D1 Vm A Ry 50HZ A. K

Q: Determine the DC currents (B. Ic and le) and de juncion voltages (VBE, VCE and Vca) mA. Ic ma, E mA…

A: In this question,  We need to determine the base current, collector current and emitter current?…

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Phase angles Difference in degree= -45°

Q: 1. A circuit with sinusoidal voltage source used as the input is given in figure 1. R1 470 V1 47mH…

A: To find the magnitude of voltage across the resistor R1

Q: Example 6 The EMF and current waves of a circuit having resistance only are e=170sin2 / 60t and…

A: We are authorized to answer only three subparts at a time since you have not mentioned which part…

Q: 2.2 Determine the period, frequency and average value of the current waveform shown in Figure 2.2.…

A:

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current  And in capacitor current leads voltage. The pahsor diagram…

Q: Vcc RB RC Q1 NPN +88 8 Volts VC

A:

Q: voltage wave is given by v=100 sin 314t. how long does it take this waveform to complete one fourth…

A:

Q: 18. If the rms value of AC current through a 10 k2 resistor is 5 mA, the rms value of voltage drop…

A: 18) If the rms value of AC current through a    10 k ohm resistor is 5 mA, the rms value of voltage…

Q: For the given waveform, the current the voltage by an angle V ot (rad) T/2

A: From the given waveform , we can easily found which one leading or lagging.

Q: -The electric field intensity ? L/A C V/I C V/R C V/L C None of them.

A: In this question we will write about electric field intensity...

Q: Q1: Draw the waveforms at the numbered points in the proper relationship to each other: 23 Di C D D.…

A: Since we only answer one question at a time. we’ll answer the first question only.Please resubmit…

Q: (Square wave) 14 V 10 V 2 3 4 t (ms) 14 1 (ms) -6 V -10 V (b) (a)

A:

Q: sin Cn ) Find T such that cs = if T is large, so that sin (nn/T) = nn/T 150 p) Determine the energy…

A:

Q: primary lines exist in electrical post, wht is the range of voltage passing thru this part of the…

A: The common primary range voltage in the primary line is 2,300,4,160, 12,470, 13,800, 25,000 in…

Q: 1. A circuit with sinusoidal voltage source used as the input is given in figure 1. R1 470 V1 VOFF =…

A:

Q: Given the equation, Ve = 42. 1 V sine, What is the value of Voltage at 151.6° A 42.1 V 84.2 V 59.54…

A: Consider the expression for the voltage is, Vθ=42.1sinθ V Consider the value of the angle is,…

Q: Draw the waveform of voltage and current under the following conditions: A current which lags the…

A: In this question,  We need to Draw the waveform of voltage and current under the following…

Q: Da/Given và 120 sin (wt i+52)v , and is 15 sin (wt +52) mA, whatis R?

A: RMS Value of a signal:  It's that steady state equivalent of a time varying signal which would…

Q: 4. After MOV AL, A0H DAA AL=

A: After the mov operation, AL will carry A0H.

Q: An alternating voltage is given by v1 = 95 sin( 200 Tit -0.3 ) volts. What is the phase angle…

A: Given: V1=95 sin200 πt-0.3Volts V2=95 sin200πt

Q: Problem 3 Sketch the following waveforms: a. 50 sin(wt + 0°) b. 5 sin(wt + 120°) c. 2 cos(wt + 10°)…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 2. 14.11 Determine the rms value of the voltage waveform v(t) 3 3. -3

A:

Q: MNP II Question 9 Write the correct answer If the peak to peak voltage is equal to 20. How much the…

A: In this question , we have to  find out rms value with given data..

Q: If values of any quantity vary with time 't' are plotted to a base of time, then the resulting graph…

A:

Q: A wire carries a current i 3cos314t A. What is the average current over 6 seconds?

A: We are given, I = 3 cos 314t A. We need to find average value of current for 6 seconds.

Q: Q3 Griven mit) = 2 Cos loot t 18 Cos (20017t) Write equatione for Foy (ts & Pen ct), Criven: kp = 2…

A:

Q: Qo: Wave from shown calculate Va.v ,Vr.m.s ? VAI 4 V +(sec) -2V - 10 2.

A: In the given waveform Find the average voltage and rms voltage?

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question,   We need to determine the peak voltage Across the load and average power P?  We…

Q: What is the value of the voltage function at 30 seconds? v(t) = 82 sin (16nt + (21t/4) V Сл v (t) =…

A: Substitute time t =32 in the given voltage equation to get voltage value.

Q: The vertical axis should show the

A: The signals are continuous and discrete time . The signals can also be periodic and aperiodic.…

Q: 6/ calculate the average value of the following voltage waveform v(t) 10 /2 e(rad) 2 -10

A: From given waveform write the expression for voltage expression v(t). now using average value…

Q: PROBLEMA 1. Para el circuito que se muestra, hallar vL(1ms). (voltaje del inductor en 1 milisegundo)…

A:

Q: The unit(s) of inductance is (are) (A) henry (C) Wb/A (B) Vs/ (D) all c

A: "Since you have posted a  multiple question we will solve first question for you. To get remaining…

Q: R = 115 ohms XL = 26 ohms Xc = 51 ohms f = 268 Hz E sine Y m C m

A:

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Answer :- 14.324°

Q: for the circuit shown below If v_in=5 sin2m10t then corner frequency will be ... Hz ‒‒‒‒‒ 1 UF 2k…

A: In this question we will find corner frequency of practical integrator...

Q: x(t) = A cos(wot + 0)

A:

Q: A voltage wave is givenby equation v=50+30 sine volts. Find ther.m.s.value of the wave.

A:

Q: Q3) Calealate inductor and Gupe;itor the energy Then oleulehe stureal in thae elemants. teelel 1. H…

A: From the basics of inductor and capacitor

Q: What is the maximum period obtainable from the following generator? Xn+1 = (aXn) mod 24 What should…

A:

Q: For the Photoflash unit. Vse 9V R15KQ. C-1500 uf. R2 120. The average power dissipated by the lamp…

A: As per guidelines given to us, we can only provide the solution of one question in multiple type of…

Q: What is the value of iL, if vs = 40 cos 400t V in the circuit? Answer must be in polar form (i.e.…

A:

Q: a) frid Vens for This periodić wave form Us(t) 2. b) find the burned power in the load Re 2k=Rm c)…

A:

Q: IV. Sketch the following waveforms with the horizontal axis scaled in degrees: a. v1 = 80 sin(wt -…

A:

Q: A= (l01lolol BE 11111010 and C:ololll00 CLK 8 DYaw the Waveform of: ) A+B+C i) ABC ) A田B

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.