Design a suitable 8 section starter for a 14.92 kW, 250 volt, 1000 rpm d.c. shunt motor from the following data: Maximum starting torque= full load torque  Armature circuit resistance = 0.4 ohm Full load efficiency = 0.85

Q: Q3- Calculate the power in the 602 resistor using Norton's theorem. 24Ω 12V www 652 1A

A: Given: Circuit

Q: Three capacitors 10 μµF, 20 µF, 30 uF are connected in series across 150V (sinusoidal). Then…

A: Given, Three capacitors are connected in series,  C1=10 μFC2=20 μFC3=30 μF Supply voltage, Vs=150 V

Q: Use Nodal Analysis to determine each of the parameters for the provided cicat. VeM A R,(100) R;(200)…

A: Given: Circuit diagram

Q: 3. Calculate the mesh current 11 for the circuit below. *

A: The required mesh current can be calculated by using the mesh analysis of the given circuit. The…

Q: A 3-6, 10 MVA, 11 kV, Y connected alternator is protected by Merz-price protection system. If the CT…

A: Given a 3-phase, 10 MVA, 11 kV, Y connected alternator is protected by Merz-price protection system.…

Q: 70. ★★ The RL circuit in Figure 25-73 consists of an ideal battery; a resistor, R; an inductor, L;…

A:

Q: Q5 T(s) = 62.5(x + 2.5) (s² +65 +25)(s+ 6.25) a) What are poles and zeros of the transfer function…

A: For the given transfer function answer the following Questions : Ts=62.5s+2.5s2+6s+25s+6.25 or we…

Q: Find the applied voltage on a forward biased diode if the current is 1mA and reverse saturation…

A:

Q: The circuit shown below is an idealized forward converter. Assuming an input voltage Va=40V, duty…

A: It is given that: Po=50WR=50 ΩVd=Vin=40 Vd=0.5

Q: FACULTY OF SCIENCES DEPARTMENT OF PHYSICS QUESTION NO. 2: MANDATORY/DOPTIONAL / BONUS In the figure,…

A: Given- C =0.4 uF ε= 20 V R1 = 10 k ohm R2= 15 k ohm

Q: = TNL 2. The transistor parameters are VND VIN 0.6 V, 100μA/V², 2 = 0, and (W/L) = 1. Let V=3.3 V.…

A:

Q: = 4. ★★ Two coaxial air-filled solenoids, A and B, of equal length (€ = 20.0 cm) and radii R₁ = 2.50…

A:

Q: 1. Determine lx in the circuit below. 600 V ΣΩ /100 5 Ω /30 22 ΠΩΣ 18 Ω 20 Ω

A:

Q: The band of interest for a DSP system extends from 0 to 2 KHz. The achievable…

A: PART(a) GIVEN=>   SQNR = 86 db             Signal frequency (fm =…

Q: Calculate the seg based on the following information. Weight of carrier = 1.57 kg/m. Diameter of…

A:

Q: If the peak voltage of a 60-Hz AC generator is 250 V, what is the instantaneous voltage after the…

A: Given: Frequency, f=60Hz Voltage, Vm=250V Rotation, ϕ=105°

Q: In a certain series resonant circuit V₁ = 100 V, V₁ = 100 V and VR = 35 V. The source voltage is (a)…

A: Given: In a certain series resonant circuit. Voltage across capacitor, VC=100 V Voltage across…

Q: 20 V. ΦΩ ΦΩ ΤΩ wwwa Μ ΦΩ -0 b Laing Tharanin's Theorem the equivalent voltage at terminals (ab)…

A: Given circuit:

Q: 15 A current? What is the radiation resistance of an antenna which radiates 5 kW when it draw

A: Given information: The power radiated by the antenna is P=5 kW.  The current drawn by the antenna is…

Q: Use superposition theorem to find the value of VÀ in the following circuit due 3A

A: Given circuit diagram,

Q: Consider unity feedback system with forward path transfer function 25/s(s+ 5); what are the values…

A: Given: Forward path transfer function, Gs=25ss+5 Unity feedback, Hs=1

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: A network consisting ac source with resistances, inductance and capacitance as well. We have to find…

Q: Q.) The circuit shown below is an idealized forward converter. Assuming an input voltage Va=40V,…

A: By utilizing a transformer, the forward converter is a DC to DC converter raises or decreases the…

Q: Calculate the radiation resistance of current element whose overall length is λ/50.

