Answered: Design the following function F using:…

Design the following function F using: АВ 00 01 11 CD 00 1 01 11 10 1 1 1.4:16 decoder block 2.2:4 decoder block 3. 8:1 multiplexer block 4. 4:1 multiplexer block 10 1.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Draw a 16-to-1 line multiplexer tree which uses only 2-to-1 line multiplexers. Number all of the…

A: Total MUX required to build a 16-to-1 MUX using only 2-to-1 MUX isMUX required to build a 16-to-1…

Q: Design the following function F using: AB CD 00 01 11 10 00 1 01 1 11 1 10 1 1 1.4:16 decoder block…

Q: Find the max clock frequency allowed for a 10 FF counter. Assume 22ns max propagation delay for each…

A: Since the propagation delay for each FLIP FLOP is 22ns. Since there are 10 such flip flops.

Q: 3. Determine the implementation complexity of Time - Space (TS) switch where the number of Time…

A: Here, we have to determine the implementation complexity of Time -Space (TS) switch, where one stage…

Q: Apply F( A, B, C,D)=E(0,3, 5, 6, 9, 10, 12,15) using two Multiplexers of 3 selectors (B , C, D)

A: I have solved it.

Q: - Determine the number of errors that can be detected and corrected for data values with a Hamming…

A: We need to find out number of error can detected and corrected .

Q: Number of bits transmitted per sample for delta modulator is A. 1 B. 5 C. 4

A: Delta modulator is a modified version of pulse code modulation.

Q: = Em(0,3,5,8,10,12,13) + Ed (6,7,9,15) ent the above function using a 2-1 multiplexer. Connect…

A: The solution is given below

Q: . What type of receiver detects the phase shift in the received signal? A. Binary phase-shift keying…

A: This problem is based on the phase shift in the received singal. What type of receiver detects the…

Q: In a binary data transmission using duobinary pulses, sample values were read as follows: 120-2-200…

Q: Show the starting and ending address of each segment located by the following segment register…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What is a decoder. Giving example of a decoder, comment on the relation between the number of…

Q: In digital modulation techniques, the symbol error probability is always equal to the bit error…

A: BPSK, DPSK, OOK and non coherent FSK have same bit and symbol error probability. It means in digital…

Q: Which of the following frequencies is associated with the 565 frequency-shift keyed decoder? 1270 Hz…

A: methods used to encode binary data in a sinusoidal waveform is called frequency-shift keying

Q: Consider the following message signal and modulated signal. Is it a: 14 12 10 m(t) Xc(t) a. SSB…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: 3 x 8 decoder/demultiplexer circuit

A: AND gate- When output is high only if both the inputs are high, otherwise it is low then this type…

Q: FSK is considered an analog multiplexing technique. Select one: O True False

A: So we have to answer whether fsk is analog multiplexing or not.

Q: A digital communication link consists of nine regenerative repeaters along with a receiver. Signal…

A: Given: A digital communication link consists of nine regenerative repeaters along with a receiver.…

Q: equired at the modem output for each of the following schemes. 75% roll-off shaping is sed in all…

Q: If you have a system with a quantizer of 5V and 3 bits resolution, show the following: 1. The number…

A: Given: A system with a quantizer of 5V and 3 bits resolution. To find: 1. The number of levels. 2.…

Q: 3. Given the following system where the delay block represents the delay introduced by the…

A: As per Bartleby policy, we cannot provide handwritten solutions but I can provide you a typed…

Q: Q3/ Difference between decoder & encoder ( only 3 difference)

A: ENCODER 1 Encoder c converts the applied information signal into a coded digital bit stream. DECODER…

Q: Exxplain the PSK modulation technique and compare the BSK, DE-BSK, QPSK, DE-QPSK.

A: PSK is known as the phase shifting keying and it is a digital modulation technique where the phase…

Q: Design a 2 to 4 Line Decoder (with Enable input ) Active Low output.

A: 2 to 4 loine decoder has two input and 4 output lines

Q: 03 Consider Sending a base bnnd audio signals with bantwidth d 2ek HZby Pulse Code modulation , The…

A: The solution is given below

Q: In the figure shown below, Vmax is measured as 10.2 V and Vmin measured as 2.8 V. Va 1. Draw the…

Q: What I/0 device number will activate this decode circuit? Remember that 1/0 device numbers are given…

A: Here Address line (A7-A0) connected to 8 input NAND gate that function as decoder.

