Consider the below table to solve using “SJF scheduling" and "Round Robin scheđuling (Time Quantum- 4ms)". Burst Time 12 16 Process PI P2 P3 6. P4 14 Suppose that the processes arrived at the same time, do the following. a. Draw Gantt chart for each schedule. b. Calculate waiting time for each process. c. Calculate average waiting time and explain which schedule gives minimum waiting time.

Consider the below table to solve using “SJF scheduling" and "Round Robin scheđuling (Time Quantum- 4ms)". Burst Time 12 16 Process PI P2 P3 6. P4 14 Suppose that the processes arrived at the same time, do the following. a. Draw Gantt chart for each schedule. b. Calculate waiting time for each process. c. Calculate average waiting time and explain which schedule gives minimum waiting time.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider the following data [Figure].Suppose round robin scheduling is applied on the given data with time quantum=Floor (XX % 3) units. It is also given that scheduling of a process or context switch will take 1 unit of time. What is the completion time and turnaround time of process P4?Where XX is the last two digits of your roll number. XX=18
Suppose that the following processes arrive for execution at the times indicated. Each process will run for the amount of time listed. In answering the questions, use nonpreemptive scheduling, and base all decisions on the information you have at the time the decision must be made. Process Arrival Time Burst Time Pl 0.0 8 P2 0.4 4 P3 1.0 1 a. What is the average turnaround time for these processes with the FCFS scheduling algorithm?b. What is the average turnaround time for these processes with the SJF scheduling algorithm? c. The SJF algorithm is supposed to improve performance, but notice that we chose to run process P1 at time 0 because we did not k11ow that two shorter processes would arrive soon. Compute what the average turnaround time will be if the CPU is left idle for the first 1 unit and then SJF scheduling is used. Remember that processes P1 and P2 are waiting during this idle time, so their waiting time may increase. This algorithm could be known as future-knowledge…
Consider the following set of processes, with the length of the CPU burst given in seconds: Process Burst time Arrival time P1 10 1 P2 04 2 P3 05 3 P4 03 4 Draw four Gantt charts that illustrate the execution of these processes using the following scheduling algorithms: FCFS, SJF preemptive and Round Robin (quantum = 3). What is the turnaround time of each process for each of the scheduling algorithms in part a? What is the waiting time of each process for each of these scheduling algorithms? Which of the algorithms results in the minimum average waiting time (over all processes)? Which of the algorithms results in the minimum average turnaround time (over all processes)?
Consider the following set of processes (a smaller priority number implies a higher priority). The processes are assumed to have arrived in the order P1, P2, P3, P4, P5 all at time 0. Process Priority Burst Time P1 1 20 P2 3 25 P3 4 25 P4 2 15 P5 5 30 What is the turnaround time of each process for each of the scheduling algorithms, FCFS, SJF (if two jobs have the same burst time, schedule them following priority), non-preemptive priority? Process FCFS SJF Priority P1 P2 P3 P4 P5
By Round Robin (time quantum= 3) show the scheduling order of the processes using a Gantt chart in the following data. Also b) What is the turnaround time for each process? c) What is the waiting time for each process? d) What is the response time for each process? Process Burst Arrival P1 30 0 P2 25 40 P3 20 50 P4 12 75
Six batch jobs arrive almost at the same time in the following order: p1;p2; : : : ;p6. The table below contains their running times and priorities: Job p1 p2 p3 p4 p5 p6Running time (in min) 8 1 5 3 7 4Priority 3 2 5 1 4 6 The highest priority is 6. For each of the following scheduling algorithms, determine the order of execution of processes and mean process turnaround time:(a) priority scheduling;(b) rst-come, rst-served;(c) shortest job rst.Scheduling is non-preemptive.
A real-time system executing four different periodic tasks Ti(p,t) is given, with p and t representing the period and the execution time of the task, respectively. Each task's deadline matches its period p. The system is executing the following set of tasks: S = {T1(10,2), T2(4,1), T3(10,3), T4(7,1)}. Is this real-time system schedulable under Rate-Monotonic (RM) scheduling? Is this real-time system schedulable under Earliest Deadline First (EDF) scheduling? Explain your answers using the concept of overall CPU utilization.
Consider the set of 5 processes whose arrival time and burst time are given below: Draw the Gantt Chart of the sequence of execution of the processes using Shortest Job First Scheduling Algorithm. Find the average waiting time of the processes.
Suppose that the following processes arrive for execution at the time given below. Each process will run for the amount of time listed. Calculate average turnaround and average waiting time for these processes under Shortest remaining time first (SRTF)(preemptive) scheduling AlgorithmHints: turnaround time: The interval from the time of arrival of a process to the time of completionWaiting time: The sum of the periods spent waiting by a process in the ready queue
Assignment 11. Consider the following set of processes,with the length of the CPU burst and arrival timegiven in seconds: Process Arrival Time Burst TimeP2 0 12P3 3 8P4 5 4P1 10 10P5 12 6 a. Draw Gantt chart that illustrate the execution of these processes using the preemptive Shortest Job First.b. What is the turnaround time of each process?c. What is the waiting time of each process?d. What is the Average turnaround time of the execution?e. What is the Average waiting time of the execution?2. Consider the following set of processes, with the length of the CPU burst and arrival time given in seconds: Process Arrival Time Burst TimeP2 0 12P3 3 8P4 5 4P1 10 10P5 12 6 a. Draw Gantt chart that illustrates the execution of these processes using the FCFS.b. What is the Average turnaround time of the execution?c. What is the Average waiting time of the execution?
Q1. Consider a set of 5 processes whose arrival time CPU time needed and thepriority are given below [20 marks]Process Arrival time (in ms) CPU Time Needed (In ms ) PriorityP1 0 10 5P2 0 5 2P3 2 3 1P4 5 20 4P5 10 2 3Note: Smaller the number, higher the priority.Draw the Gantt chart illustrating the execution of these processes for each of thefollowing CPU scheduling policy and also find the average waiting time in eachcase. I. First Come First Serve (FCFS)II. Shortest Job First (SJF) without pre-emptionIII. Shortest Job First (SJF) with pre-emptionIV. Priority Scheduling without pre-emptionV. Priority Scheduling with pre-emption
The following processes are being scheduled using a preemptive, priority-based, round-robin scheduling algorithm. Process priority Burst Arrival P1 8 15 0 P2 3 20 0 P3 4 20 20 P4 4 20 25 P5 5 5 45 P6 5 15 55 Each process is assigned a numerical priority, with a…