Answered: Consider a transmission line of…

Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one end by (+ j50) phm. The SWR produced by it on the transmission line vill be

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.36P

See similar textbooks

Related questions

Q: C- Considering the model of a medium length transmission line where the capacitive effect is equally…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL. According…

Q: Q1) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Given that Load impedance =80+j10 ohms Characteristic impedance=50 ohm frequency =550MHz

Q: A transmission line has a characteristic impedance of 50 ohm and a line resistance of 0.1 ohm/m. If…

A: Since the transmission line is distortion less, the attenuation constant of the line can be…

Q: Since a 50 ohm transmission line with phase constant (π/10) rad/m will be used at 500 MHz, what is…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: A transmission line has a characteristic impedance of 100 ohm and a resistance of 0.2 ohm/m. If the…

A: A transmission line can be characterized by 4 parameters:1. Resistance per unit length (R)2.…

Q: For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and…

A: If ZOC is the open circuit input impedance and ZSC is the short circuit input impedance of a…

Q: Q2: (Using Smith chart): Design lossless L-section matching circuits to match the load impedance of…

Q: C- Find the formulas of the ABCD constants considering the model of a medium length transmission…

Q: 3. If a transmission line with an impedance characteristic of 50 ohm is connected to a load with an…

Q: Q4: (Using Smith chart): A 100 2 transmission line connected to cellular phone antenna with load…

Q: The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm…

A: Given data:

Q: Given a telephone transmission line of 100 mile long has Zo=685-j92Q, a=0.00497 neper/mile and…

A: A telephonic transmission line is used to transmit data from one point to another point. The…

Q: A lossless 34-S transmission line is terminated in a load with ZL= (66+ j26) N. Use the Smith chart…

Q: lossless transmission line of length 1= = 502, is terminated in a load impedance gnal wavelength on…

Q: A lossless transmission line l = 0.3lambda in length was terminated with a complex load of ZL =…

A: Given Data: l = 0.3lambda ZL = 30-j20 ohms characteristic impedance for the line is Zo = 75 ohms

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: The magnitudes of the open circuit and short circuit input impedances of transmission line are 100…

A: Characteristic impedance (Z0) of a transmission line is defined as the impedance of the transmission…

Q: Q1/ Using the Smith Chart to calculate the variables below: a- Voltage reflected coefficient…

A: Using Smith Chart we need to calculate the variables below: a. Voltage reflected coefficient. b.…

Q: Consider an open – wire telephone line, which is 200 km in length, is terminated by - its…

A: The length of the wire = 200 km Generator frequency = 1 kHz Internal impedance of generator = 500…

Q: Q2: For A lossy short-circuited coaxial transmission line, find an input impedance if the…

A: Transmission line- The term transmission line refers to both overhead and underground cables. An…

Q: The voltage phasor along a finite lossless transmissionline of characteristic impedance Zo and…

Q: transmission line with an impedance of 35 Ω is connected to a load of impedance of 300 Ω, then the…

Q: has V, = 15/0° Vm Z, = A 40-m-long transmission line shown in Figure 30 + j60 N, and V, 5/-48° Vms…

Q: C- Considering the model of a medium length transmission line where the capacitive effect is equally…

A: In this question we need to draw a phasor diagram of the given transmission line.

Q: 2. The phasor voltage on a terminated transmission line is given by 1 -e-j2nz + +j2nz What is the…

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: Since the 35 ohm transmission line used at 2 GHz is terminated with a load impedance of 30.8(1 - j)…

Q: A line with 50ohm characteristic impedance is connected to a 10V generator with an impedance of…

Q: 7. Does the length of an ac transmission line affect the values of the characteristic impedance and…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: If the characteristic impedance of a transmission line is 30 ohms and the propagation constant j3…

A: We need to find out line impedance.

