Consider Clausius-Clapeyron equation and ideal gas law The vapor pressure of silver (Ag) is 7.97 x10-39 Pa at room temperature (25°C), A chamber at 1500K with a volume of one cubic meter contains one gram of Ag. What is the status of the silver in the chamber? Is it all vapor, all liquid, or part liquid and part vapor? Then based on your answer, calculate what is the mass fraction of the silver in the vapor phase? Assuming the enthalpy change of vaporization of silver is 282 kJ/mol. The atomic weight of Ag is 107.87 g/mol.

Q: The thickness of a synthesized catalyst is expected to be 1-10 nm. Which of these microscopic techni...

A: The best technique that can be adopted is TEM(Transmission electron microscopy)

Q: Qut A thermo.couple junction of area A, mass m, heat capacity C, and emissivity e in a furnace which...

A:

Q: 4.91. A mixture of 75 mole% methane and 25 mole% hydrogen is burned with 25% excess air. Fractional ...

A: Given: The molar composition of the fuel gas mixture: 75% methane (CH4) and 25% hydrogen (H2) The pe...

Q: Consider that an elementary, irreversible gas-phase reaction: A → B + 2C is carried out isothermally...

A:

Q: Quiz / A combination of a heat engine driving a heat pump, the heat energy supplied to the heat engi...

A: In thermodynamics, a heat engine is a system that converts heat or thermal energy to mechanical ener...

Q: A gasification plant of MSW produces syngas of the following Component Composition (dry volume...

A: The dry volume composition of the syngas is given as: CO = 30%, H2 = 40%, CO2 = 30% Mass of syngas c...

Q: Calculate the bubble point temperature at P=1 atm for the mixture where vapor pressure given by Anto...

A: In this question, the pressure is constant and we need to calculate the bubble point temperature. So...

Q: A 32.0 gram sample of chemical X is found to contain 12.0 grams of carbon. The law of Definite Propo...

A:

Q: Three moles of an ideal gas at 100 kPa pressure and 20oC are heated reversibly at constant pressure ...

A: Given: Moles of the ideal gas, n = 3 mol Initial temperature, T1 = 20°C = 293 K Initial pressure, P1...

Q: Derive unsteady-state mass balance.  Assumption  1. Constant pressure  2. No heat loss  3. Equimolar...

A: Distillation columns are important units in petrochemical industries. These units process their feed...

Q: Q5. If 12 mole of 1-butene is heated from 250°C to 1200°C in a steady - flow process at approximatel...

A:

Q: A copra batch contains 44% oil and is to be extracted with n-hexane. The extracted meal contains 0.0...

A: Extraction is a process of separating the liquid mixtures into individual liquids by adding the thir...

Q: Q3/ Transter the units below. Btu 4.1 J Lin) (cm) Y-) (S) (Ibm)(ft") to gmol e to SI Syptem 3 psi to...

A:

Q: Example 1.7 Explain without differentiating why the following differentiation cannot be correct: d V...

A: Derivatives are fundamental tools of calculus. Derivative at the point is the slope of the tangent a...

Q: Q / We have a five-liter solution with a mass of 750kg / m3, and another solution with a density of ...

A:

Q: How is oil in the bottom of the earth?

A: To explain How is oil in the bottom of earth? (Please note that we have discussed the question with ...

Q: What effect has a change in The atmospheric pressure on the boiling point ?

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want rem...

Q: For a system consisting of three particles in 3D, on what variables does the time-independent wave f...

A: System consisting particles in 3-D depends upon following  a) wave velocity (u) and position of part...

Q: Shown below is a flowchart of a process in which acetic acid (A) is extracted from a mixture of acet...

A:

Q: Q#2: Explain the manner in which pollution is caused by solid industrial waste, industrial effluen...

A: The Wastes generated by manufacturing or industrial processes are called industrial wastes. Most com...

Q: b)Find the derivative of the function by using the derivative definition? ds if s dt t 2t + 1

A: The rule that should be followed here to find the derivative of the function is QUOTIENT RULE.  It i...

Q: a Solution which result S 5) Cal Culate the PH ofa from the miixing of 50-oml of o.3M Hel which 5omL...

A:

Q: EXAMPLE: Standard and True Volumetric Flow Rates The flow rate of a methane stream at 285 °F and 1.3...

A:

Q: Formaldehyde (CH2O) is produced industrially by catalytic oxidation of methanol (CH3OH) according to...

A:

Q: engineering plant has an annual revenue of $ 700000. The direct production cost was 45% of the total...

A: Annual Revenue= $700,000 Production Cost=45% of Annual revenue                           =0.45×$700,...

Q: 1. Acids are substances that produce hydrogen ions (H*) when dissolved in water. Lemon juice is an e...