A:

Q: Find the decimal equivalent of the binary number (1011.011)2

A: Binary numbers are those numbers which have 2 in their base and decimal numbers are those numbers…

Q: D7.36 Design the circuit of Fig. 7.54 to obtain a de emitter current of 1 mA, maximum gain, and a ±2…

A: Given: VCC=10 VVC=±2VVCE=2.3 Vβ=100 V Find: Design the circuit to obtain an emitter current of 1 mA,…

Q: Problem: A parallel circuit comprises of a resistor of 2002 in series with an inductive reactance…

A: Given that: R1= 20 ohm, R2= 30 ohm XL=j15 ohm, XC=-j20 ohm, Total current IT=10∠-30o A Fine current…

Q: When giving presentations, many people use a laser pointer to direct the attention of the audience…

A: Given,Power= 3 mWSpot diameter= 2mmFrom this,Spot area will be πd22A=π×222   =π mm2For a perfectly…

Q: - Figure 19-3 25 VZ0° R1 W 100 Ω XL = 750 RL 2) Given Figure 19-3, find the Thevenin voltage (Vth)…

A:

Q: Problem: A coil having a resistance of 7 and an inductance of 31.8mH is connected to 230V, 50Hz…

A:

Q: A digital data will be transmitted over an analog transmission medium that has a maximum bandwidth…

A: Channel Bandwidth, B=1.4 MHz, SNR=26.2 dB we have to find out a) the maximum data speed of the…

Q: Calculate the reverse saturation current of a diode if the current at 0.2V forward bias is 0.1mA at…

A:

Q: Calculate the reverse saturation current of a diode if the current at 0.2V forward bias is 0.1mA at…

A: The question is about reverse saturation current of diode.

Q: Determine the voltages 1 and 2 of the network in Fig. by nodal analysis. ΤΩ 1 2 3. ΤΑ Μ ΜΜ 2Ω O Μ ΖΩ…

A: Solution !!

Q: D1 a) A capacitor of 1000 µF is supplied with a voltage of 10V. The voltage is discharged through 50…

A: Given data, Capacitance, C=1000 μF Voltage, V0=10 V Resistance, R=50 kΩ

Q: Use nodal analysis to determine the voltage across 5 ohm resistance and the current in the 12 V…

A: Solution !!

Q: 15 A current? What is the radiation resistance of an antenna which radiates 5 kW when it draw

A:

Q: An (open) electric circuit consists of an inductor, a resistor, and a capacitor. There is an initial…

A: Given that: Initial charge q(0)=2 C I=3 A E(t)=20 cos(t) The voltage drop across the resistor is 4…

Q: . An electrical engineer is analyzing an electroplating run and wants to calculate the charge that…

A: It is given that: V=0.30 VkWh=10.3 kWhI=3 A

Q: Use any technique you prefer to prove the logic rule: A.(A + B) = A

A: Given, The logic expression is AA+B≡A

Q: A load of 500 kVA operates on 1100 V, 50 Hz mains with power factor of 0.6 lagging. It is required…

A: We have an load with, KVA rating = 500 KVA Vs = 1100 V Frequency (f) = 50 Hz Power factor (cosϕ1) =…

Q: Calculate the dissipation in power across 2002 resistor for the FM signal v(t)= 20 cos(6600t+…

A: The expression of the FM signal is vt=20cos6600t+10sin2100t. The power dissipated via a 20-ohm…

Q: A moving coil instrument with a coil resistance of 25 ohm has a full scale deflection current of 2…

A: We have an moving coil instrument with, Coil resistance (r) = 25 Ω Full scale deflection current (i)…

Q: The voltage across a 1.1-kW toaster that produces a current of 10 A is: (a) 11 kV (b) 1100 V (c) 110…

A: Given, The power rating of toaster, P=1.1 kW Current rating, I=10 A

Q: An electric lamp of 100 2. a toaster of resistance 50 2, and a water filter of resistance 500 2 are…

A: Solution !!

Q: Perform a 4-bit Boolean logic circuit. An LED should be activated only when two signals are high,…

A: Given that: LED will be activated when only two input signals are high. A table is shown. A Boolean…

Q: The current passing through a circuit is 7.2A and the power at the terminals is 27 watts. Existence…

A: Given data, Current through the circuit I=7.2 A Power at the terminals, P=27 W

Q: Infinite uniform line charges of 5 nC/m lie along the (positive and negative) x and y axes in free…

A: You have asked multiple questions, but in part, b) the data is insufficient so we will solve the…

Q: 4. A single-loop negative feedback system has the loop transfer equation: L(s) = Ge(s)G(s) = K(s +…

A: GIVEN:                  L(s)=Gc(s)G(s)        =K(s+2)2(s(s2+1)(s+8)) FIND:             (1) sketch…

Q: A charge q1= -2 microC is placed at the origin. Another charge q2= +4 microC is placed at x=0.35 m.…

A: Given parameters: Charge at origin, q1 = -2 uC Charge at x = 0.35 m, q2 = +4 uC Observation point…

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.