Q: 3. Expression for characteristic impedance Zo of a transmission line in terms of L and C the…

A: The solution is provided in the following section:

Q: 1. A certain transmission line operating at w = 106 rad/s has a = 8 dB/m, ß = 1 rad/m and Z, = 60 +…

A: According to guidelines, only the first question will be solved. If any other solution is needed,…

Q: Q4) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Load impedance ZL=150+j30 Ωcharacterstic impedanceZ0=50 ΩFrequency f=500 MHz

Q: Example: Transmitter devive broadcasting AM-DSB, if the total power is 5 kw at 0.6 modultion index…

Q: The transmission line has the following data weight of the conductor = 6.4 kg/m, Tension in the…

A: The correct answer is 63.04 m sag is given bys=wl28T In the above equation l=Distance between tower…

Q: A 100 ohm transmission line powered by a 1 GHz source and terminated with a load impedance of ZL =…

Q: A transmission line in air with characteristic impedance Z0=50 ohm is terminated with a load…

A: The propagation constant (k) of the transmission line can be computed in the following way:

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

A: Characteristics impedance of the given lossless network is determined as shown below

Q: A transmission line section shows an input impedance of 36 2 and 64 respectively, when short…

A: Given a transmission line has, Short circuit input impedance, Zsc=36 Ω Open circuit input impedance,…

Q: 5. A transmission line circuit with lossless 50N line is terminated with a load Z, =125 2. The…

Q: Vk(t)= 9cos2π * 10^6(t) volt Voltage of a lossless transmission line fed by its source parameters,…

A: For a transmission line, VsIs=coshγlzcsinhγl1zcsinhγlcoshγlVrIr Propagation constantγ=zy=α+jβ…

Q: A lossless transmission with characteristic impedance of Z0 = 1002 and length = 52cm The line was…

Q: A load impedance of 40 + j70 Ω terminates a 100 Ω transmission line that is 0.3λ long. Find the…

Q: Draw a Lattice diagram each for transient currents and transient voltages that are propagating at…

A: Given data is shown below. V=1.25×108μsl=250mt=10μsVg=15∠10°Zg=145∠25°

Q: A 75N lossless transmission line is terminated with a load impedance equals to 105-j1502. The length…

A: consider the question;

Q: (Using Smith chart): A 100 N transmission line connected to cellular phone antenna with load…

Q: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

A: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

Concept explainers

Electric field

A physical field present around an electrically charged particle that exerts a force on all other charged particles is called an electric field. The charged particles present in the field either repel or attract. From electric charges or time-varying magnetic fields, the electric field originates. One of the manifestations of electromagnetic force which is one of the four fundamental forces present in nature are the electric fields and magnetic fields.

Question

The Subject is Electromagnetic II .

Consider a transmission line of characteristic impedance
50 ohms. Let it be terminated at one end by (+ j50)
ohm. The SWR produced by it on the transmission line
will be

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A small manufacturing plant is located 2 km down a transmission line, which has a series reactance of 0.5/km. The line resistance is negligible. The line voltage at the plant is 4800V(rms). and the plant consumes 120kW at 0.85 power factor lagging. Determine the voltage and power factor at the sending end of the transmission line by using (a) a complex power approach and (b) a circuit analysis approach.
A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the characteristic impedance of the line is 50 ohm, them what will be the attenuation constant of the line in Neper (Np)/m?
Given a telephone transmission line of 100 mile long has Z,=685-j92Q, 0a=0.00497 neper/mile and f=0.0352 rad/mile work at 1000Hz. If Z=2000Q and Eg=10Vrms with Z:=700Q, find the sending end impedance, voltage, current, and power.
For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and 50 ohm respectively. What will be the value of the characteristic impedance of the line?
A 50ohm transmission line powered by a 3GHz source and terminated with a load impedance ZL=25-j60 ohms will be matched with the shorted parallel side. What should be the length, in m, of the parallel lateral line calculated using the Smith diagram ?
Consider a transmission line with characteristic impedance (Zo) of value 50Ω, if the value of the measured VSWR is 2, determine the magnitude of the load (Zl ) connected to that line that generates such value.
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit. Select one: True False
A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
Solve this math : A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line. Note: In the below i have added similer type of math and its ans.In the above math, there is just changes of values and Main Change is ACSR ROOK which is given to then question and in the below question which is solved it was ask ACSR Parakeet. So notice that. Follow This Book for help"POWER SYSTEM ANALYSISAND DESIGN;FIFTH EDITION, SI;J. DUNCAN GLOVER" Now solve the math according to the given way solve the math. "A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 25…
A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the damping coefficient α=
The magnitudes of the open circuit and short circuit input impedances of transmission line are 100 ohm and 50 ohm respectively. What will be the characteristic impedance of the line?