Consider the following figure. Represent the discrete samples into their corresponding hex values. Draw the analog signal.

Q: Draw the signal after adding -2.5 DC level with the given signal, sketch the new output signal and…

A:

Q: Q.4. A single-phase half-wave-controlled converter is operated from a 120V, 50HZ supply. Load…

A: For single-phase half-wave controlled rectifier with R-Load,…

Q: The input voltage ?? of the following circuits is a triangular signal with an amplitude of 18Vpp,…

A: Given the two circuits: a)      b) Given the input is a triangular signal of 18Vpp voltage, the…

Q: 1)(a) State advantages and disadvantages of AM and FM (

A: Dear student you posted 3 question as single request.we will solve first part only.kindly resubmit…

Q: Determine the ripple factor for the filtered bridge rectifier with a load as indicated in the figure…

A: The given circuit is a full bridge rectifier circuit with capacitor filter. The value of all the…

Q: 6. For the given input waveform to the given circuit, what is the peak value of the output waveform?

A: Given:

Q: 1)(a) State advantages and disadvantages of AM and FM

A: ADVANTAGES OF AM AM transmitters are less complex.  AM receivers are simple, detection is easy. AM…

Q: Q1. In the circuit Figure 1, ß is in range 75 < p s150 , Determine the range in (a) Small signal…

A:

Q: Example: Suppose that an analog signal is given as x(t) = 5cos (2n x 10 t) and is sampled at the…

A:

Q: we can see the following signal at which point of the modulator? 6 A Modulating signal D Carrier -…

A:

Q: Define moore state machine. Draw Mealy state diagram of sequnce 1111 with overlapping condition.

A: The state diagram is visual representation of the sequence. It shows the internal states and…

Q: Clipper circuit: Vi (p-p)= 10 volt (Sinewave) F=1 kHz R= 10 Kohm V= 4 volt Find and Sketch the…

A:

Q: Draw and explain the circuit of a simple AM demodulator using Junction diode ( draw the input and…

A: Output of pig detector circuit tracks the envelope of modulated signal with some truncation error.…

Q: What will be the output SNR for a PCM system with 16 levels in the quantizer. Assume full scale…

A: For a pulse code modulated system with a sinusoidal signal amplitude as input, the output signal to…

Q: (b) Derive its output voltage equation in terms of duty cycle and input voltage.

A:

Q: In analog to digital signal conversion sampling, what is problems that may occur in the…

A: An analog signal can be converted to a digital form or vice versa through a series of steps.  The…

Q: a. Set the input signal of the clipper circuit to 4Vp-p and 1 kHz square wave, shown above, and Show…

A: The circuit is as shown below, We need to show the input and output waveform for a square wave…

Q: The vertical deflection of the electron beam in a CRO is provided by,

A: A cathode-ray oscilloscope (CRO) is an instrument that provides accurate time and aplitude…

Q: ww Draw output waveform and transfer characteristic of circuit.consider diode as ideal V, VR

A:

Q: 1.. . is a voltage controlled device. 2. The controlling parameter in MOSFET is . 3. A thyristor is…

A:

Q: Q5: Full the following Blanks (Choose 10 only). 1. . . is a voltage controlled device. 2. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: For positive half of the signal below, what is the peak output value of the circuit? NOTE: .use…

A:

Q: 1. Describe the difference between standard deviation and population standard deviation? Describe a…

A: There are three questions. We are authorized to answer one question at a time. We are answering…

Q: • Design a classical rectifier to deliver 100W into a resistive load from a 120Vc 60HZ mains.…

A: Part (a): The circuit diagram for the classical rectifier is given by:

Q: 20 V 10V -20 V

A: The input peak voltage is 20 V. For a positive half cycle, A diode will be in reverse bias…

Q: A nominal Zener voltage is usally specified in datasheet of Zener diode at a value of reevrs current…

A: To answer above question one should know what Zener diode. It is a special purpose P-N junction…

Q: What is threshold voltage?

A:

Q: For the given input waveform to the given circuit, what is the minimum value of the output waveform?…

A: The solution can be achieved as follows m

Q: The resolution of a 12 bit analog to digital converter in percent is ?

A: It is given that 12 bit analog to digital converter.

Q: describe and compare the different types of Analog to Digital Converters(Advantages, Disadvantages,…

A: Analog to digital converters are used within a data acquisition system is to convert conditioned…

Q: Identify THREE (3) properties of an analog signal that can be modulated by modulating signal.

A: Modulation  :- The process of converting an analog signal into digital signal is known as…

Q: Suggest a demodulator circuit to detect the data signal from the Phase shift keying modulated signal…

A: A signal obtained is called a carrier signal. A Carrier signal with information is also called a…

Q: Define Phase Margin and Gain Margin for continuous and discrete systen

A: Brief idea about phase margin and gain margin

Q: Sketch output waveform the following CLIPPER circuits. Pl

A: Given clipper circuits  and input sinusoidal waveform with amplitude 8v and -8v then the output…

Q: 1:5 1000 Vin(Vrms) O Vo 1V +

A:

Q: A MOSFET has . . terminals Select one: a. five O b. two c. three

A: The MOSFET has

Q: Explain in your own words some of the trade-offs between CISC and RISC.

A: The architecture of computer has the following types: Reduced Instruction set computer (RISC)…

Q: briefly Q4. What are RISC design principles? Explain each one

A: A RISC or (Reduced Instruction Set Computer ) architecture has lesser number of complex instructions…

Q: 8. The circuit shown below is a small sine wave signal with average zero andtransistor ß =98Find the…

A:

Q: Describe the operation of the circuit and sketch the output waveform. vo ww

A: Clamper is the circuit that use to add DC level to an AC signal. There are two types of clamper…

Q: Design a POWER SUPPLY with 5V output voltage. Use zener diode as a voltage regulator. Then solve for…

A: Aim- To Design a POWER SUPPLY with 5V output voltage. Use zener diode as a voltage regulator..…

Q: A collector modulator is a balanced modulator. O True False The information or intelligence is at…

A: Given  Few true or false questions based on modulation. Please find the below attachment for clear…

Q: An analog signal voltage in the range of 0 to 8V is divided into 16 equal intervals by a quantizer.…

A: The analog voltage range is 0 V to 8 V.  The number of equal division is 16.

Q: Discuss the difference between the information input and the recovered output from the diode…

A: DIODE DE-MODULATOR - The envelope detector is used to demodulate high level Amplitude modulated(AM)…

Q: What is the importance of threshold voltage?

A: Threshold Voltage: It is the minimum voltage that is required to turn on an electronic device such…

Q: list of some of the important terms and definition about Metal Oxide Semiconductor Field Effect…

A: Some of the important terms related to MOSFET are :- Drain-source Voltage :- It is the maximum…

Q: For the circuit shown in below, determine and sketch the output waveform for the give input signals:…

A: Opamp is a differential amplifier with huge gain. An ideal opamp has infinite differential gain.…

Q: The input voltage Vi of the following circuits is a triangular signal with an amplitude of 18Vpp,…

A:

Sample and Hold circuit

The sampling circuit and the holding circuit generate electrical samples as input and then hold these samples for a specified period. The time at which the sample and circuit holder produces the input signal sample is called the sampling time. Correspondingly, the length of the circuit that holds the sampled value is called the holding time.