A: 1.A Lemon juice taste sour. It tastes sour because they contain acids. The chemical nature lemon jui...

Q: show solution

A: The energy in the universe is constant. It can convert from one form to the other form. It can neith...

Q: 1. A 1.00L rigid tank contains superheated steam that has a uniform temperature of 310°C and uniform...

A: Answer 1: First, use the temperature and pressure to find the specific volume with a pressure of 1.0...

Q: Cal Culate the PH ou Selution which results from the mixing of 50.0ml of o-SM HCl which 5omL of o.4M...

A: Given: Moles of HCl=0.3×50=15milli moles Moles of NH3 =50×0.4=20milli moles pKa(NH4+) = 9.26  

Q: Q2: A 60 mm diameter pipe contains glycerin (sp.gr 1.258) flowing at 8.5 m'/hr as shown in the figur...

A: Given: d = 60 mm, specific gravity = 1.258, Q = 8.5 m3/hr and zA = 0m, zB = 12 m. PA = 2 atm and PB ...

Q: Q1/ If the blood entering the unit flows at the rate of 220 mL/min, and the blood exiting the unit P...

A: Given:Blood in flow rate, Bin=220mLminBlood out flow rate, Bout=215mLminDialysate in flow rate, Din=...

Q: Q3/ The solubility of sodium chloride NaCl in water at 290 K is 35.8 kg / 100 kg of water. Express t...

A: Solubility is the ability of a substance to dissolve in a solvent. The substance may be solid, liqui...

Q: I have attached a formula sheet which might help.

A: From image, given that: For inlet: Pressure, P1 = 1800 lbf/in2 , Temperature T1 = 1100⁰F For exit 2:...

Q: Q2: Determine the pressure difference between points A and B in the figure. taken that: Benzene sp.g...

A:

Q: The less volatile component has O a. Low boiling point & High vapor pressure Ob. Low boiling point &...

A:  

Q: QI/ Ammonia gas (A) is diffusing through stagnant N2 (B) under steady-state conditions. The total pr...

A: Total pressureP=1.013×10 Pa Temperature T = 298 K  Concentration of ammonia at point 1 = Y1 mole fra...

Q: Q/ Draw the structural formula of the following s: (4M) O 3,4-diethyl-2,5,5-trimethyloctane 6) Cis-)...

A: IUPAC names of the compounds are a) 3,4-Dimethyl-2,5,5 Trimethyl Octane b) Cis-1,3 Dimethyl Cyclohex...

Q: hich object will have the most potential energy?     1 kg book, 8 m from the ground    5 kg ...

A:

Q: Calculate the percent ionic character (%IC) of the ionic compounds listed below.NaClZnOCuOAgCl

A: Percentage Ionic Character Formula, % ionic = {1 - exp[-(0.25)(Xa-Xb)2]} x 100 Xa and Xb are electro...

Q: Heptane is burned with 35% excess air. Find the composition of the flue gas if combustion is complet...

A: Heptane is burnt with 35% Excess air. Assuming Complete Combustion means: All carbon oxidized to CO2...

Q: Adsorption on 6x10-mesh activated carbon is being considered to recover methyl ethyl ketone(MEK) fro...

A: Properties of MEK, C4H8O8 T, °C 14 25 41.6 79.6 Pt, mmHg 60 100 200 760 ρ=.805g/cm3 at 20°...

Q: Chemical Engineering Question

A: Note: Since you have posted a question with multiple sub-parts, we will solve the first three subpar...

Q: Q10) Fill the blanks 1) The analysis that quantifies analytes called 2) The most abundant element in...

A: 1) The analysis that quantifies analytes called quantitative analysis.  Quantitative analysis is use...

Q: Describe the preparation of 500 mL of 0.0740 M CI solution from solid BaCl.2H2O (244.3 g/mol).

A:

Q: A hydrocarbon has a MW of 114 g/mol and has a composition of carbon 84.06% and hydrogen 15.94%. What...

A: Given: Molecular weight = 114 For 100g of the compound,  C = 84.06g H = 15.94g

Q: The molar enthalpy of a binary liquid mixture of components 1 and 2 at constanttemperature and press...

A: Given that, The molar enthalpy of a binary liquid mixture of components 1 and 2 at constant temperat...

Q: Q6. An inventor has devised a complicated non- flow process in which 1 mol of air is the working flu...

A:

Q: The enthalpy of combustion of methane, graphite and dihydrogen at 298K are -890.3, -393, -285 KJmol ...

A:

Q: One kg of steam undergoes a reversible isothermal process from 20 bar and 250°C, to a prgssure of 30...

A:

Q: 0 How many grams of KCI should be added to 100 g NaCl to make i 4. mixture that contains 55.0 per ce...

A: Mass of NaCl=100g Amount of Chlorine in Mixture=55% Amount of KCl to be added?