Determine i in the circuit. 30 N 12Ω 5Ω 20 Ω 12V 25 Ω 60 2 15Ω 10 2

Q: A 3000V, 24-pole, 50HZ, 3-phase, star-connected induction motor has a slip ring rotor of resistance…

A:

Q: An open–wire transmission line is made from two wires, each with a diameter of 2.5 mm, located 16 mm…

A: In this question we will write effect on characteristic impedance of open wire transmission line if…

Q: = 15 V, V = 6 V termine the minimum voltage. -11 V -15 V -21 V 0-9V

A:

Q: So (e-t sinh t) u (t)

A:

Q: What would be the value of ESP after pushing the 32-bit value shown below onto the stack? 000000A5

A: Before PUSH instruction, ESP value is =0001000

Q: se mesh-current analysis to find the branch currents indicated in the network sha elow. I1 820°v j1Q…

A:

Q: A hypothetical isotropic antenna is radiating in free-space. At a distance of 100 m from the…

A:

Q: 3. Solve the given circuit to find the current through the 15 - 52 resistor using Thevenin s I 200…

A: Circuit is given as:

Q: 500-hp synchronous motor is connected to 2300 volts. the motor is to operate at 90% power factor.…

A: We need to find out current for given power

Q: 5. Find the Thévenin and Norton equivalent circuits for the portions of the networks in Figures…

A: Brief description: Any complex circuit can be reduced into simple circuits by the help of circuit…

Q: D1 Vsecondary Vfiltered D2 V1 sine Rload I 120 VAC @ 60 Hz D3 10:1 - D4 Figure 1: Bridge Rectifier…

A: We need to find out capacitor value for given filter voltage

Q: Q7. Assuming identical supplies in the figure below: a. Find li, lh and lz. P12 W 12V b. Find the…

A: We need to find current and power for given circuit

Q: In your own opinion, what do you think is the importance of having this Basic Measurement Theory?…

A: The real world demands the analysis and design of complex systems. It is possible with the clear…

Q: Find I3 if l1=5 mA, I2=7 mA, la=6 mA and Is=8mA. Currerts In Node Is 12 Currents Out I3 I4

A: In this question we will find unknown current I3 using KCL...

Q: A Phase modulator has a carrier signal of ec = 100 cos [2t(735 x 103)t] and phase deviation constant…

A: According to the signal, for the given phase modulation, we need to find a. The effective voltage of…

Q: 12.14 Show that the attenuation due to a waveguide operating below cutoff is a = 2Vµɛ f\/1

A: We need to show that the attenuation due to a waveguide operating below cut-off is : α=2πμεfc1-ffc2

Q: Consider the discrete-time periodic signal x[n] shown below. x[n] 4 4

A: a) fourier series representation-     x(n) = ∑k=0N-1dk ej2πkn/Ndk =1N∑n=0N-1xn e-j2πkn/NHere N =4,dk…

Q: 2.46. Compute the convolution y(t) = x(t) * h(t) of the following pair of signals: 0<t<T 0<t<2T x(t)…

A:

Q: In the given circuit below, determine the current flowing through each resistors using; Kirchhoff's…

A: This question belongs to circuit theory . It is based on the concept of mesh analysis and…

Q: Using KCL, find the unknown currents. 3.5 mA 8 mA $1

A: To find out unknown currents in the diagram given, Given Iout = 8 mA

Q: What is the effect of connecting a 0.1 capacitor across the capacitor of the integrator in the…

A: As we know that we have already an integrator circuit in which a capacitor and resistor is…

Q: In the circuit of figure shown in the next slide, three impedances are 12 – j10 ohms, 10 + j20 ohms,…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Solve for the electric network 120 12V 200 10V ww- 150 find the values of each current across each…

A: We need to find out current through each resistor .

Q: Vm = 20 V, V = 6 V, Determine the minimum output voltage. O -6 V 20 V O -20 V O -14 V

A: Here the properties of diode have been used to answer this question. Here as the cut in voltage of…

Q: 1. When gre the p-n junctions of the n-channel FET blocked?