Q: The DS-1 system multiplexes 24 voice channels into one TDM frame and each frame contains 8 bit per…

Q: For a delta modulator system, the following number of bits are getting transmitted per sample: 1. 4…

A: The sampling rate of a signal should be higher than the Nyquist rate, to achieve better sampling. If…

Q: The fan connector will have three or four holes. A three-hole connector can fit onto a 4-pin header…

A: The analog pulse modulation techniques are classified into three types, which are mentioned as…

Q: ?How many 1*2 Decoders are required to design 4*16 Decoder 10 5 15 O

Q: The following switching functions are to be implemented using a decoder, so the equipment's required…

Q: If the channel is of low pass nature the transmitted signal may be: a) Normal AM, b) FM, e) baseband…

A: 3)AM , FM etc are bandpass analog modulation schemes. Channels of low pass nature allows only base…

Q: 1.5 1 0.5 |-0.5 -1 |-1.5 1 2 3 4 5 6. 7 LO LO

Q: A major advantage of PRTS is that they are very linear. A disadvantage is that they have poor…

A: In this question we need to verify the given statement is true or false

Q: In ASK, when modulating signal is binary 1, the ASK output is a. same as the carrier signal b.…

Q: Write the necessary instruction to change or swap 3 byte stored at DS:0A60 with DS:0A80

Q: Voice information with a frequency range of 0.3 - 4 kHz is sampled according to Nyquist requirements…

A: It is given that: fm=0.3~4 kHzL=256 levelsn=log2256=8 bitsd=0.5M=16

Q: Briefly differentiate between phase encoding and frequency encoding.

A: The differences between the phase encoding and frequency encoding are listed in the table shown…

Q: 1. For 8-bit binary numbers: a. Compute 125-75 using 2's complement to represent negative numbers.…

Q: In DSB-SC-AM modulation the information carried by carrier is zero more than information carried by…

A: So We have to solve DSB SC AM and third harmonic question.

Q: Write an ALP to transfer the message “CORONA” serially at 2400 baud rate, 8-bit data, 1- stop bit.…

A: TO write an alp program

Q: The term BER refers to Select one: O Bit Error Rate O Binary Error Rate Baud Error rate Bit…

A: A) Bit error rate. The term BER refers to Bit error rate.

Q: Ao A₁ A₂ Address decoder 0 1 2 3 4 5 6 7 0₂ АННННН 0₂ {KKKKK. 00

A: Given data: An address decoder diagram is given in which the black box of the output represents 0…

Q: Example 2: Use Multiplexers to implement of Full adder. Table 6.4 A B SUM CARRY 1 1 1 1 1 1 1 1 1 1…

Q: 10) What could be the output the following decoder circuit if A-1,B-0 and E-1? Do D D.

Q: Given that 70 elements can be encoded using three digits of a numbering system with radixr, which of…

A: No. of different 3 digit numbers that can be formed in base r is r3 . Given , 70 numbers needs to…

Q: Show how an asynchronous counter can be implemented having a straight binary sequence from 11111…

Q: BCD TO 7- Segment decoder i/p for number (4) are A.0100 B.0111 C.1001

A: BCD to 7-segment decoder :- The 7-segment display 4 if, b = c = f = g = 1 and rest of the bits are…

Question

Design the following function F using:
АВ
00
01
11
10
CD
00
1
1
01
11
10
1
1
1.4:16 decoder block
2. 2:4 decoder block
3. 8:1 multiplexer block
4.4:1 multiplexer block
(P.S. All empty cells are do not care)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The following page of the data sheet, contains 74138 function table. Study the function table. Given that H=1 and L=0, describe the outputs of the decoder in terms of A, B and C. Fill Table 1. (Use 0 and 1 for the inputs).
Design four way traffic lgiht signal using gray code and using logic vehicle on side long timer and short timer also by using d flip flop
Give the Answers of following questions, 1: without reducing implement the following Boolean expression using basic gatesY Y= (A' B)'+A+BC 2: Reduce the following Boolean expression using Boolean algebra. Y = (A+BC)' (AB'+ (ABC)') 3: Explain the construction and working of the Depletion MOSFET, with characteristics curve.
Suppose, 5 signals are coming through 5 sources and will be multiplexed by time division multiplexing technique. The data rates of the 5 sources are 30kbps, 60kbps, 60kbps, 30kbps, Nkbps. Which of the data rate managements will work! here?
Q- To transmit the data 1011000 to his friend using hamming code technique. If during transmission, the 5th bit is flipped. Explain the process of recovering origin data from the received data.
6. Calculate the check bits (find the codeword) for the bit-pattern (100101011), usingHamming code error correction method.
Convert the Moore state diagram of the following figure into an equivalent ASM chart. Check only one variable in each decision box. Minimize the number of decision boxes in each ASM block.
A bit word 1010 is transmitted . construct the even party 7-bit hamming code for this data?If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?
(-100)10 - (+120)10 = (?)2 numbers are 8 bits, and subtraction is done by using the methods of complementing 15 and 16. Realize, specify the state of the flags at the end of the extraction process (B = ?, OF =?).
Find the answers to the following questions? a) Find the excess-3 code of (152) Base 10.b) Convert binary to grey code 0101011.
Construct the given function on a suitable size Decoder.F= A’B+AB’C+AD’+BCD