Consider the analog audio signal x(t) = 3 cos 2000 tt + 5 sin 6000 nt -10 cos 12000 nt (a) What is the Nyquist rate for this signal? (Hint: w = 2nf) (b) Suppose you wish to transmit this audio signal as 5+1 Dolby surround sound through a 1 Mbit/s connection in real time. Using a sampling rate F; = 5000 samples/s, what is the maximum average number of bits you can use to represent an audio sample? (c) You want to use a sampling frequency of 32 kHz, and also want use 8 bit/sample/channel representation. What is the minimum compression ratio you need in order to transmit the 5+1 surround audio signal? %3D

Consider the analog audio signal x(t) = 3 cos 2000 tt + 5 sin 6000 nt -10 cos 12000 nt (a) What is the Nyquist rate for this signal? (Hint: w = 2nf) (b) Suppose you wish to transmit this audio signal as 5+1 Dolby surround sound through a 1 Mbit/s connection in real time. Using a sampling rate F; = 5000 samples/s, what is the maximum average number of bits you can use to represent an audio sample? (c) You want to use a sampling frequency of 32 kHz, and also want use 8 bit/sample/channel representation. What is the minimum compression ratio you need in order to transmit the 5+1 surround audio signal? %3D

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Find the highest sampling frequency fs so that if the signal v(t) = 12 cos(2π125t + π/3) + 18 cos (2π85t) is sampled at times t = nT where T = 1/fs, you obtain the signal vs(n) = A cos (Ωn + ψ) with a single frequency component. Find the amplitude A, normalized radian frequency Ω, and phase ψ of the sampled signal.
For the signal v(t) = 15 cos(2π225t + π/3) + 10 cos(2π475t + π/2) + 2 sin(2π650t + π/7), if you sample at times t = nT for the sampling frequency of fs = 1/T = 500 Hz, find the signal y(t) which will generate the same samples as v(t) but has the lowest positive frequencies for each of its components.
An audio signal has bandwidth of 5.8 MHz encoded by PCM. Given the total number of bits to represent a level are 10 bits, determine a. Total number of levels. b. Bit rate. c. PCM bandwidth. d. SQNR in dB. Assume unity normalized signal power.
An analog telephone line has an SNR of 45 dB and passes audio frequencies over the range of 300 to 3,200 Hz. A modem is to be designed to transmit and receive data simultaneously (i.e., full duplex) over this line without errors. If the frequency range 300 to 1,200 Hz is used for the transmitted signal while the frequency range 1,500 to 3,200 Hz is used for the signal being simultaneously received, computethemaximum capacity of the channel duringtransmission and reception?
Given the following FM modulated signal equation, determine the original message equation, m(t). s(t)= 1cos(2π2.4GHz*t + 5sin(2π7kHz*t)), Kvco=4500 (Hz/v) With explain a. m(t)= 1.8cos(2π2.4E9t) b. m(t)= 1.8cos(2π22E3t) c. m(t)= 14.7cos(2π7kHz*t) d. m(t)= 7.78cos(2π7kHz*t)
An audio signal described as 25 sin 2π (5 X 103 )t amplitude modulates a carrier which is described as 40 sin 2π (1 X 106 )t Determine the modulation factor, percent modulation and the upper and lower sideband frequencies and write the AM equation.
A Pulse Code Modulation based system is processing a sampled voice signals ranges from X Hz to Y Hz before it is going through the telephone line. If the bandwidth for that signalis set as 2,000 Hz, suggest a best value for X and Y.
Suppose the total power of an FM signal is 7 W. What is the power of the second sideband if the modulation index is 3? Show the details of your work. Write your answer on a white typewriting paper, scan it in JPEG format, and paste it into the space provided below.
An FM superheterodyne receiver is tuned to a frequency of 88 MHz. What is the local oscillator frequency if low-side injection is used at the mixer? Show the details of your work.
2. An FM signal is represented by the equation v(t) = 12 sin (6.28x108 t + 8 sin 1450t). Determine the unmodulated carrier frequency, the modulating frequency and the modulation index. Note: Please write clearly
Find the discrete signal obtained by sampling the analog signal x(t) = cos(2000 * pi * t) + sin(5000 * pi * t) with a sampling rate of 5000 samples per second?a. cos(2.5 * pi * n) + sin(pi * n)b. cos(0.4 * pi * n) + sin(pi * n)c. cos(2000 * pi * n) + sin(5000 * pi * n)d. nothing is right
Determine the energy content of the even symmetric component of the signal defined asx(t) = 10+2t volts, -5≤t≤5= 0, otherwise