluminium,ρAl=2.7g/cm...
Q: 27 charged water drops each with a radius of 2 mm and a charge of 10-11 C merge into a single drop. ...
A: Let 'r' be the radisu of each small drop and R is the radisu of the big drop Since the Volume is co...
Q: Enumerate the microstates of p3. Determine the MS and ML values for each microstate.
A: We know that, ML=∑mli=ml1+ml2+ml3 where, ml1= +1 0 -1ml2= +1 0 -1ml3= +1 0 -1 -...
Q: The segment of wire in the figure caries a current of I=8.00 A, where the radius of the circular arc...
A: The current carried by the segment of wire is given as, I = 8 A The radius of the circular arc is gi...
Q: Solve for the fixed-end moment at the left support of the restrained beam shown. Say EI is constant.
A: From figure,MA=Pab2L2and, MB=Pa2bL2
Q: need soon will upvote
A: Given: To find the expected time of the atoms and at least one of the two to decay as,
Q: Please solve part b accurate
A: Given, f1=-25 cmf2=10cmd=30cmu1=-80cm
Q: The visible light of wavelength 4000 Å undergoes scattering froma diamond crystal of refractive inde...
A: Given: λ=400A°n=2.42v0=1.2×104m/s
Q: The block of 4 kg mass shown is initially at rest on a smooth plane. A force of F = 3t2 + 2t + 4 (N)...
A: Here, we use Newton's second law to get the required.
Q: A 40 kg box has an initial velocity of 6 m/s down a 30-degree inclined plane at an initial height of...
A: The free-body diagram for the problem is shown below: According to the conservation of energy, we h...
Q: The figure shows the light intensity on a screen behind a double slit. The slit spacing is 0.220mm a...
A: The width of mth maximum in a double slit interference experiment is given by, y=mλDd (1)d...
Q: Three long, parallel, straight wires each carrying a 8.0 A current pass through the vertices of an e...
A: Given, Current, I=8 A Length of the wire, L=8 cm=0.08 m The magnetic field vector on B are,
Q: A 22-MHz clock signal is used into a 4-bit Ripple counter (Frequency division) circuit. What will be...
A: Given that:4-bit ripple counterf=22 MHz
Q: 6. Consider a planet of mass m in orbit about a star of mass M. Since M >> m, we can assume the star...
A:
Q: You are one of two identical twins and you decide that you want to be 9.00 years younger than your t...
A:
Q: Consider the long (L> b) cylindrical shell of inner radius a uniformly distributed over the cross se...
A: Given,inner radius a=R=1.8cmouter radius b=3R=3×1.8cm=5.4cmcurrent I=3A
Q: For a diffraction grating of 650 lines / mm, we detect the fourth order diffraction at the angle of ...
A: Using:2dsinθ=nλ------(1)where,d is the distance between slits.θ is the angle of emergencen is the or...
Q: A steel ring of 3.000 cm inside diameter at 20°C is to be heated and slipped over a brass shaft meas...
A: Inner Diameter of steel ring, dring=3.0 cmDiameter of brass shaft , dbrass=3.002 cmInitial temperatu...
Q: How I got this equation from Brnoli
A: Assume a tank filled with fluid up to a height h1 & denote the velocity of water at its free sur...
Q: A 60.0-cm length of wire carries a current of 10.0 A. It is bent into a square loop and placed with ...
A: Torque on the given square loop is: ζ =NIAB sinθhere N = number of turnsI = currentA = area of the ...
Q: Under the action of its stern and starboard bow thrusters, the cruise shiphas the velocity vB = 1m/s...
A: Given: VB=1 m/sw=1 k^=1×π180k=π180k rad s
Q: The boxes are initially moving, m, going up and m, going down the incline. In order to prevent the b...
A: Free body diagram:
Q: The reaction below shows an interaction between a quark and a lepton. The X represents an unknown pa...
A: solution (a). conserve the charge on both sides of the given nuclear reaction. 1+1=X+0X=2 therefore...
Q: Two long, straight conducting wires with linear mass density A are suspended from cords so that they...
A: Solution: initial speed v0=μoQ2/(4πλdRC) Q = charge on the capacitor plates = CV=2.6×10-6×2.8×103=...
Q: A partide with charge q = 1.1 C and a long wire carrying current I = 5 A is on the ry-plane at the m...
A: When a conductor carrying current within it, it creates a magnetic field in its near vicinity. The v...
Q: Two flasks are connected by an initially closed stopcock. In flask contains 250cm^3of kryptonite at ...
A: P1=500mmHgP2=950mmHgV1=250cm3V2=450cm3Vf=250+450=700cm3kryptonite final pressurePk=P1V1Vf=500×250700...
Q: The magnetic flux through a metal ring varies with time t according to 5(at3 – bt?)T m², with a = Pg...
A: Given that,The magnetic flux (φB) = 5 (at3 - bt2) T.m2a = 1.00 s-3b = 6.00 s-2The resistance of the...
Q: The segment of wire in the figure carries a current of I-3.00 A, where the radius of the circular ar...
A: Given: I=30A R=1.0cm
Q: A charged particle moves into a region of uniform magnetic field, goes through half a circle, and th...
A: Given, Mass of Proton,mp=1.672×10-27kgMass of Electron,me=9.11×10-31'kgTime,t=130ns=130×10-9sCharge,...
Q: A man is attempting to lift a crate using a two part pulley system as shown in the image. The crate ...
A: Given data: Mass of the man m1=75 kg. Mass of the block m2=53 kg. Force applied by the man F=659 N....
Q: A wire 60.0 cm long is held parallel to and 100 cm above a long wire carrying 100 A and resting on t...
A: Induced EMF is the potential difference created on a conductor due t change in magnetic flux through...
Q: the atom 170 74 W decays to 170m 73 Ta by emitting what kind of nuclear radiation? alpha bet-minus x...
A: The atom W74170 decays to T73170a. In this reaction Z is decreased by one. This implies, it is β+Dec...
Q: The two most prominent wavelengths in the light emitted by a hydrogen discharge lamp are 656 nm (red...
A: Given The wavelength of red light = 656 nm The wavelength of Blue light = 486 nm Diffraction ...
Q: The magnetic flux through a metal ring varies with time t according to PB = 3(at³ – bt2²)T · m², wit...
A: Given, ϕB=3at3-bt2
Consider a gas discharge tube (like the one used to discover cathode rays) where low-density hydrogen gas is enclosed. We recall that atoms are excited from the ground state. What minimum voltage should be applied to the electrodes in order to produce the
a) The 1st four long wavelengths observed in the Balmer series.
b) Which one(s) of the assumptions of Bohr describes best this problem?
Step by step
Solved in 2 steps