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: In 3 phase induction motor the greater number of poles give. speed high O Medium O Low

A: In this question we will write induction motor poles and speed relation...

Q: An input æ(t) = u(t) is applied to an LTI system which produces corresponding output y(t) = -2u(t–…

A:

Q: A hypothetical isotropic antenna is radiating in free-space. At a distance of 100 m from the…

A: We need to find out power and power density

Q: 5. For the given op-amp, determine the voltage gains: (a) Av1=Voj/Vi and (b)Av=Vo/Vi. R, VioV R4…

A: We need to find out voltage gain for given circuit

Q: flab,code):1I(0, 3,6,9,1!,19,20,24,25, 26,27,28, 29, 30) ΠD (,.a,12,13)

A:

Q: 14) USE THEVEN INS THEOREM TO FIND RTH, VTH, AND To. 12y (t akn3 Io RTH 2kn 3 Ikn akn Io= -4mA Tho

A: We need to find out thevenin equivalent circuit for given circuit

Q: A shunt generator delivers 195 A at terminal p.m. of 250 V. The armature resistance and shunt field…

A: Since you have posted a question with multiple sub parts , we will solve first three sub parts for…

Q: Solve the current using superposition theorem and solve for the individual currents of each…

A:

Q: Part A - Calculating the output voltage of a difference op-amp circuit Learning Goal: To analyze…

A: Part A  The given circuit is shown below: The voltage at the node b,  Vb=R2R1+R2VxVx=100 mVR2=100…

Q: 4) Express 35dBm in terms of (a) dB and (b) dBV

A:

Q: (iv) Draw the circuit diagram to explain the adjustable-frequency drive for a 3-phase induction…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: 1. Looking at the transmitter, the signal power is 23 mW. The input signal to noise ratio is 40 dB.…

A:

Q: R9 R. Vo1, R R Vo2 V1-2V, V2-3V, V3-4v RI-IK R-4.7ΚΩ, R3-1KΩ, R4-2KΩ, RS-10ΚΩ, R6-2KΩ, R7-2K RS-2…

A:

Q: A separately excited generator, when running at 1000 rpm supplied 200 A at 125 V. what will be load…

A:

Q: 3. A two wire DC ring main distributor ABCDEA is fed at point C with 230V supply. The resistances of…

A: Ring Mains Distributor: It is type of DC distributor. As indicated in figure, the distributor is in…

Q: se Kirchhoff's Laws to solve the branch currents in the network below. I2 I3 :-jin 12 220° A I4 + Vx…

A:

Q: can someone show me step by step how to do this problem and explain the concepts a)find R so that…

A:

Q: If the carrier frequency 1200hz and reference voltage =120 V with modulation Index 0.4 and…

A: We need to find output voltage and output frequency

Q: Vs Vc Vp + Figure 5 16) In Figure 5, if vs is a 6 V peak AC supply (vs = 6 sin(100rt)), what is the…

A: To solve this question we draw a waveform of the given circuit.

Q: A gain of 25dB is equal to

A:

Q: USE NODAL ANALYSIS TO FIND V V2, AND V3 Vi Va 5Kn V3 12MA O 5kn 3 3 4kn 多kn

A:

Q: Using the characteristic curve (please refer to the uploaded characteristic curve) of the NPN…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: 5) The electric flux density is defined as D = 3x²a, + 2xya, + yza,. Determine the SD. ds, where S…

A: We need to find out integration of electric flux for given surface

Q: 7. If line frequency is 60 Hz, what is the output frequency of a bridge rectifier? 8. If the load…

A: As per the guidelines given to us, we can only provide the solution of first question in multiple…

Q: as an external auditor, what are your 7 requirements of auditing that adherence to law and…

A: Everyone in the organization must observe safety standards since they are critical to the health and…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.