Consider the common source amplifier shown in the figure below. Assume that the transistor has been biased in the saturation region. It has an Ip = 1 mA, additionally k = 617 x 10-6 A/V² and Cgs = 1 pF. You may ignore channel length modulation and all other parasitic capacitors. Sketch the Bode plots for this amplifier. VDD

Q: Problem 3. x(1) - h(t) - y(t) The above diagram shows a single-input single-output (SISO) system. In…

A:

Q: Sketch the asymptotic magnitude and phase Bode plots to scale for the transfer function? H(jω) =…

A:

Q: Find this system's response y(t) for x(t) = e-2t.u(t) h(t) = [2e-3t-e-2t].u(t) y(t) = ???

A:

Q: Given the state table shown below, find the output and state sequences for the input sequence,…

A: Given:  Required: Output and state sequence if the input sequence is X=110011. Starting state is A.

Q: Write the signal as s(t) = A(cos(w.t + 8) - ka(t)sin(wet + 0)) and find the maximum frequency…

A:

Q: In the circuit shown in the figure, VA = V = 14.0 V and R₁ = R₁₂ = R₁ = R₁ = Rs = 125.0 2. Current…

A:

Q: H.W: Design Two Pole Butterworth BPF Center Frequency 3dB, fo=1.26 KHZ And The Selectivity = 10;…

A:

Q: Kxm+ zxm + ahmi zhx + (m+m) thX (2+2) hxm + (htch ) EXм .+. (x+c*). thm (thxm+&rxm) +(Ehxm +z, i xm)…

A:

Q: Project # 1: Give the following DC circuit (Assume that capacitor is fully charged): Vin= 10 VDC i₂…

A: Answer: given that  input dc voltage Vin = 10 V resistances R1=R2=R3= 10 ohms capacitance C1= 1…

Q: Problem 04 A non-sinusoidal voltage of e = 120 + 100 sin (377t-20°) + 80 sin (1131t+ 20°) volts is…

A: Here we have to calculate the current.

Q: Determine the Equivalent Resistance of terminals Ra &R a b 12 Ω 4 Ω 10 Ω C d 3 Ω 36 Ω 15 Ω 6 Ω

A:

Q: 1. A plane wave with E(z)= [(1 +j)x+ (1-j) ^y] e+¹0 exists in a lossless medium with &=480, H=o. z…

A: Given,   E→=[(1+j)x+(1−j)y]ej10z Standard equation for E→=Eejβz   (A): frequency…

Q: 5 Part 2 of 5 ! Required information TD1-1 PL1 is off PL2 is on PL3 is off PL4 is on (5 s) TD1-2…

A: Given the logic diagram To find what happens to the PL1, PL2, PL3, and PL4 when switch S1 has just…

Q: Determine the break away points, angles of departure and centroid of Itu vost locus for the system…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: Question- Basics, Construction, Types, Operating Principle & EMF Equation For 3-0, 4-pole…

A: Given- A 3-ϕ, 4-pole alternator- Pole pitch = 15 slots, Coil is short pitched by 60o To Find- The…

Q: The i-v characteristics for the electrical component C on the right of terminals a-b is described by…

A:

Q: Q2) Use mesh analysis to find the voltage "V." in the circuit shown 1 ΚΩ I, 1ΚΩ Μ + )12V TRAI 51 ΚΩ…

A:

Q: Use the following circuit to complete this problem: iin(t) † 4 H 1F 10 Q + Vout(t) a. Redraw the…

A: In this given problem we need to draw the circuit after frequency scaled by factor of kf=100 ,and…

Q: R₁ Vin (+1) Ra www R₂ ww R₁

A:

Q: - 1. Compute the DTFT of x[n] = 5u[n - 3] - 5u[n – 9] (a) What is the real part of X(e³(-2.6))? (b)…

A: here we have to find the real and imaginary parts of   X  e j  - 2.6

Q: Problem 4 Find V(t) for t>0 in the circuit below. Assume the switch has been open for a long time…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Give an overview and insights when design and creating an AC-DC power supply with selectable output…

A: Introduction  - A power supply is an electronic equipment that provides electricity to a load. A…

Q: Calculate the voltages across R2 and R3 using the values. below El RI 81 VRI R2 E2 |R3 E1=11.6 V…

A:

Q: 41V (+)) - 802 W 800 V₂ + 6 402 250-2 90⁰mA 200

A: Given data Voltage source of 41 V is applied at the left periphery of the circuit. Current source of…

Q: 1₁- A, ₂- E b. Report the voltage gain across the current source I Voltage gain across I is (Click…

A:

Q: Find the relative permittivity of dielectric material used in a parallel plate capacitor if electric…

A: Given: Electric flux density, D=15 μcm2 Energy density, WE=20 Jm3.

