consider a steam power plant operating .8 on the ideal Rankine cycle. The steam enters the turbine at 5 MPa, 350 oC and is condensed in the condenser at a pressure of 15 kPa. The thermal efficiency of the :cycle is

Q: A large movable plate (300 cm x 100 cm) is located between two large fixed plates as shown in Fig.1....

A: Given: μ1=20 cp=20*0.001=0.02 N.s/m2μ2=10cst=10 cp=10*0.001=0.01 N.s/m2U=14.4 km/hr=14.4*5/18=4 m/sb...

Q: C: Copper has an atomic radius of 0.128 nm, an FCC crystal structure, and an atomic weight of 63.5 g...

A: Given: Atomic radius =r = 0.128 nm = 0.1280 * 10-9  meter Avogadro number  = 6.023 * 1023 atom/mole ...

Q: o:I m3 of an ideal gas f 360 k and I bar is compressed adiabatıcally to8 bar. It is then cooled at c...

A: The ratio of heat capacities is considered. From this value and volumes, we will obtain the temperat...

Q: 1. Write mathematical expressions of the following a.Fraction conversion of reactant а. b. Yield of ...

A: Chemical reactions are not instantaneous but slow proceed. The fractional conversion describes the c...

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: Given: The ratio of sugar to water in feed is 1:3. Basis: 25 kg sugar and 75 kg of water entering th...

Q: Example: Calculate the MEABP of the petroleum fraction of petroleum cut has the following ASTM D86 D...

A:

Q: A liquid Phase reaction A2B is tuken place in a PER /CSTR, The feed stream Containing A Car =lo Kmet...

A:

Q: For steady state operation of turbine shown below find the power output if the flow rate of steam is...

A: Given data: Mass flow rate of steam = 6 kg/s Properties at the inlet of turbine are, P1 = 2 MPa T1= ...

Q: Water flows at a velocity of 3.0 m/s. Calculate the dynamic pressure, pd, by assuming that the densi...

A:

Q: Aromatic, anti aromatic, or non aromatic

A:

Q: a. What are the effects of the presence for sulfur compounds in crude oil? b. Explain the most accep...

A: As per Bartleby  multiple Sub-parts question guidelines, we are supposed  to answer only first 3 Sub...

Q: There is 1.36 kg of gas, for which R = 377 J/kg-K and k = 1.25, that undergoes a nonflow constant vo...

A:

Q: When Ca(OH)2 is dissolved in water, it is known that the enthalpy of solution (AHsoln) is -16.2 kJ/m...

A: Given data: Enthalpy of solution = -16.2 kJ/mol Mass of calcium hydroxide = 54 g Volume of water = 5...

Q: 630 g of water (Cp = 4.186 J/g-K) is heated to 49 ⁰C at constant pressure. The resulting change in e...

A:

Q: A-A storage tank for concentrated nitric acid will be constructed from aluminum to resist corrosion....

A: Given Inside diameter of the cover plate,d=8m Height upto which HNO3 filled,h=20m Density of conc H...

Q: The specific gravity of gasoline is approximately 0.70. (a) Estimate the mass (kg) of 50.0 liters of...

A:

Q: 1.) Air undergoes an Isentropic process where it expands. It is initially at 900K then the temperatu...

A:

Q: Classify the following compounds as to what organic group it belongs. Choices: alkane, alkene, alkyn...

A: Here present group is R-O-R where R is benzene .

Q: ОН ОН

A: IUPAC naming is to give consistency to the names. It also enables every compound to have a unique na...

Q: A 28.66 g sample table sugar is dissolved into 120.02 g solvent (MW = 56 g/mol) with a boiling point...

A: Given Details, mass of sugar dissolved, m =28.66 g mass of solvent ,M=120.02 g M.W. of solvent, Mb =...

Q: Q3) A: Give the crystal structure for the following metals. Fe , Ni , Pb , Cr , Al , Ag , Zn , Mo , ...

A:

Q: What is the value of Heptanes plus for retrograde gas? • greater than 20 mole percent O less than 12...

A: Mainly composition of retrograde gas are methane, light hydrocarbon (C2- C6), Heavy hydrocarbon (C7+...

