Design a three-phase system such that the phase current in the generator, lines and charging phase is the same. The phase voltage in the generator must be 1000 [V] with ACB sequence. The connected load must be such that the phase current in each load is 10 [A] and its power factor is 0.97 “lagging”.

Design a three-phase system such that the phase current in the generator, lines and charging phase is the same. The phase voltage in the generator must be 1000 [V] with ACB sequence. The connected load must be such that the phase current in each load is 10 [A] and its power factor is 0.97 “lagging”.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.23P: Figure 3.32 shows the oneline diagram of a three-phase power system. By selecting a common base of...

See similar textbooks

Similar questions

Two balanced Y-connected loads, one drawing 10 kW at 0.8 power factor lagging and the other IS kW at 0.9 power factor leading, are connected in parallel and supplied by a balanced three-phase Y-connected, 480-V source. (a) Determine the source current. (b) If the load neutrals are connected to the source neutral by a zero-ohm neutral wire through an ammeter, what will the ammeter read?
The total instantaneous power absorbed by a three-phase motor (under balanced steady-state conditions) as well as a balanced three-phase impedance load is (a) A constant (b) A function of time
In a balanced system, the phasor sum of the line-to-line voltages and the phasor sum of the line-to-neutral voltages are always equal to zero. (a) False (b) True
Figure 3.32 shows the oneline diagram of a three-phase power system. By selecting a common base of 100 MVA and 22 kV on the generator side, draw an impedance diagram showing all impedances including the load impedance in per-unit. The data are given a follows: G:90MVA22kVx=0.18perunitT1:50MVA22/220kVx=0.10perunitT2:40MVA220/11kVx=0.06perunitT3:40MVA22/110kVx=0.064perunitT4:40MVA110/11kVx=0.08perunitM:66.5MVA10.45kVx=0.185perunit Lines I and 2 have series reactances of 48.4 and 65.43, respectively. At bus 4, the three-phase load absorbs 57 MVA at 10.45 kV and 0.6 power factor lagging.
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
The total instantaneous power delivered by a three-phase generator under balanced operating conditions is (a) A function of time (b) A constant
There is a three-phase system such that the phase current in the generator, lines and charging phase is the same. The phase voltage in the generator must be 1000 [V] with clockwise sequence. The connected load must be such that the phase current in each load is 10 [A] and its power factor is 0.97 “lagging”. a) Determine phase currents in the generator, lines and phase in the load
n 3-phase alternator, the change of terminal voltage from no load to full load is more in case of leading power factor as compared to unity power factor. Select one: True False
A three-phase, wye connected alternator is rated at 720 kVA, 2400 V, 60 Hz. At the rated load, determine: the output, in kilowatts, at 80% lagging power factor. the full-load line current. the full-load current rating of each of the three windings. the voltage across each winding
Calculate the line and phase current drawn by the load and the power factor.
In the circuit shown below, the 3-phase induction motor is connected across a 3-phase, 440 V source. Assuming a phase sequence ,of a-b-c determine: a) Line currents. b) the readings of wattmeter W1 and W2 c) the impedance equivalent of the load in delta that can replace the induction motor
Qa1. The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two advantages of three phase system over a single phase system. Also write mathematical relationship between the phase voltage and the ine voltage, and the phase current and the line current for both delia (D) and wye (Y) connections. Please answer in typing format please..