Describe an inductor and the how an inductor stores energy

Q: How to convert between transfer function and state-space models

A: Transfer functions and state space models- Transfer functions and state space models are mathematica...

Q: Find Vrms (gen) if R1 = 473 ohms, R2 = 15 ohms and L3 = 5.9 mH.

A:

Q: 2kΩ I 0.3V 0.004Vo 251 40kN 10kΩ Vo Figure 2 + +

A:

Q: 4. The capacitance of C1 is 2F, the capacitance of C2 is 2F, the capacitance of C3 is 1F, and the re...

A: We need to find out charge and voltage across capacitor in given circuit

Q: 3. C3 and C4 are connected in parallel with each other. And together, they are connected in series w...

A:

Q: TITLE OF 3MINSVIDEO ON YT: Automatic on off light switch with phototransistor   Please check scre...

A: Automatic Light Control - Automatic  Lighting Control ideally is to control the lights even when one...

Q: 9. A sif X(1) = Am COS(2 Jm1) a si Ac (2Tfc1) iñn a double-sideband transmitted-carrier (DSBTC) syst...

A: We need to find out the power for given amplitude modulated signal

Q: Find the vector component of F = 10a, - 6a, + 5a, that is perpendicular to G = 0.1a, + 0.2a, + 0.3a,...

A: Find the vector component of F that is perpendicular to G but lies on the same plane as two vectors.

Q: Solve the voltage across 10-ohm resistor.

A: This question comes under electrical circuit theory . It is based on the concept of nodal analysis ....

Q: 1. Determine the Vo for the circuits below: Si Ge 2 k2 +20 V 2 kQ (a) Si +10 V 1.2 k2 4.7 k2 (b)

A:

Q: 1. 15 lighting outlets 2.1 kitchen range 3. 12 lighting outlets 4. 1 water heater at 1500 watts 5. 1...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: j4 2 10. Obtain the equivalent impedance of the circuit in Fig. 1.38. ell Zeg Lea j2 2 -j2 2 Fig. 1....

A: In this question,  We need to determine the equivalent impedance of the circuit as shown in the circ...

Q: Determine ?1to ?5.

A: The given circuit is shown below:

Q: Five resistors are connected in parallel. Compute for the (a) total resistance, (b) current flowing ...

A: Given, Five resistors are connected in parallel R1=10 Ω;R2=20 Ω;R3=30 Ω;R4=40 Ω;R5=50 Ω; V= 220 V  

Q: Example(6): Determine the values of currents In ,2 &I3. RI R2 I1 V1 =10V+ V2-20V R3 0n 13

A: We need to find current for given circuit

Q: Design a CS amplifier using E-MOSFET with voltage gain 20dB , VGS=5V , VDD=12V ( gm=4500μS ).

A: CS amplifiers- Common source amplifiers are not used on their own in electronic circuits nowadays, m...

Q: Photo resistor to be used? A-as sensor B-as resistor C-as actuator D-None of these

A: Given: Photo resistor

Q: Differentiate between the cable tester with multi mete

A: Following are the difference between cable tester and multi meter-  

Q: 4. A transmission line has a characteristic impedance of Z = 21.05260.4° with propagation constant o...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: A resistor R is connected in parallel with a 10 ohm inductive reactance. The combina then connected ...

A: Solve the problem

Q: IR R 220 2 Vz = 20 V IZM = 60 mA RL21.2 k2 V,

A: The minimum value of the Vi will be corresponding to the minimum voltage required to turn ON the Zen...

Q: What will be truth table

A: There are two variables used in the given boolean function so we will have only 4 combinations of in...

Q: 1)-What happens if different voltage and different current ratings of solar panels are connected tog...

A: (i) Panels of the different voltage and different current ratings are connected in series.  The out...

Q: assume an operational amplifier is working on inverting amplifier in which it takes input resistance...

A: Given

Q: A capacitor branch having a ratio of Xc to R of 5 is paralleled with an impedance consisting of a 4 ...

A: In this question one parallel circuit is given which includes RL and RC branch... Overall power fact...

Q: Define Attenuation and find the attenuation at the destination if the power at the destination is 10...

A:

Q: 2. Determine the admittance Y for the circuit in Fig. 1.30.

A:

Q: Using Thevenin's Theorem, Find Thevenin equivalent circult at terminals a-b.( Rth and Vth)* R3=1.5 k...

A:

Q: y[(t) = {3e-2t, t0           {0,      otherwise The function above defines a voltage signal y(t) m...

A:

Q: Assume that a 600 2, 12 µV rms voltage source

A:

Q: If R = 11 Q, what is the value of the current I in amperes? Your answer must be accurate to two deci...

A:

Q: Find the Thevenin equivalent resistance for the network below. 12 3v1 1.52 RTH (1) 1 Q (2) 1.6 2 (3)...

A:

Q: Design, implement and test a digital logic circuit that accepts inputs A, B and C from plane A, B an...

A: The logic circuit can be designed by forming the truth table based on the given condition and then b...

Q: Please provide a full solution, draw an illustration, and label each resistor. A circuit consisting...

A: The solution is given below 

Q: The input power to a three-phase motor was measured by two wattmeter method. The readings were 10.4 ...

A:

Q: In the given circuit, find the equivalent resistance of: 1.) Equavalent resistance across b and e (...

A:

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 12 kW...

A: Two wattmeter method is used for the measurement of three phase power having unbalanced load.

Q: Microwave level sensor

A:

Q: See Figure 10.4. Find the total charge stored on the capacitors in this circuit. 25V 10μF Τ5μF Figur...

A: Given circuit,

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting and Non-conducting wires:

Q: Explain Transducer classification adding EXAMPLE to each category. Note: Please do not handwritten.

A: Classification of Transducers The Transducers Can be classified based On a) The principle of Transdu...

Q: An electronic device has a resistance of 30 Ohms and a current of 20,500 mA. What is the voltage acr...

A: The resistance of the device is given as, R=30Ω And, the current through the device is, I=20,500 mAI...

Q: B3

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: Compute the charge stored on a 4-pF capacitor with a 24V across it.

A: The charge stored in a capacitor, Q in coulomb as the product of the capacitance C (in Farads) of th...

Q: A causal LTI system with impulse response h(t) has following properties T4. 1 for all t when input i...

A: SOLUTION:- When input is eS0t,                then ouput  y(t) =eS0t.H(s0)Given,               x(t) ...

Q: Three vectors A, B and C lie on the 3D RCS. The scalar product of A and B is equal to -2. The scalar...

A:

Q: In the 555 timer timing diagram shown below, the capacitor charge voltage controls the of the pin 3 ...

A: Answer: period(Time period) Time period(T)= t1 (high) + t2(low) So second option alone is wrong and ...

Q: A current of 1A passes through a 0.12 kQ resistor. What is the voltage across the system in Volts? Y...

A:

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A: Given, A series RLC resonance circuit has Capacitance, C=22 μF Resistance, R=1200 Ω Inductance, L=34...

Q: A 3-phase, 50 Hz, 35 km long overhead line supplies 500 kW at 22 kV, 0.8 p.f. lagging. The line resi...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.