Determine C/R, for the system given H3 R2 R G2 G, H

Q: An AC bridge is balanced at 20KHZ with the following components in each arm: Arm AB=10OK2, Arm 100HF…

A:

Q: Obtain the voltage Vin the network of Fig. 9- 28, using the mesh current method. -j2 N 5/30° V 10/0°…

A:

Q: what is the cutting line of a series clipper (biased and unbiased)?

A:

Q: Y

A:

Q: 2. Determine C/R, for the system given R2 R G2 Gs H H

A: The solution is given below

Q: write only the option  The electrical power is delivered to the users through five distribution…

A: Some statements are given. We need to choose the correct option regarding to each of the statements…

Q: Calculate the average output voltage based on a 9Vp (use full-wave rectifier)

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC  power that…

Q: circuit shown in Fig. P6.42, current source VBE At 25°C with ß = 100, what currents flow in R| and…

A:

Q: 100 200 s00 1000 What is the ectual reacing? 30 20 50 10 s00 200 100 2 10 50 2k1k 21 20 100 30 150…

A: From the diagram, clearly we can say that the pointer is exactly middle of 1 and 2 in the ohms…

Q: Find V2 (volt) unit if E1=9V, E2=-5.4V, R1=4.6kN, and R2=1.9kQ. (Answer should roundoff to 2 decimal…

A: Given , We have a circuit with diode. Please find the below attachments for the clear explanation.

Q: Electronics circuits   Pls show the solution step by step. Thank you.   In a bridge-type…

A: Capacitor: This is used to store the energy in form of an electric field and its unit is farad.

Q: EE-310 Signals and Systems - Homework 4 d. Can this system be realized? Explain. e. Find the system…

A: The solution is given below

Q: The current in a given conductor is represented by the geometric sum of two currents whose equation…

A: This question comes under electrical network theory . It is based on the concept of RMS value of the…

Q: O 24ax + 78 ay + 20 az

A:

Q: A circuit composed of a 24-V battery and four resistors connected in a series connection, whose…

A:

Q: Carrier wave of frequency f= 1MHz with pack voltage of 20V used to modulated a signal of frequency…

A:

Q: Repeat problem 50 with a load resistor of 1.2 k.

A: The required parameters can be calculated by using the DC and AC analysis of the Darlington…

Q: 27. Determine the capacitance required to establish a capaci- tive reactance that will match that of…

A: This problem comes under electrical network theory . It is based on the concept of calculation of…

Q: A resistor is connected to a 6 volt battery. If the ammeter in the circuit reads 2A, what is the…

A:

Q: Four resistances 800, 500, 25 0 and Rare connected in parallel. The current through 250 resistance…

A: The solution is given below

Q: 8.Find the total current for the given network. 10 IT 25V- 12.5 310 312.5 312.5

A: We will find out total current for given circuit

Q: What is the approximate value of the total resistance. R2 RS R11 4 kOhm 4 kOhm 5 kOhm R128 kOhm R310…

A: In this question,  We need to calculate the equivalent resistance.  We know if two resistances R1…

Q: Calculate the resistance of 87 m length of a wire having a uniform cross-sectional area of 0.25 mm²…

A: This question belongs to electrical network theory . It is based on the concept of formula of…

Q: (a) Draw a QPSK waveform for 11010010 (b) Draw a Multilevel FSK (M = 4) for the same bitstream as in…

A: 4- Level QPSK and FSK for the data 11010010:

Q: d. Can this system be realized? Explain. e. Find the system output for an input x(t) = cos(t). f.…

A:

Q: solution. 1. Three resistors, 250, 45n, and 750, are connected in series, and a 0.51-A current…

A: We need to find resistance , power for given circuit

Q: 7. The bias voltage is set to +4.3 V. The output of the biased limiter shown will be clipped a.…

A:

Q: Consider signal x(n)={4,4,9,4,4} starting from n=0 with discrete-time Fourier transform. Compute the…

A:

Q: 7. The bias voltage is set to +4.3 V. The output of the biased limiter shown will be clipped a.…

A:

Q: Match the signal and its FT ve-at u(t) ve 6(t) v 1 sgn(t)

A:

Q: Problem 02: A resistor which conductance of G = 50 mS is connected in parallel with an inductor…

A:

Q: find the power dissepated in RL by using voltage division and current division for RL=10 ohm Circuit…

A:

Q: Calculate the current across the 20 ohm resistor. 20 otm www 30 ohm 200V

A:

Q: If the frequency were halved, what would be the new impedance of the series RLC circuit?   Given:…

A:

Q: If A = ax + 3az and B = 5ax +2ay - 6az. Find the Dot product of vector A and B

A: This question belongs to basic electrical . It is based on the concept of basic laws of vector…

Q: Given that αdc =0.980, determine the corresponding value of βdc. b. Given βdc =120, determine the…

A:

Q: Q4/ Determine the overall noise factor and noise figure for the cascaded amplifier: A1=3 dB, A2=…

A:

Q: E̲x̲p̲r̲e̲s̲s̲ ̲t̲h̲e̲ ̲f̲u̲n̲c̲t̲i̲o̲n̲ ̲F̲(̲A̲,̲ ̲B̲,̲ ̲C̲,̲ ̲D̲)̲ ̲=̲ ̲D̲(̲A̲’̲ ̲+̲ ̲B̲)̲ ̲+̲…

A:

Q: Please answer with complete solution :)

A:

Q: Find Ip in A (ampere) unit if E=11V, internal resistance Rp=41.4, and R=484N. (Answer should…

A: In this question,  We need to determine the current iD  if  E, RD  and R is given We know I= V/R

Q: 1) Find gm, Zi, Zo, Av. (12mS, 2.2MN, 2.7k, -32.4) + 15V IDSS= 9 mA 2.7k Ω Vp = - 4V VGSQ = -1.5V Vo…

A: We need to find input, output impedance and voltage gain for given circuit

Q: system with 16 bits address bus can access 2^16 memory space. Estimate the size of each memory IC…

A: In this question we will find size of memory....

Q: Z1 = 55+ j902, I, = 25230°A, R2 Let V, = 302- 20°V, %3D = 902, R3 = 852, X2 = -402, N1 = 3, and N2 =…

A: The given circuit diagram is shown below. Given values of parameters are, Is=25<30° A.…

Q: A given periodical signal has O Exponenti Fourier Series O Trigonometric Fourier Series O All of…

A: Answer: ALL OF THEM  Third option.

Q: What is meant by a 4-wire 3-∅ system? What advantage does it possess

A: In this question we will write about 3 phase 4 wire system....

Q: wo electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

A: It is given that: IL=23.3 AIA=15 A

Q: D2 ? The circuit shown above is a Use the same circuit in question 2, the PIV for the circuit shown…

A:

Q: A tap-changing transformer has an effective impedance of 0.01+j 0.1 Ω and serves a load which draws…

A: given Z=0.01 + j 0.1 Ω   load =0.9 MVA, 0.8 lag pf load voltage = 1 kV

Q: 6) Find gm, Zi, Zo, Av (2.73mS, 268N, 2.48kN, 6.77) + 18V 3.3kQ 10 kQ Vi Vo HE Zi, IDSS =8.4 mA 1kO…

A:

Q: 12V You To=3 P= ? re si I= ? P= ?

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.