Consider a lead network with a lower frequency break of 800 Hz. Calculate the frequency at which the gain will be -24.6 dB?

Q: The most commonly used relay, for protection of an alternator against loss of excitation is a mho…

A:

Q: Can you name a few potential uses for the logic synthesis device?

A: Sure! Here are a few potential uses for a logic synthesis device: Design and optimization of…

Q: Question 7 if is modulated using a SSB-AM technique a carrier: X What is the power of the…

A:

Q: Draw the output voltage waveform of the circuit shown. Label properly the values. 0 Vm T T t Vi www…

A: We need to find out output for given circuit.

Q: A MOD 2 and a MOD 5 up counter when cascaded together results in a MOD counter.

A:

Q: Model the following transfer function on Matlab and Simulink and find its response to a step input.

A:

Q: 2. Find the state equations for the translational mechanical system shown below. 0000 Frictionless…

A:

Q: Answer the following questions: 1. Simplify the function below using a three-variable K-Map. F…

A:

Q: 2. Find v(t) and i(t) for all t. 10 u(t) A 10 Ω Μ 5Ω 0.2 F – 14+

A:

Q: Vi=ult)-u(+-+) V Section 13.6 13.61 A rectangular voltage pulse v[u(t)- u(t-1)] V is applied to the…

A:

Q: Find Zal in the four-way power divider circuit in Figure P6 Assume each element is 152. شوه b O 1 w…

A:

Q: Ex:1 Find the resistance that gives off 144 W of heat when the current through it is 2.0 A rms.

A:

Q: Using the partial fraction expansion method, find the inverse of the following z-transforms: 1 a.…

A: Given: X(z)=1z2-0.3z-0.24, To find: Inverse z-transform using partial fraction expansion method.…

Q: Design the power supply using diode components. This power supply sholud have 2 outputs. 12Vdc and…

A: To design: The power supply using diode components. This power supply sholud have 2 outputs. 12Vdc…

Q: A three-phase cage induction motor is started by direct-on-line (DOL) switching at the rated…

A: Given: Three phase cage induction motor Started by Direct on line method, Starting current-…

Q: (2) In the circuit shown below, V₁-4v, V3-3v. Find V₂. (Hint, the voltage on the wire at the top is…

A: Apply KVL in a loop KVL states that the algebraic sum of voltages in a closed loop is zero.

Q: A 34.5 KV feeder line is 5 mi long. The conductors are spaced 4 ft horizontally. The conductor is…

A: Given data: voltage of line Vl=34.5 kV Length of feeder line l=5 mi Horizontal spacing =4ft GMR of…

Q: Find the overall transfer function R G₁ G₁ G₂ H₂ H₂ G₁ Figue

A:

Q: 3) For the difference amplifier shown, calculate a) Vout/Vini (assuming Vin2 is 0) b) Zin (impedance…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: can you please calculate the magnitude of i3 not just the equation

A:

Q: 2.41 Find the power spectral densities and average pow- ers of the following signals. (a) x₁ (t) = 2…

A: Given data (a) x1t=2cos20πt+π3 (b) x2t=3sin30πt (c) x3t=5sin10πt-π6 (d) x4t=3sin30πt+5 sin10πt-π6 To…

Q: The op amp in the noninverting summing amplifier of (Figure 1) is ideal. Consider vo = 4va + 3vb +…

A:

Q: Design a combinational logic circuit that shows the results for three people who votes. The three…

A: Given, A combinational logic circuit that shows the results of the voting of three people. The three…

Q: Problem 6: Given the following transfer function G(s) calculate the steady state value at t = ∞ 6 2s…

A: Solution: For the given transfer function G(s) calculation the steady state value at t=∞.…

Q: 13.9 Find i, (t) for t > 0.

A: It is given that:

Q: Draw the output voltage waveform. Identify the function of the circuit.

A: The given circuit is a biased clamper circuit. The clamper circuit will shift the waveform to a…

Q: Example 3. Determine v for the network of Figure 6. Example 4. Repeat Example 3 using Silicon diode.…

A: In  this question We need to determine the output voltage waveform.  If diode is ideal and silicon…

Q: How to test a PCB with just an oscilloscope and signal generator?

A: PCB is a printed circuit board, it has copper conductors on a board which creates electric…

Q: +24V 3822 www 1652 www. 4A 10052 H 7V 2022 A B

A: We need to find out thevenin and Norton equivalent circuit for given circuit, maximum power transfer…

Q: Create an Arduino program with the following condition. Print the states of the potentiometer and…

A: // Pin definitions const int potPin = A0; // Potentiometer pin const int led1Pin = 2; // LED 1 pin…

Q: 1. Determine the volta. 45 V I Eμ R₁ www 5kQ 7.5 k R₂ 00 E₁4

A: Given data, Circuit diagram is given as,

Q: A radio transmitter supplies a current of 8.0 A to an antenna system with an impedance of 500 Q with…

A: The formula for the apparent power in an AC circuit is given by: S = VI* where S is the apparent…

Q: 2. For the variable output supply shown in the following figure, what setting of R₂ would provide an…

A:

Q: In a series RLC circuit with R = 152, C = 20 µF and L = 55 mH connected to a generator. The maximum…

A: As per the guidelines we suppose to answer 3 subpart only

Q: In this circuit, what will be the voltage peaks of the output, if the input is 20Vp-p sine wave?…

A:

Q: +1 10 V Μ 10 Ω 2ib + Va |5| V1 V3 30 Ω 20α Η ww 20 Ω in 1A V2

A: We need to find out voltage and power for given circuit.

Q: Given a circuit having two ideal diodes: D1 and D2. The assumption that D1 is ON and D2 is OFF is…

A: option d is correct

Q: Ex: 2 Find the reactive power of an ideal 0.5 H inductor that draws 0.5 A from a 60 Hz source.

A:

Q: What is a thick film resistor ? list some applications where it used and how it is used.

A: We need to tell about thick film resistor.

Q: For R you've used 10 instead of 100 ?  also I don't understand why you've put 10+ 55.22 ohms I need…

A:

Q: Why is it important to maintain a rack clean of cables?

A: We need to explain why is it important to maintain a rack clean of cables.

Q: Given the following circuit: Assuming D1 is ON and D2 is OFF, with Vs1 = 12.6 V, VS2 = 1.3 V, R₁ =…

A: It is very simple diode problem ,  We need to find the current going through R2. Circuit:

Q: An audio signal having the highest frequency of fM = 15 kHz is input to a 16-bit A/D counter type…

A: Given: fM = 15kHz Number of bit ADC,n = 16 period of clock,Tc = 0.15μs Need to calculate the counter…

Q: Find VAB using mesh analysis

A:

Q: 1. For the following circuits, Find i. ii. iii. iv. Impulse response Transfer Function Identify…

A: Given:

Q: 0 Vm 72 T T {₁ R e +

A:

Q: Q3. Find the Thévenin equivalent with respect to the 7k2 resistor.

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: ㅓㅏ V1 5V 4 R1 4.1k2 R2 ww 1002 1 R3 ww2 5.00M2 Circuit 1 R4 3302 3 R5 470k2

A:

Q: 1. Why NAND and NOR gates are called the Universal gates?

A: 1. NAND (Not-AND) and NOR (Not-OR) gates are called Universal gates because they can be used to…

Q: A system is described by the following differential equation: d²x dt² +10- +20x=1 dx dt with the…

A: Given differential equation is as follows.

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.