Q: The minimum clear space between the edges of the opening in the screening surface and is usually giv...

A:

Q: A water contains a suspended solids concentration of 10.30 mg · L−1. Coagulation reduces this to 1.0...

A: Given Water changes(Mass flow rate,Qin=1.884 m3/s) Suspended solids(SS) concentration initially,Cin=...

Q: Because intermolecular forces can only be controlled at surfaces & interfaces. Because of the high s...

A:

Q: 1. Process integration definition and one example of the use of process integration

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: 4. Consider the voltaic cell which is based on the cell reaction: Zn(s) + Cutaa) Zna + Cus) Under st...

A:

Q: 4- Natural gas can be used in ?

A: To answer What is natural gas used for?

Q: An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of solution contai...

A:

Q: A large piece of that can be considered a SAm solid initially has a uniform temperature of 505.4 K. ...

A:

Q: During flash distillation, the feed mixture must be heated to a temperature _________ the temperatur...

A:

Q: PROBLEM 1. Compute the capillary effect of immersion in mercury of a glass tube of 6mm internal diam...

A: Given data: Internal diameter of tube = 6 mm Surface tension = 0.51 N/m Specific gravity = 13.55 Ang...

Q: 4). A 100-mL water sample is collected from the activated sludge process of municipal wastewater tre...

A:

Q: The velocity, V, of water approaching a sphere 5.0 cm in diameter, D, is 0.15 m/s. Calculate the Rey...

A:

Q: lnn intbedenigned ng miste conng le p eld le p 9tmle pe Caleulat les of evtd pdt fed plateihe feed i...

A:

Q: Q3) what is throat area of a venture scrubber if water is introduced at a rate of 103 cubic meter pe...

A: Given data: Flow rate of water = 10–3 m3/1 m3 Pressure drop across venture meter = 40 in H2O Velocit...

Q: The feed to a reactors contains 100kmol C,H4 and 100kmol 02. a) which is limiting reactant? C2H4 b) ...

A: Given that, 2C2H4 + O2 → 2C2H4O The number of moles of C2H4 in the feed nC2H4,F = 100 kmol The numbe...

Q: Calculate the frictional pressure drop in psf for a 50 % solution of glycerol with a density of 1.12...

A:

Q: The chemical reaction A → C + D is known to be second order with respect to the concentration of rea...

A: This problem is based on Chemical reaction Engineering. Data given : Reaction : A ---> C + D Over...

Q: 10 kg of oxygen contained in a closed container of volume 2m3 is heated without exceeding a pressure...

A:

Q: It refers to the ratio of the fugacity of a component in a real liquid solution to that of the fugac...

A: Given data It refers to the ratio of the fugacity of a component in a real liquid solution to that o...

Q: A-A storage tank for concentrated nitric acid will be constructed from aluminum to resist corrosion....

A: The chemical storage tank is an important storage container in industries. These are used to store h...

Q: B: Define the coordination number and its value for BCC unit cell.

A: The coordination number is the wide variety of ions that straight away encompass an ion of the contr...

Q: Explain Ideal reheat cycle and actual reheat cycle

A: In a reheat cycle, the expansion takes location in two turbines. The steam expands in the high-press...

Q: 2. A chromium metal was deposited coming from a solution of Cr. The amount of the said metal deposit...

A: (b) m= mass of the substance liberated at an electrode in grams = 2.19 gI= total electric current pa...

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: Given: The ratio of sugar to water in feed is 1:3. Basis: 25 kg sugar and 75 kg of water entering th...

Q: In a LPG fuelled truck, (85% propane and 15% butane by volume), 5% (by volume, dry) oxygen is measur...

A:

Q: Separation processes involving solid agents normally utilize __________.   a packed beds   b flo...

A: Introduction A separation process is a method that converts a mixture or solution of chemical substa...

Q: Design a two-phase horizontal separator for gas flow rate 40 ft'/s and oil flow rate 7000 ft'/s. The...

A: Procedure for Sizing Two-Phase Horizontal Separator 1) Calculate the Values of d, Leff that satisfy ...

Q: Q1/ Consider the system shown below. Determine the value of (K) and (K) so that the maximum overshoo...

A: