Consider the given block diagram. R(s) K₂ 3 (5+1) Determine: (i). The maximum gain for stable operation (ii) The corresponding frequency of oscillation U(s) 1½/24 (5+1)² C(s)

Q: Four kg of water is placed in a tank volume of 1 m³. Heat is added until the temperature is 130 °C.…

A:

Q: The work done by an isothermal reversible expanding of 1 mol of an ideal gas from a volume of 20 L…

A: Given Isothermal reversible expansion of an ideal gas have n=1 mol V1=20L V2=40L T=273K Find Work…

Q: HW-3-: The width of a certain road at formation level is 9.50 m with side slopes 1 in 1 for cut and…

A: Given data: Width of rod = 9.5 m Depth of excavation = 0.4 m

Q: Two distillation columns in series are used to enhance the recovery of a desired component. In one…

A: Given that, The mole fraction of benzene in the feed xB,F = 0.2453 The mole fraction of toluene in…

Q: A mixture of benzene vapour and air contains 15% benzene by volume at 300 K and 101.3 kPa. The…

A:

Q: Joul In English unit = * O N.m O O lbm.ft Olbm.ft/lbf Ft. lbf None of the these

A: In S.I unit,  1 Joule  = 1 N.m  we know that,  1 N  = 0.2248 lbf 1 m = 3.28 ft

Q: Concentration of iodide solution (mm) Concentration of thiosulfate solution (mm) Concentration of…

A:

Q: B-A Refrigerant 134a is contained in a gid tank of volume 0.2 m². Initially the refrigerant exists…

A: Given that V =0.2 m3T1 = 10 CT2 =50 CQuaity =100 %

Q: Mass velocity of Propane gas is (...........*G )Kg/m2.s, it flows in main line with diameter 10cm…

A:

Q: The heat capacity of sulfuric acid has the units J/(g mol) and is gr the relation Heat capacity =…

A:

Q: Q3) What are the steps of processing used in the following techniques CHOOSE A or B. A) 1. Typical…

A:

Q: Which type of fire extinguishers are used to put out fires of liquid fuel? Chemical foam…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 19. What is the effectiveness (A) 0.345 (B) 0.766 (C) 0.625 (D) 0.456

A:

Q: c) Identify the bubble point pressure from the data given in Table Q3 (c) Table Q3 (c) PVT data…

A: Introduction: Bubble point Pressure: It is defined as the pressure at which the first gas bubble…

Q: If a gasoline engine car consumes 5,000 liters of Gasoline, calculate the total GHG emission in…

A: Given consumption of gasoline by car engine =5000 liters Emission factors  2.3 kg CO2 /liter…

Q: During an experimental drying test of hygroscopic wet solid, it took 8.5 hours to dry the solid from…

A:

Q: Q3/ A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m², a…

A:

Q: 106 Joules of heat are transferred from a reservoir at 327° C to an engine that operates on the…

A:

Q: (1) The final boiling points of gasoline, diesel, atmospheric gas oil (AGO), and lubricating oils…

A: From given information , we have to arrange the given fuels in their decreasing order of boiling…

Q: Drive equations for effectiveness factor for a first order reversible reaction at nonisotermal…

A:

Q: Q1. Answer 3 of the following 1. The unit of energy is......... while for power is. 2. Getting 100…

A: 1) Energy is measured in terms of joule (J) while the power is measured in terms of a watt (W)…

Q: For the values 2, 4, 6 the average deviation

A: To calculate average deviation of 2,4,6 Average deviation =1n∑xi-x¯ where xi= Data values in the…

Q: A smooth 3-in.-diameter hole is punched into the side of a large chamber where oxygen is stored at…

A:

Q: A- Air at 1.2 bar, 35 °C and 0.02 m' is heated at constant volume process till pressure becomes 6…

A: We are given the following information:   Air at 1.2 bar, 35 oC, and 0.02 m3 is heated at constant…

Q: 2. 10kg of H₂O in a 1.5m³ tank is initially at 200°C heat loss causes a decrease in temperature to…

A:

Q: 1.13 Consider a liquid level system as shown in Figure. Derive the mathematical model. What type of…

A:

Q: Find the minimum value of "K" such that a closed loop system having the following characteristics…

A:

Q: The work done due to reversible expansion is more than that of the irreversible expansion false O…

A: Explanation: In reversible process the heat added is completely converted to useful work and there…

Q: Explain how low octane naphtha is converted into high-quality motor fuels ?