Q: Apply the Routh criterion on the provided characteristic equation to determine the stability range.…

A: Given: The Characteristic Equation is : s2+3s2+(2+k)s+(4+5k)=0

Q: 2. Compute the clock period for the following clock frequencies. a. 32.768 kHz b. 100 MHz c. 1.5 GHz…

A: Given, Clock frequencies are  a) f1 = 32.768 kHz b) f2 = 100 MHz c) f3 = 1.5 GHz d) f4 = 2.4 GHz We…

Q: Refer to the following circuit. Apply Wye - Delta transformation or any other method, to find the…

A: It is given that:

Q: Find the current through and the potential difference across each resistor in figure. Input voltage…

A: In this question We need to determine the potential difference across each resistance and current in…

Q: 2. For the circuit below, determine Iz(t). Io 5 A, R, 102, R=20 2, and L=2 H. Assume a long period…

A: In this question We need to determine the current in the inductor at different different time.  We…

Q: Which of the following correctly orders how frequently each type of fault occurs?- a. balanced…

A: Given: Which of the following correctly orders how frequently each type of fault occurs?

Q: Simplify the boolean expression: AB'CD+A'BCD   the expected answer is ACD+BCD. only use the…

A: In this question we need to simplify the given Boolean expression

Q: Exercise 3: A linear time-invariant discrete-time system is described by the difference equation…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: SW 11 (40/41) L DETERMINE V., Vdc, PIV AND SKETCH THE OUTPUT WAVEFORM FOR THE CIRCUIT BELOW. Vin…

A:

Q: In x(n) 12 H₁(z) x(n) ↓2 the input signal is upsampled by I = 2, then filtered by H₁(2), and then…

A:

Q: How do you design transmission line and verify it?

A: Step-1--> Designing a transmission line involves several steps, including choosing the…

Q: 1- 2- 3- 4- 5- R(s) R(s) R(s). R(s) R(s). Find the response of each 2nd order system shown below. 20…

A: Given data The transfer function are given in the block diagram for each of the subpart. The…

Q: 4. An audio signal s(t) generated by a loudspeaker is reflected at two different walls with…

A: Given data xn=sn+r1sn-k1+r2sn-k2 It is given that the k1 and k2 are the delays of two echoes. To…

Q: 开 1000 < D: +5+30 0 s 把 中 38 100

A:

Q: Gain Margin

A:

Q: The p.d across 5 m of nichrome wire is 3.2 V when the current is 0.2 A. Find the diameter of the…

A: The potential difference across a nichrome wire is V=3.2 Volts. The current flowing through the wire…

Q: look DETERMINE V₂ AND THE REQUIRED PIV RATING OF EACH DLODE FOR THE CIRCUIT BELOW- SKETCH THE OUTPUT…

A:

Q: Find The RMS Vlaue And average value of the periodic waveform using The laws of integration are…

A:

Q: - (6) Find the power that is absorbed by each element in the following circuit. 2AT 4 V - 9V+

A: Given data, Circuit diagram is given as,

Q: Consider the system shown below: R₁(s) R₂(s) + + G₁(s) G3(s) G5(S) + H₁(s) The Characteristic…

A: Here we have to find the characteristic equation.

Q: 1. Determine I and Vab. 30V (+ 322 lov + + Vab 52 W ↓ +1 8v

A:

Q: 5) For the following amplifier, assume that ro = ∞o, Re = 50 52 and R₁ = 16 02, and that the…

A:

Q: Problem 1 A 2-hp, 120-V, 4-pole, three-phase, Y-connected, synchronous motor has a synchronous…

A: Given Data: A three-phase star-connected synchronous motor with, Power Pin=2 hp Supply voltage…

Q: Figure + 2 ΚΩ 0.2 iA 2 ΚΩ Σ2 ΚΩ {R 1 of 1 • а Part B Find the equivalent resistance. Express your…

A: Given a circuit with dependent current source Vs = 350 v and R = 5.2 kiloohm To find equivalent…

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.