Convert to DELTA. -j50 Q ... j100 O [1] ll [2] 200 Q [3] RE IM Z12 Blank 1 Blank 2 Z23 Blank 3 Blank 4 Z31 Blank 5 Blank 6

Q: * The following signals are sampled. In order for their samples to contain all information of a…

A: In this solution we discuss about sampling theorem.

Q: One of the simplest programming technologies is Cabling O IC O Fuse O

A:

Q: Vb is equal to 302∠200 and Vbc is 523.079∠230, the phase sequence is:"     POSITIVE     NEGATIVE

A: In this question , we will find phase sequence of given voltages....

Q: PART 1 The voltage across a 100+j25 Q impedance is 230230° V. The power factor of the load is 0.97…

A:

Q: Please help! I need a single phase agitator motor (0.24KW) - 240Volt to mix 500L of water and to run…

A: Single Phase Motor:  A single-phase motor is a rotating mechanism powered by electricity that can…

Q: Show how amplitude and phase diagrams are created the pole located on the real axis zero, which is…

A: A transfer function's poles and zeros are the frequencies at which the denominator and numerator of…

Q: How do you measure a current between two points in a circuit? (draw a diagram) How do you measure…

A: An instrument called ammeter measures electric current in a circuit. It is always connected in…

Q: A 3-phase induction motor running with 25% slip takes 100kw from the mains. If the stator copper…

A:

Q: If -10coswt + 4sinwt = Acos(wt+ø), where A>0 and -180° <øs180°, find A and ø ANSWER: Blank 1, Blank…

A:

Q: Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a…

A:

Q: () What is the motor armature current? (a) 99 A (b) 102 A (c) 107 A (d) 110 A (e) 115 A (ii) What is…

A:

Q: Calculate the transformer turns ratio using the following parameters: Vp = 120 V; Vs = 60 V; Is = 5…

A: Given: A transformer has Vp=120 VVs=60 VIs=5 A

Q: has a fixed AND ..... array(constructed as a decoder) and programmable connections for .the output…

A:

Q: If we give a synchronous motor's stator only one volt of power to get it started, what will happen…

A: The Principle of operation of a synchronous motor is based on the change of alternating flux which…

Q: The transfer function of a plant is: G,(s) = sta where a and b are arbitrary constants and a,b > 0.…

A:

Q: There are two charges Q, = 5 x 10-9 C located at (2, 0, 4) and Q2 = -2 × 109 C located at (-3, 0,…

A:

Q: For the given op-amp circuit, determine: iin/Is, Vout/iin, and Vout/Is

A:

Q: Q2) Non – sinusoidal voltage applied on 102 resistance with consumed power 521.25 watts and the…

A: We need to find out current and effective voltage for given power .

Q: Design and construct a cross-over network with the following specification: 375HZ for low pass, 3750…

A: Given data, Lowe cut off frequency=375Hz Upper cut off frequency=3750Hz

Q: the system describe by y(n)=x(-n+3) is? Yes No static linear time invariant causal stable

A:

Q: A coil that con sists of 450 windings is wound around a bakelite rin g. The mean diameter of the…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: In a certain application, the circuit in Fig. 2.140 must be designed to meet these two criteria: (a)…

A:

Q: An IC that contains large numbers of gates, flip-flops, etc. that can be configured by the user to…

A:

Q: hat is the equivalent transfer function: u(s)+ y(s) G(s) H(s)

A:

Q: = 15260' 2, z, = 202 - 30° n, and z, = 1045 2, are connected to an abc- 3. Three wye-connected load…

A: In this solution the concept related to the two wattmeter method is discussed.

Q: * Many motor controls require control signals a) Voltage O b) Current O c) DC O d) AC O

A: 1. Voltage control : Voltage control in power system is very important for almost all the motor for…

Q: 3. VO R Determine the current (in amps) flowing from node 2 to node 3 for the situation when y3…

A: Given circuit: V=-3 voltsR=3 Ω

Q: are faster in speed because the delay between the input and output is due to the propagation delay…

A:

Q: 1. Three non-inductive resistances, each of 100 Q, are connected in star to a three- phase,…

A: Given,Three non-inductive resistances are connected in star to a three- phase, abc-sequence.andThree…

Q: 1- For a noise channel with inputs =, outputs = m show that H(X) = H(Y), and H(Y/X) =0 %3D

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Fill in the blanks / identification: a) Use voltage division to determine the voltage v, across the…

A:

Q: The current in the 12 n resistor in the circuit in Fig. P3.30 is 1 A, as shown. a) Find vg. b) Find…

A: First of all we have to calculate the current in each branch then we need to find the voltage at…

Q: What is the equivalent transfer function: u(s)* + y(s) G(s) H(s)

A:

Q: has a fixed AND ... array(constructed as a decoder) and programmable connections for .the output OR…

A: Given: Programmable logic device

Q: What is the equivalent transfer function: u(s)* + y(s) G(s) H(s)

A:

Q: Fill in the blanks / identification: (a) Calculate current i in Fig. 2.68 when the switch is in…

A:

Q: . A 3-ph, 3-wire balanced load with a lagging power factor is supplied at 400 V between lines. A…

A: A wattmeter is a device used for measuring power, the unit of power is the watt. The three-phase…

Q: Problem 1: v. A, =? %3D 400 k2 40 kQ v, o R Problem 2: A, = . =? 400 k2 40 k2 60 k2.

A:

Q: 1. Determine the sensitivity [mV/ C] of the measured data for the thermocouple. The output and input…

A: Given: Measured data for a thermocouple

Q: Solved for Fc = Frequency Response and Fr = resonant frequency of the following circruit

A:

Q: Given the circuit, where the rate at which R1 is dissipating electrical energy is 20.0W. When the…

A:

Q: * The output in Moore model depend on both the present state and the input False O True O

A: Given: Moore model

Q: Find lo in the network using the current division rule. Choose the cori 12 mA 32 kn 6 kn 3 kn

A: Given,

Q: In the circuit of Fig. 2.75, calculate Vị and V2. 1 V 2 V + + + 5 V V2 V1 = V V2 = V

A:

Q: 10 Ω 8Ω 4 Ω 1Ω 9 V I. Data A. Series Connection Resistors Resistance voltage Current 1 2 Total Reg =…

A: Series combination of two resistor is given as:Req=R1+R2 Parallel combination of two resistors is…

Q: *in . when input change, it doesn't affect the output Mealy model O Morre model O

A: We need to fill the blank space for the given statement

Q: How can a JK flip-flop be converted to a T flip-flop?     No change is required     Set the…

A:

Q: A 10 KVA, 400 V/200 V single phase transformer with 10% impedance, draws s steady short circuit…

A:

Q: 3. Determine Vo and Sketch output waveform for the clamper network shown. 20 V + C Ge R Vi 6 V= -20…

A: Clamper: It is a circuit which shifts the input waveform with respect to the reference voltage but…

Q: and ab in the circuit of Fig. 2.82. 10 V 32 5Ω a 30 V Vab +. 8 V

A: Circuit diagram is given as,

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.