Consider the waveform illustrated below. Vload Vs 0 -Vs 5m 10m 15m Assume the amplitude equal to Vs 1. the average value of the complex waveform; 2. the r.m.s.value of the complex waveform. 20m Time (s) and calculate 25m 5 30m 35m 40m 333

Q: Find The Z Parameters for the circuit shown I₁ 3001₁ 1₂

A: Given circuit,

Q: (+ R1 R₂ 5 Ω 302 R₁ E₁ R3 20 a I R4 60 R₂ C E₁ 10 V b E2 8 V R3 I 5 A R4 E2 (+1)

A: We need to find out thevenin equivalent resistance for given circuit.

Q: A 3-phase, 4 pole, 230 V, 60 Hz wound-rotor induction motor has

A: Three Phase Induction machine- This Induction machine comprises of rotor and stator as it basic…

Q: (b) An arbitrary system has impulse response given h(t) = e-²tu(t). If the signal x(t) is passed…

A: Given data, The given function h(t)=e-2tu(t)

Q: A 1/20hp; 1,550 rpm shaded pole motor has a maximum torque of 38 oz-in and a starting torque of 12…

A: Given data, Rating of motor P0=120hp=74620=37.3 W Speed N = 1550 rpm Maximum torque = 38 oz-in…

Q: Q13: the delay between address and data in 8086: a) 10 Msec. b) 15 Msec. c) 16Msec. d) we can not…

A: Delay is nothing but the time use to separate occurrence of two events in a microprocessor for the…

Q: a. Find the Fourier transform of the given function. -T f(t)= 2A -t+ A, 7sts≤0; ≤ t ≤ 0; T 2 T f(t)=…

A:

Q: 2r ar + System, then evaluate S at (1,1,1). Q2) Transform the vector: S = 2 cose αθ + rsinθ αØ to…

A: Cartesian coordinate system: This system is used for locating the cartesian coordinate in the plane.…

Q: Kindly answer this please, thank you! A potential difference of 232 V is applied to a field winding…

A:

Q: For the given op-amp circuit, determine: (a) iout/iin2, (b) lin2/iin, (c) iin/Is, and (d) iout/Is.

A: The circuit is given as Given data areAvOL=500VVRin=50kΩRout=100ΩRS=50ΩR1=500ΩR2=100ΩR3=2kΩR4=100Ω

Q: Resistance can be also expressed in terms of the following** EXCEPT ONE**. Select your answer.…

A:

Q: A three-phase source has a phase sequence of EAB - EBC - ECA and delivers the following delta load…

A:

Q: 2. Write the sequence of states for a 3-bit Johnson counter starting with 000.

A: here we have to write the sequence of states for a 3 - bit johnson counter starting with the 000.

Q: Obtain the transfer function V₂(s) V₁(s)

A: The required transfer function can be obtained by using the voltage divider rule after converting…

Q: The cutoff frequencies of a series resonant circuit are 5400 Hz and 6000 Hz. a) Find the bandwidth…

A:

Q: 2. Using KCL, fnd the unknown currents (I1, I2, Is and I4 ( for the network shown in the Figure 3.…

A:

Q: Define the 2nd order system and give the open loop and close loop of the 2nd order

A: Block diagram of second order system is shown in below figure, This is negative unity feedback…

Q: What change(s), if any, can be introduced into the circuit shown below for a) zero bias? b)…

A: a). Zero biased:  Above given circuit is a depletion type MOSFET which is generally in ON condition…

Q: Briefly explain the difference between KVL and KCL in the aspects of its circuit configurations,…

A: KCL: It states that if there are currents that entering and leaving at the node then sum of entering…

Q: Find the circuit current i shown in the figure.

A: Given, The circuit is,

Q: If a 10-bit ring counter has an initial state 0101001111, determine the waveform for each Q output.

A: Given,For a 10-bit ring counter -The initial state is given by,I=0101001111

Q: - If the ends of a cylindrical bar of carbon (o = 3 × 104 m) of radius 6 mm and length 8 cm are…

A: The resistance of the bar can be calculated by using the general expression of resistance.

Q: For the equivalent circuit of lossless linear transformer shown, find the value of L₁, L2, M & K?…

A: Given  The equivalent circuit diagram of lossless linear transformer. We need to find the values of…

Q: The drain-to-source voltage at the pinch-off point of a particular JFET is 7 V. If the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 16660 8

A:

Q: SEARCH CIRCUIT OF ANALOG TO DIGITAL CONVERTER CIRCUIT. AND DISCUSS HOW IT WORKS

A:

Q: An unbalanced star-connected load is supplied from a 400-V, 3-ph, Y-connected alternator through…

A:

Q: 7. The signal to be digitized could occupy the range of 70 ± 10 MHz or from 60 to 80 MHz. Calculate…

A: Given  Fmax= 80Mhz Fmin =60Mhz  Bandwidth (B.w) = ?  Sampling rate(Fs) =?

Q: 8. Three JK flipflops are connected as a synchronous counter that goes through the following…

A: In this question we need to design a given counter

Q: VGS Q2) For the circuit shown in Fig. 1, calculate the following given that the values of the…

A:

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: This question is related to 3 phase circuit calculations

Q: 1.0 ΚΩ 2.0 ΚΩ +12 1.8 ΚΩ 1.5 ΚΩ R₂ · 1.0 ΚΩ ID = 2 mA VGSOFF = -6 V Determine a) Vas b) 9m c) A

A:

Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…

A: Terminal voltage  = 11kV Th rate  = 15000 kVA Value of resistance  = 1.5Ω Value of reactance = 30Ω

Q: 1. In Figure 1, determine (a) the current supplied by the source, (b) the voltage drop across each…

A: We need to find out source current and voltage across each resistor for given circuit

Q: 5.A 36 VA, 120/12 volt, 60 Hz transformer is connected as a booster by placing a 3 + j4 load on the…

A: Given: A 36 VA, 120/12 volt, 60 Hz transformer is connected as a booster by placing a (3 + j4) ohms…

Q: The charge 10-5 e-3t C is removed from a sphere through a wire. Find the current in the wire at t =…

A:

Q: 2. A 3-phase, 11kV, star-connected alternator has armature resistance of 1 /phase and a synchronous…

A:

Q: Example Find Fourier trans form of the signal shown below Fig1. düze) x(4) dy (4) of .H S(4+1) +1 -1…

A:

Q: The dc series motor has a linear torque- speed characteristics. O True O False

A: The dc series motor has a inverse torque-speed characteristics.

Q: 4.4ΚΩ Μ Vin 800mv 30kΩ Μ => Rx Μ 55ΚΩ + +12V -12V -Vout δε 140

A:

Q: Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and…

A:

Q: Design a component values for RLC series circuit with center frequency of 4KHz and quality factor of…

A:

Q: b. Find the Fourier transform of the given waveform. f(1) -2 -1 1 2 (s)

A: In this question we need to find a Fourier transform of the given signal.

Q: (2) If the S, (1)=√25 (1) cos 2z ft-√25 (1) sin 27 ft is a passband signal write the equivalent…

A: Given  Input signal , we need to find the output at different stages of the block diagram. Please…

Q: The following information is given in connection with an alternator slot = 144; poles = 8; speed=…

A:

Q: b) Sketch and find the phase relationship between the following waveforms: V = -4 cos (wt + 90°) =…

A:

Q: Refer to the given circuit below. Determine the Thevenin Equivalent EMF if R3 is to be analyzed.

A:

Q: A transmission line cable consists of 13 strands of identical copper conductors, each 1.55 mm in…

A: Transmission Line: In electrical engineering, a transmission line is a specialised cable or other…

Q: What is the Operations of Tesla?

A: There are various operations of Tesla  for the purpose of optimal productivity  in the area of…

Q: 6. Convert these powers into Watts: P₁=100 dBm; P₂=1000 dB?

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.