A: low Octane naphtha Converted to high quality motor fuel  by continuous Catalytic and reforming unit.…

Q: 4. Find the fugacity (Pa) of ice (p = 0.915 g/cm³) at -10 °C and: ) P= Pat (i.e., at the sublimation…

A: Write the expression for fugacity of ice as follows: fT,P = Psat×expVP-PsatRT   .......1   Where,…

Q: For isobaric process, 1 mol of an ideal gas with Cp=5/2R the temperature changes from 125 K to 255 K…

A: Given, CP=5/2R, T2=255K, T1=125K For an isobaric process, ∆H=∆Q=nCP∆T ∆H=1×52R×255-125…

Q: A nickel steel rod 8 cm OD originally at temperature of 300° C is suddenly immersed in a liquid at…

A:

Q: If 1.1g of 100.0C steam begins to condense on a container of liquid water at 25.0C and they…

A: Given, The mass of the steam, ms = 1.1 g The initial temperature of the steam, Ts = 100 °C The…

Q: Q3/ If 1000Kg/h of a nicotine -water solution containing 1wt% nicotine is to be counter currently…

A: We are given the following information:  the feed contains the solution of nicotine-water = 1000…

Q: The Ozone gas at STP contains (6.022 × 10^23) molecules. O True O Flase

A:

Q: A) Calculate the molar volume of isobutane vapor at 90 °C and 16.54 bar using Redlich- RT a - Kwong…

A:

Q: A) An insulated stream of warm water is produced in a steady flow mixing process by combining 1 kg/s…

A:

Q: What is potential energy surface (PES)? Draw PES to represent the variation of energy during…

A:

Q: distillation column

A:

Q: Consider the truncated virial equation of state: PV =1+B'P+C' P² RT where the virial coefficients…

A:

Q: 50. The wire diameter of a 10-mesh screen whose aperture is 0.065 in. is (C) 0.045 in. (D) 0.025 in.…

A: Write the relation between aperture and wire diameter as follows: A = 1Mesh count- d     .......1…

Q: 2kg of gas occupying (0.7m3) has an original temperature of (15°C). It was then heated at constant…

A: Given:  Initial Temperature  = T1 = 15 C = 288 K  Volume = V  = 0.7 m3  Final Temperature = T2  =…

Q: B/ Air in the room with dimensions are 4 mx 6 m x 3.5 m have density of air is 1080 g/m³. Calculate…

A:

Q: This fixed mass system contains air with mass m = 13.947 kgs. The air is ideal gas and you must…

A: Given data: Mass of air = 13.947 kg Specific heat capacity at constant volume = 0.717 kJ/kg.K Gas…

Q: 300m^3 of CO2 saturated with water are at 20°C and 1 atm is compressed to 2.5 atm while it cools…

A: The given situation has been illustrated in the figure below

Q: Q3/ Pentane is burned with (45 %) excess air. Fractional conversion of (85 %) of Pentane is…

A: Basis: 100 moles of Pentane fractional conversion is defined as the number of moles of a compound…

Q: Q1. Answer 3 of the following ( 1. The unit of energy is. while for power is 2. Getting 100 kwh…

A:

Q: What reactors do you choose, how do you arrange them, and what is the highest conversion you call…

A: Reaction is A→B+C Levenspiel plot is given Budget to purchase reactor=$10000 Choose the reactor…

Q: 0.67 mol of acetic acid are added to 1 litre of pure water with no discernible change in volume.…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Nitrogen from a cylinder is bubbled through acetone at 1.1 bar and 323 K at the rate of 2x 104…

A: